Invacare Non-Removable Device 1820 User's Manual
Contents
1. Clamp Tab 7 f Swingaway Front Riggin Upper Hinge Pin Upper NA Hinge Plate A FIGURE Installing Non Removable Device Part No 1076733 3 Non Removable Device Yes you can Invacare Corporation www invacare com USA Canada One Invacare Way 570 Matheson Blvd E Unit 8 Elyria Ohio USA Mississauga Ontario 44036 2125 L4Z 4G4 Canada 800 333 6900 800 668 5324 MADE IN MEXICO Invacare the Medallion Design and Yes you can are registered trademarks of Invacare Corporation 2006 Invacare Corporation Part No 1076733 Rev C 2 8 062. Non Removable Device Gz Assembly Installation and Operating Instructions Model No 1820 Yes you can SAVE THESE INSTRUCTIONS NOTE Check all parts for shipping damage In case of damage DO NOT use Contact Carrier Invacare for further instructions Safety Summary To ensure the safe installation of the non removable device these instructions MUST be followed A WARNING DO NOT install this equipment without first reading and understanding this instruction sheet If you are unable to understand the warnings cautions and instructions contact a healthcare professional dealer or technical personnel if applicable before attempting to install this equipment otherwise injury or damage may occur Invacare products are specifically designed and manufactured for use in conjunction with Invacare accessories Accessories designed by other manufacturers have not been tested by Invacare and are not recommended for use with Invacare products After ANY adjustments repair or service and BEFORE use make sure that all attaching component parts are secure Installing Non Removable Device NOTE For this procedure refer to FIGURE 1 on page 3 1 Install front rigging onto the wheelchair CAUTION It may be necessary to widen the opening of the clamp to prevent scratching the wheelchair frame NOTE There is a right clamp and a left clamp Ensure that the clamp tab is at the bottom of the clamp before insta
3. lling 2 Follow one of the following instructions e Footrest Position the clamp between the two hinge plates of the footrest Detail A e Elevating Legrest Position the clamp above the upper hinge plate of the elevating legrest Detail B For more information regarding Invacare products parts and services please visit www invacare com Part No 1076733 Non Removable Device 3 Follow one of the following instructions e Footrest Position the clamp tab over the lower hinge pin of the footrest Detail A e Elevating Legrest Position the clamp tab over the upper hinge pin of the elevating legrest Detail B 4 Squeeze the clamp together with pliers to secure around front frame tube NOTE The clamp MUST be positioned on the front frame tube to allow the swingaway front rigging to operate properly 5 Install the lug bolt through the clamp from the inside of the wheelchair frame 6 Install the locknut onto the lug bolt Securely tighten 7 Repeat STEPS 1 6 for the opposite side Non Removable Device 2 Part No 1076733 DETAIL A FOOTREST Inside of Wheelchair Front Frame Lug Bolt Frame oe Tube EP Locknut Upper Clamp Tab Lower Hinge Plate Hinge Pin Swingaway 7 Rigging Lower DETAIL B ELEVATING LEGREST Front Frame Inside of Tube Wheelchair Frame Lug Bolt Locknut P Clamp
Download Pdf Manuals
Related Search