Haier JTHA30- User's Manual
Contents
1. The safety valve should be connected to the cold water inlet pipe Please check carefully if the direction is correctafter installation The correct direction of installation is that the arrowhead on the safety valve should point to the water heater Please connect the drain hose tothe safety valve Connect one end of the hoseto the safety valve ventand the other end to the sewage drain The hose canbe cut shortor extended as necessary The hose shall be installed as inclined downward see to Figure 42. by the spraying hot water In case the power cord of the water heater is damaged be sure to have it replaced by after service technicians with special cord offered by the manufacturer The product adopts the patent Safe Care technology of our company As long as adopting civil power supply even if the earthing wire is electrified by mistake the Safe Care technology still can block the dangerous electricity and ensure your personal safety But if you find perceptible current please pull off the power plug and contact local after service departmentfor maintenance Do not disassemble byyourself Description of the Symbols Setting Environment f 9 O Do not set it atplace where is too cold and may freeze oO Do not use as floorstanding appliance oO Please mount it to firm and reliable wall Incase connecting water heater with water drain Dono installto places without sewer hose connect the drain hose to the inlet of the sewer to avoid polluting by splashing The original pipeline of the water heater is an organic part of Safe Care Do not remove itby yourself Otherwise we will not take responsibility for the injure and loss caused by the safety trouble occurred therefrom Description of the Symbols Y Never do that Be sure to act as per instructions O Installation Installation must be made by installers of or
3. designated by our company after service department The water heatershall be wall mounted Before installation make sure water heater rear wires are fit firmly Determine an installation location Make four holes 12mm 65 mm deep in the wall with an impact drill according toinstallating dimension Insertfixexpansion hooks and expansion bolts in corresponding wall holes Lift the water heater Insert wall rack onto the hooks and bolts Fit flatwashers rear wires and nuts in turn onto the bolts see Figure 2 Tighten the nuts and check them firm Install accessories such as safety valve drain hose as shown in Figure 3 Use sealing compound to preventwater leakage To facilitate installation and removal it is suggested a G 1 2 movable nutis fitted at appropriate locations oninlet and outlet pipes respectively Find water supply location Connect inlet pipe outlet pipe andcity water piperespectively to theuse point The hot water pipe shall notbe too longto reduce the heat losses Please reserve some space in installation for the future maintenance 7 O 2e v Hot t i water outlet Safety valve Cold water inlet Pai Hot water Cold water outlet valve 4 outlet valve 1 Mixing valv Shower head Figure 2 Figure 3 for reference in installation only Connection and useof safety valve
4. long operation life 3 Convenience Adjustable heating temperature Adjustable water temperature Adjusting range water inlet temperature 75 C 4 Multiple usage Enclosed structure capable of supplying waterto multiple placeslike toilet kitchen etc Suitable forfamily enterprises service tradeslike beauty careon hot watersupply not drinkable 5 Nice molding horizontaltype wall mounting design saving space The water heater you purchasedis the improved model of the series product Please operate according tothe user s manual Parameters Rated voltage 220V 50Hz Rated power 1200W Rated pressure 0 75MPa Waterproof grade IPX4 Dimensions Dimension See to Figure 1 Weight See to Figure 1 Volume Seeto Figure 1 Tap water pressure no less than0 05MPa Figure 1 Front v iew Cutaway view Bo ttom view Model Volume Sn A a c1 d1 e1 f1 kg ties ure Cmm mm mm mm mm mm FCD JTHA30 III ET 30L 15 1 75 569 366 100 192 347 200 FCD JTHA40 I ET 40L 16 5 T5 688 391 100 220 353 200 FCD JTHASO III ET 50L 18 5 75 694 438 100 220 400 200 FCD JTHA60 I ET 60L 20 5 75 795 437 100 305 400 200 FCD JTHA80 I1 ET 80L 26 6 75 991 440 100 521 400 200 Remarks the permitted errorlimit of above parameters is 10 A Hot water outlet B Cold w
5. Little Sea ox Haier Household Electric Water Heater User s Manual mel FCD JTHA30 II ET FCD JTHA40 II ET FCD JTHASO III ET FCD JTHA60 III ET FCD JTHAS80 III ET Haier Group Qingdao Economic and Technological Development District Haier Water Heater Co Ltd Haier Garden Qianwangang Road Economic Development Zone Qingdao P R China ae Number 0040500304 Please read this manual before usage Retain it for future reference E Pre safe Expert afe Care E PTOIO Mark of This mark is the designation for Pre safe Expert of Haier Water Heater Company which indicates use of the company s patented technology inside the product It ensures you a safe bath while monitoring whether your house ground wire islive or not all the time If this mark is lightedon it indicates your house ground wire has come live poor grounding and live In this case please immediately stop use and unplug from the power supply and remember notto touch any electric appliance shell in your house At the same time immediately contact after sales service and your property management company for professional repair untilthe mark goes off Pre safe Expert will become the electric safeguard for your Haier Safe Water Heaters family E Contents Before usage i Packing List Electric Safety Drain hose Expansion Expansion User s Name water valve ply bolt hook manual he
