Harman Kardon HKTS1 User's Manual
Contents
1. electric shock do not remove the grounding plug on the power cord or use any plug or extension cord that does not have a grounding plug provided Make certain that the AC outlet is properly grounded Do not use an adapter plug with this product The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance servicing instructions in the literature accompanying the appliance Part No J BLULB 6 96 INCLUDED Five satellites with wall mount brackets for left right center and surrounds Powered subwoofer x Three 20 speaker cables for connection from receiver to subwoofer Three 15 speaker cables for connection from subwoofer to front satellites Two 40 speaker cables for connection from receiver to rear satellites SPEAKER PLACEMENT Satellites Surround Speakers Subwoofer MOUNTING OPTIONS Satellites and Surrounds Wall Mounting Note The HKTS1 satellites feature a 5mm threaded insert on their back Using this lt 9 provision the satellites can be used with Monster Mount Standard2. receiver amplifier and speakers Make sure all wires are connected Make sure none of the speaker wires are frayed cut or punctured If more than one pair of main speakers is being used check the minimum impedance requirements of your receiver amplifier If there is low bass output check the following Make sure the connections to the left and right Speaker Inputs have the correct polarity and Make sure that the subwoofer is plugged into an active electrical outlet Powered subwoofer is plugged in and is either in the On or Auto position If there is no sound from the sur round speakers check the following Check all wires and connections between receiver amplifier and speakers M ake sure all wires are connected Make sure none of the speaker wires are frayed cut or punctured e Review proper operation of your receiver amplifier and its surround sound features Make sure the movie or TV show you are watching is recorded in Dolby surround If it is not check to see if your receiver amplifier has other surround modes you may use 10 SPECIFICATIONS HKTS1 System Sat TS1 Frequency Response Recommended Power 35Hz 20kHz 6dB 10 50 watts Nominal Impedance 8 ohms Sensitivity 86dB 1 watt 1 meter Tweeter One 1 2 dome video shielded Midrange 3 driver video shielded Dimensions H x W x D 4 5 8 x 3 1 8 x 2 7 8 inches 118 x 80 x 73mm Weight 1
3. 1b 46 kg Refinements may be made on occasion to existing products without notice but will always meet or exceed original specifications unless otherwise stated Sub TS1 Amplifier 75 watts RMS Bass 8 woofer bass reflex enclosure Dimensions H x W x D 10 1 2 x 18 1 2 x 10 1 2 inches 267 x 470 x 267mm Weight 29 9 Ibs 13 6 kg har ma n Z ka rdo n H A Harman International Company 250 Crossways Park Drive Woodbury New York 11797 1 800 422 8027 USA only Fax 516 682 3523 1999 Harman Kardon Incorporated Monster Mount is a registered trademark of Monster Cable Products Inc Trademark of Dolby Laboratories Printed 6 99 Part No HKTSLOM
4. HKTS1 OWNER S MANUAL harman kardon Power for the digital revolution Read First Important Safety Precautions 1 Read Instructions All the safety and operating instructions should be read before the product is operated 2 Retain Instructions The safety and operating instructions should be retained for future reference 3 Heed Warnings All warnings on the product and in the operating instructions should be adhered to 4 Follow Instructions All operating and use instructions should be followed 5 Cleaning Unplug this product from the wall outlet before cleaning Do not use liquid cleaners or aerosol cleaners Use a damp cloth for cleaning 6 Attachments Do not use attach ments not recommended by the product manufacturer as they may cause hazards 7 Water and Moisture Do not use this product near water for example near a bathtub wash bowl kitchen sink or laundry tub in a wet base ment near a swimming pool and the like 8 Accessories Do not place this product on an unstable cart stand tri pod bracket or table The product may fall causing serious injury to a child or an adult and serious damage to the product Use only with a cart stand tripod bracket or table recommended by the manufacturer or sold with the product Any mounting of the product should follow the manufacturer s instructions and should use a mounting accessory recommended by the manufact
5. Satellite Speaker Mount OmniM ount Systems 25MSM or other compatible mounting brackets Please follow the bracket manufacturer s instructions regarding the installation of both the satellite and the bracket On shelves Attach plate to wall The customer is responsible for proper selection and use of mounting hardware available through hardware stores to prop erly and safely wall mount the speakers Slide speaker onto support On the wall Wall brackets included On optional stands Place speaker and support on wall plate SPEAKER CONNECTIONS Connection Tips Separate and strip the ends of the speaker wire as shown Speakers and electronics terminals have corresponding and terminals The lead of the speaker wire is noted with a stripe It is important to connect both speakers identically on the speaker to on the amplifier and on the speaker to on the amplifier Wiring out of phase results in thin sound weak bass and a poor stereo image Speaker Level Left Front Center Right Front Speaker Level Output Subwoofer Speaker Level Input Left Front Right Front Left Surround Right Surround Line Level Left Center Right Front Front Subwoofer Left Sub Right Front woofer Fro
