Harbor Freight Tools 56 in., 11 Drawer Glossy Red Industrial Roller Cabinet Product manual
Contents
1. If our inspection verifies the defect we will either repair or replace the product at our election or we may elect to refund the purchase price if we cannot readily and quickly provide you with a replacement We will return repaired products at our expense but if we determine there is no defect or that the defect resulted from causes not within the scope of our warranty then you must bear the cost of returning the product This warranty gives you specific legal rights and you may also have other rights which vary from state to state 3491 Mission Oaks Blvd PO Box 6009 Camarillo CA 93011 1 888 866 57972. not open more than one Drawer at once Empty close and lock Drawers before moving Use only on a flat level hard and smooth surface capable of safely supporting a fully loaded Cabinet Do not roll Cabinet over concrete seams or other rough uneven surfaces US GENERA Item 67681 T 10 11 12 13 For technical questions please call 1 888 866 5797 Do not lift using handle s Do not move or lift while loaded To prevent tipping move using supplied handle on Bottom Cabinet only Lock Swivel Casters after moving Do not mount on truck bed or any other moving object Use as intended only Inspect before every use do not use if parts are loose or damaged Maintain product labels and nameplates These carry important safety information If unreadable or missing contact Harbor Freight Tools for a replacement Page 3 Assembly Instructions Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document including all text under subheadings therein before set up or use of this product 1 Assemble on a flat level hard and smooth surface capable of safely supporting a fully loaded Cabinet 2 Attach Side Handles 3 using Handle Screws 2 3 If using Top Chest 61370 assemble according to its Owner s Manual Handle Screws Figure A Final Assembly 1 Using an assistant place EMPTY Top Chest on top of Bottom Cabinet 2 WARNING M
3. x 4 154 Ib 37 5 16 W x 19 1 2 L x 6 H 220 Ib Component Size Weight Capacity 37 5 16 W x 19 1 2 L x 8 H 220 Ib 12 5 16 W x 19 1 2 L 5 H 154 Ib 12 5 16 W x 19 1 2 L x 154 Ib each 12 5 16 W x 19 1 2 L x 4 154 Ib 12 5 16 W x 19 1 2 L x 14 H 220 Ib Total Combined Weight Capacity 3458 Ib Evenly distributed from bottom up US GENERAL Page 2 For technical questions please call 1 888 866 5797 Item 67681 IMPORTANT SAFETY INFORMATION Assembly Precautions 1 Assemble only according to these instructions Improper assembly can create hazards Wear ANSI approved safety goggles and heavy duty work gloves during assembly Keep assembly area clean and well lit Keep bystanders out of the area during assembly Use Precautions Do not assemble when tired or when under the influence of alcohol drugs or medication Weight capacity and other product capabilities apply to properly and completely assembled product only Assemble on a flat level hard and smooth surface capable of safely supporting a fully loaded Cabinet TO PREVENT SERIOUS INJURY AND DEATH FROM TIPPING DO NOT SIT STAND OR CLIMB ON THIS ITEM This product is not a toy nor a toy chest Do not allow children to play with or near this item Do not exceed weight capacities evenly distributed from bottom up Be aware of dynamic loading Sudden load movement may briefly create excess load causing product failure Do
4. Owner s Manual amp Safety Instructions Save This Manual Keep this manual for the safety warnings and precautions assembly operating inspection maintenance and cleaning procedures Write the product s serial number in the back of the manual near the assembly diagram or month and year of purchase if product has no number Keep this manual and the receipt in a safe and dry place for future reference US GENERAL 56 11 Drawer Industrial Roller Cabinet ITEM 67681 Visit our website at http www harborfreight com REV 14j Email our technical support at productsupport harborfreight com When unpacking make sure that the product is intact and undamaged If any parts are missing or broken please call 1 888 866 5797 as soon as possible Copyright 2010 by Harbor Freight Tools All rights reserved 3 No portion of this manual or any artwork contained herein may be reproduced in Read this material before using this product any shape or form without the express written consent of Harbor Freight Tools Failure to do so can result in serious injury Diagrams within this manual may not be drawn proportionally Due to continuing SAVE THIS MANUAL improvements actual product may differ slightly from the product described herein Tools required for assembly and service may not be included Specifications 56 1 2 W x 21 3 4 L 1500 Ib 37 5 16 W x 19 1 2 L x 5 H 220 Ib 37 5 16 W x 19 1 2 L x 3 H 154 Ib each 37 5 16 W x 19 1 2 L
