Havis-Shields C-3330-800 MW-800 User's Manual
Contents
1. Havis Shields EQUIPMENT CORPORATION INSTALL INSTRUCTIONS C 3330 800 MW 800 FIXED MONITOR MOUNT 1996 2006 FORD CROWN VICTORIA TOOLS REQUIRED Power Drill Drill Bit Set 1 8 through 3 8 3 8 and 1 4 Drive Standard And Metric Socket Sets W 6 Extensions 3 8 and 4 Ratchets HARDWARE QTY DESCRIPTION 8 X 1 12 Black sheet metal screws 10 32 X 2 Machine screws 10 32 Keps nuts 8 X 3 8 Black Torx screws 10 32 x 12 Machine screws 10 Flat washers 10 Star washers KHANNA AO Monitor Mounting Plate Phillips and Standard screwdriver set Wire Cutters Wire Strippers Wire Crimping Tool Standard And Metric Wrench Sets PART GSM33136 GSM33122 GSM30028 CM86508 GSM33118 GSM3 1003 GSM31034 CM93349 800 Rear defroster filler CM93604 Trunk release filler plate CM93603 INSTALLATION A DISASSEMBLE DASHBOARD 1 Remove long dash trim This is trim piece that contains trunk release and rear defroster switch 2 Pull AM FM radio HVAC controls and trunk release button 3 Remove 7mm Hex Head Screws located above speedometer control and below AM FM Radio Note This will ease installation of Monitor Mounting Bracket Do not unplug HVAC controls Lay HVAC controls gently on floor of car B INSTALLING DASH MOUNT SUPPORT BRACKETS 1 Run power and ground for monitor to factory heater control hole 2 Run large black data cable that connects monitor to CPU to fac2. O Box 2099 Warminster PA 18974 800 524 9900 215 957 0720 P 215 957 0729 F www Havis com C 3330 800 INST 9 05
3. tory heater control hole 3 Cut long dash trim panel to 22 3 8 removed in step A 1 Make sure cut is smooth and even and put back into place 4 Remove 4 7mm hex head sheet metal screws from dash panel Mount Monitor Dash Bracket using 6 8 X 1 2 Black sheet metal screws 6 Mount attached clamps using 4 attached 10 32 X 2 1 2 machine screws and 4 10 32 Keps nuts 7 Support the main part of plate w sheet metal screws prior to mounting the clamps Be sure that these screws are flush to dashboard pa Note Pull cables through bottom hole in Monitor dash bracket 8 Position trunk release filler plate CM93603 behind Monitor dash bracket where trunk release hole is located 9 Push trunk release switch through hole Note Make sure trunk release catches filler plate 10 Plug in trunk release wires On 1997 1999 model years attach Rear Defroster filler plate CM93604 w 2 8 X 3 8 Black Torx Screws On year 2000 and newer mount the rear defroster switch and connect wire plug 11 Mount monitor to Monitor Mounting Plate CM93349 800 using Motorola Monitor hardware 6 4mm 0 7x6mm Metric machine screws Set monitor aside for now 12 Plug in power cable and Data cable Mount monitor to dash bracket w 4 10 32 x 2 Machine screws 4 10 flat washers and 4 10 star washers Consolidator Kwik Raze Collins Dynamics Kwik Kit PrisonerTransports K 9 Transports 75 Jacksonville Rd P
Download Pdf Manuals
Related Search