6. defeat the safety purpose of the polarized plug 13 Power Cord Protection Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them paying particular atten tion to cords at plugs convenience receptacles and the point where they exit from the product 14 Nonuse Periods The power cord of the product should be unplugged from the outlet when left unused for long periods of time 15 Outdoor Antenna Grounding If an outside antenna or a cable system is connected to the product be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and built up static charges Article 810 of the National Electrical Code ANSI NFPA 70 provides information with regard to proper grounding of the mast and supporting structure grounding of the lead in wire to an antenna discharge unit size of grounding conductors location of antenna discharge unit connection to grounding electrodes and requirements for the grounding electrode See Figure 1 16 Lightning For added protection for this product during a lightning storm or when it is left unattended and unused for long periods of time unplug it from the wall outlet and dis connect the antenna or cable system This will prevent damage to the prod uct due to lightning and power line surges 17 Power Lines An outside antenna system should not be located in the vicinity
7. nt Out OMO R L Left Right Rear Center Rear Receiver Left Right Surround Surround OPERATION Mode Procedure LED Status Off Receiver amplifier off Off On Receiver amplifier on and playing program material Green Standby Simply turn off your receiver amplifier The subwoofer will Red turn off after approximately twenty minutes The subwoofer will tum on when your receiver amplifier begins playing again Volume Subwoofer Level Level min max TROUBLESHOOTING If there is no sound from any of the speakers check the following Receiver amplifier is on and a source is playing Powered subwoofer is plugged in and is either in the On or Auto position Check all wires and connections between receiver amplifier and speakers Make sure all wires are connected Make sure none of the speaker wires are frayed cut or punctured e Review proper operation of your receiver amplifier If there is no sound coming from one speaker check the following Check the Balance control on your receiver amplifier Check all wires and connections between receiver amplifier and speakers Make sure all wires are connected Make sure none of the speaker wires are frayed cut or punctured If the system plays at low volumes but shuts off as volume is increased check the following Check all wires and connections between
8. of overhead power lines other electric light or power circuits or where it can fall into such power lines or circuits When installing an outside antenna system extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal 18 Overloading Do not overload wall outlets extension cords or integral convenience receptacles as this can result in a risk of fire or electric shock 19 Object and Liquid Entry Never push objects of any kind into this product through openings as they may touch dangerous voltage points or short out parts that could result in a fire or electric shock Never spill liquid of any kind on the product 20 Servicing Do not attempt to ser vice this product yourself as opening or removing covers may expose you to dangerous voltage or other hazards Refer all servicing to qualified service personnel 21 Damage Requiring Service Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions a The power supply cord or the plug has been damaged or b Objects have fallen onto or liquid has been spilled into the product or c The product has been exposed to rain or water or d The product does not operate normally when following the operating instructions Adjust only those controls that are covered by the operating instructions as an improper adjust ment of other con
9. trols may result in damage and will often require exten sive work by a qualified technician to restore the product to its normal operation or e The product has been dropped or damaged in any way or f The product exhibits a distinct change in performance this indicates a need for service 22 Replacement Parts When replacement parts are required be sure the service technician has used replacement parts specified by the manufacturer or that have the same characteristics as the original part Unauthorized substitutions may result in fire electric shock or other hazards 23 Safety Check Upon completion of any service or repairs to this product ask the service technician to perform safety checks to determine that the product is in proper operating condition 24 Wall or Ceiling Mounting The product should be mounted to a wall or ceiling only as recommended by the manufacturer 25 Heat The product should be situ ated away from heat sources such as radiators heat registers stoves or other products including amplifiers that produce heat Figure 1 Example of Antenna Grounding as per National Electrical Code ANSI NFPA 70 Antenna Lead In Wire Ground Clamp Antenna Discharge Unit NEC Section 810 20 Grounding Conductors NEC Section 810 21 Electric Service Equipment Ground Clamps Power Service Grounding Electrode System NEC Art 250 Part H RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION To prevent
10. urer 9 A Product and Cart Combination Should Be Moved with Care Quick stops excessive force and uneven surfaces may cause the prod uct and cart combination to overturn 10 Ventilation Slots and openings in the cabinet are provided for ventila tion and to ensure reliable operation of the product and to protect it from overheating and these openings must not be blocked or covered The open ings should never be blocked by plac ing the product on a bed sofa rug or other similar surface This product should not be placed in a built in installation such as a bookcase or rack unless proper ventilation is provided or the manufacturer s instructions have been adhered to 11 Power Sources This product should be operated only from the type of power source indicated on the marking label If you are not sure of the type of power supply to your home consult your product dealer or local power company For products intended to operate from battery power or other sources refer to the operating instructions 12 Grounding or Polarization This product may be equipped with a polar ized alternating current line plug a plug having one blade wider than the other This plug will fit into the power outlet only one way This is a safety feature If you are unable to insert the plug fully into the outlet try reversing the plug If the plug should still fail to fit contact your electrician to replace your obsolete outlet Do not
Download Pdf Manuals
Related Search