Hampton Direct Katie Jig Appendix C User's Manual
Contents
1. IE JIG System while the router is running Page C 2 Copyright 1997 2000 Hampton House Inc2. KEL appendix C Router Table Handles Appendix C Router Table Handles Follow the safety and general instructions for using the KATIE JIG System except as indicated below Attaching Router Table Handles to the KATIE JIG System Attach handles to ends of KATIE JIG System fixture using screws provided so that the guide tuning forks will be down Securely clamp the boards to the KATIE JIG System using 2 clamps Placement of these clamps should be done to best accommodate the boards CAUTION Make sure the clamps do not interfere with the router bits Prepare Router Table and Set Height of Bits For best results use two routers mounted in router table Determine height for dovetail bit At least 1 16 of bearing must extend above base of router table Thickness of pin board Dovetail bit depth Trim stock or spacer 1 2 for guide tuning forks Base of router table Copyright O 1997 2000 Hampton House Inc Page C 1 Determine height for pattern bit Thickness of tail board Pattern bit depth Trim stock or spacer T 1 2 for guide forks At least 1 16 of bearing must extend above base of router table Base of router table Routing Pins and Tails Grasp the router table handles on the side opposite the board that you wish to route and slide the KATIE JIG System toward the bit Carefully route the areas between each of the guide tuning forks CAUTION DO NOT lift the KAT
Download Pdf Manuals
Related Search