Harbor Freight Tools 24 In Bolt/Cable/Wire Cutters Product manual
Contents
1. Pittsburgh ITEM 96252 24 BOLT CABLE WIRE MULTICUTTER JAW GAP ADJUSTMENT INSTRUCTIONS Jaw Gap Adjustment Cam bolts When properly set the gap between the edges should be parallel and be able to grip a sheet of paper Observe the indexing arrows bolt faces and turn them equally Hold each bolt then tighten the nut Open and close the jaws a few times to set in the tool and double check the gap Repeat the setting if jaw gap is incorrect Turn Cam bolt arrows inward to close in jaw tips Turn Cam bolt arrows outward to close in the jaw heels Jaws Lower Pivot Bolts Over tightening of these bolts may intervene with smooth pivoting action of the jaws Minimum Jaw Closure Limiting Screw With the jaw gap set back off the screw until it rests against the opposite handle s face then unscrew it one more flat and tighten the nut Note The Cam bolts are pre lubricated at the time of assembly However whenever the jaws are re adjusted it is recommended to back off the Cam lock nuts and place a drop of lubricating oil inside the Cam lock housing To prevent serious injury 1 Wear ANSI approved safety goggles during use 2 Never use on live electrical circuits 3 Keep fingers clear of sharp blades 4 Keep out of children s reach Distributed exclusively by Harobr Freight Tools 3491 Mission Oaks Blvd Camarillo CA 93011 Visit our website at http www harborfreight com Read this material before using this product Fail2. ure to do so can result in serious injury SAVE THESE INSTRUCTIONS Copyright 2009 by Harbor Freight Tools All rights reserved No portion of this manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools For technical questions or replacement parts please call 1 800 444 3353
Download Pdf Manuals
Related Search