Harbor Freight Tools Self_Centering Drill Press Jig Product manual
Contents
1. Drill Press Jig NCYel 1192046 Safety Precautions and Instructions Distributed Exclusively by 4 HARBOR FREIGHT o 3 TOOLS wah TO PREVENT SERIOUS INJURY READ AND UNDERSTAND ALL WARNINGS AND INSTRUCTIONS BEFORE USE 3491 Mission Oaks Blvd Camarillo CA 93011 Copyright 2005 by Harbor Freight Tools All rights reserved No portion of this instruction sheet or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools For technical questions please call 1 800 444 3353 1 Always wear ANSI approved safety goggles during use 2 Read and adhere to all warnings operation instructions and safety precautions outlined in this instruction sheet and those outlined in the owner s manual for the press that this item is to be used with 3 Before every use check for any broken parts or mounting fixtures and any other condition that may affect proper operation Any part that appears damaged should be carefully checked to determine that it will operate properly and perform its intended function 4 Do not use this jig if under the influence of alcohol or drugs Read warning labels if taking prescription medicine to determine if your judgment or reflexes are impaired while taking drugs If there is any doubt do not use this tool 5 Stay alert Watch what you are doing use common sense Do not use this tool if you are tired The warnings cautio2. ns and instructions discussed in this instruction sheet cannot cover all possible conditions and situations that may occur It must be understood by the operator that common sense and caution are factors which cannot be built into this set but must be supplied by the operator SAVE THIS INSTRUCTION SHEET Operanon Instruction on Back Operation Instructions 1 Firmly secure the jig to the table of the drill press The manner of this will vary carefully follow the instructions provided with the drill press for attaching such accessories If such instructions are unavailable consult a qualified technician for proper procedures 2 Make sure that the jig iS centered di Note Drill press not included rectly underneath the center of the drill 3 After the jig is mounted properly and securely in the correct location place a round piece of stock inside the jig Secure the stock firmly using tie downs clamps or other appropriate means Note lf the stock is not perfectly round it may not seat inside the jig properly Only work on stock that is firmly secured 4 Following the instruc tions provided with the drill press drill a hole into the stock to the chosen depth being careful not to drill into the jig 5 Remove the work piece from the jig 6 Remove the jig if it is not to be used for the next project ITEM 92046
Download Pdf Manuals
Related Search