5. ake sure the Top Chest is seated inside the Bottom Cabinet s edges Bottom Cabinet Figure B US GENERA Page 4 For technical questions please call 1 888 866 5797 Item 67681 Operation Instructions Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document including all text under subheadings therein before set up or use of this product Empty all Drawers 5 Roll Cabinet to a flat level hard and smooth surface capable of safely supporting a fully loaded Cabinet Do not roll Cabinet over concrete seams or other rough uneven surfaces Close all Drawers and lock them Unlock Swivel Casters 6 Lock Swivel Casters To prevent tipping move using supplied handle on Bottom Cabinet only 7 Unlock Drawers and fill Cabinet evenly from bottom to top Do not exceed weight capacities Maintenance Servicing Procedures not specifically explained in this manual must be performed only by a qualified technician AWARNING TO PREVENT SERIOUS INJURY FROM TOOL FAILURE Do not use damaged equipment If any part becomes damaged have the problem corrected before further use PERIODICALLY inspect the general 2 Wipe external surfaces of the condition of the Cabinet Check for Cabinet with clean cloth loose hardware 3 Lubricate Drawer Slides as needed misalignment or binding of moving parts brake operation caster swivel fu
6. ct has no serial number record individually as replacement parts month and year of purchase instead Page 6 For technical questions please call 1 888 866 5797 Item 67681 Assembly Diagram De Veen T call 1 888 866 5797 Limited 90 Day Warranty Harbor Freight Tools Co makes every effort to assure that its products meet high quality and durability standards and warrants to the original purchaser that this product is free from defects in materials and workmanship for the period of 90 days from the date of purchase This warranty does not apply to damage due directly or indirectly to misuse abuse negligence or accidents repairs or alterations outside our facilities criminal activity improper installation normal wear and tear or to lack of maintenance We shall in no event be liable for death injuries to persons or property or for incidental contingent special or consequential damages arising from the use of our product Some states do not allow the exclusion or limitation of incidental or consequential damages so the above limitation of exclusion may not apply to you THIS WARRANTY IS EXPRESSLY IN LIEU OF ALL OTHER WARRANTIES EXPRESS OR IMPLIED INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS To take advantage of this warranty the product or part must be returned to us with transportation charges prepaid Proof of purchase date and an explanation of the complaint must accompany the merchandise
7. nction and movement cracked or broken parts any other condition that may affect its safe operation o BENERA Item 67681 For technical questions please call 1 888 866 5797 Page 5 PLEASE READ THE FOLLOWING CAREFULLY THE MANUFACTURER AND OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN THIS DOCUMENT AS A REFERENCE TOOL ONLY NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT IN FACT THE MANUFACTURER AND OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO Parts List and Diagram Parts List Part Description Qty 6 6 x2 Fixed Caster 8 Drawer Handle Label 6 9 DrawerHandle 6 Drawer 37 5 16 W x 19 1 2 L x 6 H 6 x2 Swivel Caster Drawer 37 5 16 W x 19 1 2 L x 8 H Drawer 12 5 16 W x 19 1 2 L x 5 H Drawer 12 5 16 W x 19 1 2 L x 14 H Record Serial Number Here Note Some parts are listed and shown for illustration purposes only and are not available Note If produ
Download Pdf Manuals
Related Search