6. ater pcs pcs pcs copy set Quantity 1 1 1 2 2 1 Fi Note This appliance isnot intended foruse by persons including children with reduced physicalsensory or mentalcapabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by aperson responsible for their safety Children should besupervised to ensurethat they donot play withthe appliance Features ecer ieres esre ir itita stepene 9 Parameters 2282 icecet oii ceed dias 3 DIMENSIONS 2226822 ee Sete ee Sete tes 3 Electric circuit diagram 3 Safety precautions 4 Setting environment eere 5 Installlation Installation eee 6 7 Attentions in instruction 00e 7 Operation instructions ece 8 Attentions in operation 8 FAQ Cleaning and maintenance gt 9 FAQ ee eee ee eee eT Cone eet oe 9 Packing E EEEE E eee ee ceed 10 ING tGsinsctend oe seepaiay e a Beas 10 See to the physical product forthe appearance coloror pattern 10 E Cleaning and Maintenance Statement This water heater shall only be repaired and maintained by qualifie servicemen Improper maintenance may cause severe injury or damage Before opening or repairing water heater please dopull out the power plug Note Before asking for service please refer to troubleshooting section to resolve easy problems External Cleaning Disconnect power supply before cleaning Ge
7. ater inlet C Heating element D Enamel tank E Wall mounting bracket rod F Magnesium anode Electric Circuit Diagram L Brown wire N Blue wire MT High temperature limiter BT Thermostat HL Heating indicator EH Heating element E Yellow green wire BT A L N Se HL Operation Instructions O For the first use after installation due to there s no water within the tank first the city water inlet valve and mixing valve must be opened Close the mixing valve when water flows out continuously from the showerhead or other outlets the tank is full Check connections are free of water leakage and insert the power plug O Tum the knob to set your desired water heating temperature which can be stepless changed between cold water inlet temperature and 75 C In heating mode heating lamp is lighted on Normally the knob shall be positioned at highest temperature This machine has a thermostat function which automatically switches off the water heater when temperature reaches the setting value and switch on again when water temperature decreases to certain value O city water pressure 0 75 MPa will cause much water flowing out from safety valve pressure relief vent This is due to too high water pressure Please ask after sales service for correction Attentions in Operation 1 To avoid causing machine troubles do not conn
8. ect power before tank is full of water 2 Adjust a suitable temperature before use for water temperature above 50 C may burn your skin 3 This product is closed water heater which can supply hot water through pipe connection to several points like bathroom bathtub washbasin showerhead and kitchen 4 Heating adjustment can be made flexibly all year round adapting to climate changes In long term out of use or maintenance you can close city water pipe valve open mixing valve to hot water range and move up safety valve handle to drain the tank To avoid injury before next use it is suggested to first open hot water valve before switching on the water heater exhausting gas possibly retained inthe pipeline In this case no smoke or fire is permitted near the open valve Carefully check and confirm all parts arein good condition 5 Provided hot water quantity can meet use demand temperature setting shall be possibly low It can minimize heat dissipation high temperature corrosion and sedimentation ensuring a longer service life 6 Regularly ask servicemen to make safety inspection remove sediment on heating elements and check consumption of anode bar Too much consumed anode bar shall be replaced Installation O The water may drip from the discharge pipe ofthe pressure relied device and that this pipe must be installed in a continuously downward direction and in a frost free environment Check safety valve once a month as fo
