Harbor Freight Tools 95500 User's Manual
Contents
1. SOLAR INSECT KILLER WITH LIGHT ASSEMBLY amp OPERATING INSTRUCTIONS th ban shee a x ri t OP See ts O Oy ea SN re 3491 Mission Oaks Blvd Camarillo CA 93011 Visit our website at http www harborfreight com TO PREVENT SERIOUS INJURY READ AND UNDERSTAND ALL WARNINGS AND INSTRUCTIONS BEFORE USE Copyright 2006 by Harbor Freight Tools All rights reserved No portion of this manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools For technical questions or replacement parts please call 1 800 444 3353 SPECIFICATIONS Overall Dimensions 5 7 8 L x 5 7 8 W x 6 1 8 H Solar Panel Dimension 2 62 L x 2 62 W Polycrystalline Solar Panel 60 mA 0 24 W 600 mA AA NiCd Batteries Qty 2 included Single LED Light 1 White LED ales hacia MOARE Pest Attracting Light 2 Ultraviolet LED 8 Hours on Fully Charged Batteries Net Weight 0 8 Ib Save This Manual You will need this manual for the safety warnings and precautions assembly oper ating inspection maintenance and cleaning procedures parts list and assembly diagram Keep your invoice with this manual Write the invoice number on the inside of the front cover Write the product s serial number in the back of the manual near the assembly dia gram or write month and year of purchase if product has no number Keep this manual and invoice in a s2. afe and dry place for future reference GENERAL SAFETY RULES WORK AREA 1 Keep work area clean Cluttered areas invite injuries 2 Check for damaged parts Before using any product any part that appears damaged should be carefully checked to determine that it will perform its intended function Check for any broken or damaged parts and any other conditions that may affect its operation Replace or repair damaged or worn parts immediately 3 Always check hardware and assembled parts after assembling All connec tions should be tight and hardware tightened 4 Keep children away Children must never be allowed in the work area Children should not be allowed to play or touch this product because of high voltage Also keep pets away front the Solar Insect Killer with Light D Use eye protection Always wear ANSI approved impact safety goggles when setting up this product 6 Maintain products with care Keep the Solar Insect Killer with Light clean for better and safer performance Follow instructions for set up Be sure the Solar Insect Killer is in the OFF position before cleaning off bugs Clean with a dry brush Be careful not to damage the electric grid Keep the Solar Panel clear of dirt and dust with a damp cloth Inspect periodically SKU 95500 For technical questions please call 1 800 444 3353 Page 2 T People with pacemakers should consult their physician s before using this product Electromagnetic fields in close proxi
3. dually as replacement parts SKU 95500 For technical questions please call 1 800 444 3353 Page 8
4. mity to a heart pacemaker could cause interference to or failure of the pacemaker UNPACKING When unpacking check to make sure that the item is intact and undamaged If any parts are missing or broken please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible ASSEMBLY INSTRUCTIONS Note For additional information regarding the parts listed in the following pages refer to the Assembly Diagram near the end of this manual on page 8 Installation Operation Note The Solar Insect Killer with Light can be configured in two designs One design is as a Light that resembles a Lantern The other design is a Solar Garden Light with a stake that goes into the ground 1 As a Solar Garden Light insert the assembled Stake 17 18 19 amp 20 into a flat and level surface Choose an area where the sunlight falls directly onto the Solar Panel 2 Insert the sharp end of the Stake into the ground deep enough to hold firmly Be sure you have avoided any underground wiring or plumbing Attach the Light firmly on the top of the Stake See the cover photo Make sure the area is not accessible to children or pets and that the area has no plant debris nearby that can fall on the unit 2 As a Lantern design remove the Stake You need to place the lantern in a area where the Solar Panel 2 can be charged with direct sunlight while hanging Lift the Hook 1 and connect it to a chain or hook from a beam or doo
5. move the cage to access the batteries Twist the cage counterclockwise and lift off to expose the Screws 10 Set aside Caution The cage is fragile Handle carefully See Figures 4 amp 5 Underside of 4 top cover p On off Switch 8 Figure 4 2 With a screwdriver not provided remove the Screws 10 to expose the batteries Tilt the Transparent Inner Hood assembly 12 containing the bulbs carefully aside but still connected Remove the batteries being careful not to damage the wiring See Figures 4 above and 5 on page 6 SKU 95500 For technical questions please call 1 800 444 3353 Page 5 Transparent Inner Hood Batteries 11 Assembly 12 Battery Case 9 Figure 5 3 Replace the dead batteries with identical AA NiCd Rechargeable Batteries 11 Be sure to follow the polarity signs inside of the Battery Case 9 4 Reverse these steps and reassembly the Solar Insect Killer with Light Tighten the screws and replace the cage turning clockwise Connect assembly to the Stake Turn the Switch to ON If it does not light check to polarity of the batteries again or place the Solar Light in sunlight and charge 5 Dispose of the used batteries properly by contacting your local community waste disposal facility INSPECTION MAINTENANCE AND CLEANING 1 To remove dust be sure the Switch is in the OFF position Use a damp cloth Dry with a cloth 2 This product is weather resistant but avoid standing
6. r jam Avoid hanging it too low where bodily injury could happen See Figure 3 SKU 95500 For technical questions please call 1 800 444 3353 Page 3 Solar Panel 2 Figure 1 3 You need to flip the Switch to OFF 8 and charge the Solar Insect Killer with Light when using it for the first time Charge time for the Solar Panel 2 is at least 2 3 days After this it will last eight hours without sunlight Turn OFF the light during daylight Note The Solar Insect Killer with Light can also be charged with an AC DC adapter 4 5V 250mA not included Note There are three positions on the Switch 8 ON OFF amp Ultraviolet Light that attracts insects to kill them The Insect Killer position of the switch will operate 6 hours at a time after a full days charge See Figure 2 On Off and Ultravio let Switch 8 Si a bs b gt Ob Oo Figure 2 4 The power Switch 8 is located on the underside of the top cover See Figure 2 SKU 95500 For technical questions please call 1 800 444 3353 Page 4 Hook 1 Lantern Style Ground Stake 17 18 19 20 Figure 3 5 Place the lantern assembly on the top of the Ground Stake 17 18 19 20 Be sure it is connected firmly Turn the Switch 8 ON REPLACING THE BATTERIES Note If the light stops working after being used for a period of time it may mean the bat tery is beyond its lifespan 1 Remove the Light from the Stake From the underside of the Light re
7. water 3 Brush off the dried bugs with the Light in the OFF position SKU 95500 For technical questions please call 1 800 444 3353 Page 6 PARTS LIST ty r r r Circuit Board Aa 1 White Control GreutBoare 1 Recharge Soet 1 Part Description PLEASE READ THE FOLLOWING CAREFULLY THE MANUFACTURER AND OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEM BLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT IN FACT THE MANUFACTURER AND OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO SKU 95500 For technical questions please call 1 800 444 3353 Page 7 ASSEMBLY DIAGRAM Solar Panel 2 Ultraviolet LED White LED Electric Grid Main Body Record Product s Serial Number Here Note If product has no serial number record month and year of purchase instead Note Some parts are listed and shown for illustration purposes only and are not available indivi
Download Pdf Manuals
Related Search