9. et bowl bathtub washbasin ordoorframe where willcause a suppressedor unsafe feeling to users Power socket forwater heater shallbe in adry place free of water splash splash proof box ispreferred Do not confuse inlet and outlet water pipes Safety valve shall be installed at designated position withno random modification 7 Safety Precautions Check if the ammeter and the diameter of the wires are in accordance with the rated current of the water heater If necessary please have it checked by experienced electrician OThe water heater adopts power supply of 220 240V 50 60Hz Be sure to use independent receptacle and earth it reliably The receptacle shall comply with the stipulation of national standard ce O Set the receptacle of the water heater at dry position away from water spraying Do not insert and pull the power plug with wet hands O After installation be sure to fillthe heater completely with water before switching on the power in the first usage Children must take bath under the supervision of adult In winter of cold area if the heater is idle for a long period please pull the handle of safety valve to discharge the water Otherwise it may freeze inside the water heater and cause damages OQ Never do that Q Be sure to act as per instructions On opening and closing the water valve do not point the shower head to human body Otherwise it may hurt
10. ice departmen 2 always light uncontrollable thermostat when are excluded Unconstant flow and Unconstant water pressure Adjust the flux of outlet water temperature or use with constant water pressure of water a Temperature set too low Adjust setting water temperature Insufficient hot water Excessive water pressure Adjust the flux of outlet water L Before Usage Dear users Thanks forchoosing Haier waterheater product Haier products have good quality andexcellent performance Tofacilitate you touse the product pleaseread the manualand operate accordingly Please retainit for future reference The international star service of Haier Group willalways accompany you No matter what kind ofproblems you meetin usage please contact with the local after sales service agent We are atyour service allthe time Thanks again forchoosing Haier Product The water heater you purchased may not fullcomply with the manual due tothe improvement of product We apologize for the inconvenience occurred therefrom fa Features 1 Safety High quality heat proofstainless steel electricheating element overtemperature protection overpressure protection of tank safeand reliable Safe Care patented design together with the functionof monitoring anddisplaying of live groundwire has becomea real safeguard for family safety 2 Durability The shell adopts dusting anticorrosiontreatment handsome and durable enamel tank with reliable quality and
11. llow move the small handle of safety valve if there s water flowing out safety valve is normal if there s no water flow please pressure release hole contact local after sales service station The pressure relief device is to be operated Figure 4 regularly to remove lime deposits and to verify that itis notblocked Attentions in Installation During installation adequate space must be reserved for future maintenance and repair If the water heater is installed within decoration boards the right board shall be removable to facilitate removing the plastic coverduring maintenance City water inlet pressure shall not be less than 0 05 MPa Maximum pressure can not exceed 0 7MPa Electric water heater shall be installed indoors with ambient temperature above 0 C The pipes shall be collectively laid Hot water outlet shall not be too far from use points Incase farer than8 m hotwater pipe shallhave a thermalinsulation to minimize heat loss The mounting wall shall be firm and reliable to support twice the weight of water heater full of water Non load bearing walls or air brick walls must have corresponding protective measures like additional support wall through screws or back boards Electric water heater shall be located in a place easy for use maintenance and with a floor drainer Incase the tank or pipes leak nearby or lower facilities shall not be damaged The installation location shall avoid being above toil
12. ntly wipe with wet cloth dipped with a little of mild detergent Do not use gasoline or other solvents Finally dry with dry cloth Keep water heater dry Do not use cleansers containing grinding agent e g toothpaste acids chemical solvents e g alcohol or polishers to clean Internal Cleaning To ensure high working efficiency heating elements andtank liner of water heater shallbe cleaned oncein three years Take care notto damage protection layer on heating elements and tank liner inner surface According to different local water qualities and use habits magnesium rod shall be periodically replaced If maintenance is needed please contact localservice station E Faa Phenomenon Confirmation items Remedy No water supply or water pressure too low Check No water Hot water access close Check and clear Hot water access close Check and open Only cold water but Temperature not set to desired setting Adjust temperature of water pointer light heating time limit and setting i Keep heatin when heat temperature not obtain p g A Contact with service department Defective heater when DOQ are excluded Only cold No power to heater Check power socket water and A Contact with service department pointer not Uncontrollable thermostat when are excluded light when heat i i Setting water temperature not obtain Keep heating Heating pointer GontGci wiki ced n i 4 ontact with serv
Download Pdf Manuals
Related Search