Haier HLP455E User's Manual
Contents
1. forbidden to perform Performing of those actions may result in damage of the machine or injure the personal safety of he user Please check if the power receptacle has good earthing condition before using to guarantee your safety Safety precautions Please insert the power cord into special When the machine is normally using receptacle with rated voltage Be sure to please put the power plug at the location use single phasethree pins receptacle easily to be inserted and extracted by hand The ground terminal of the receptacle Be sure to pull the plug off when there s must be properly grounded If possible power failure or the machine is being please adopt electric leakage protector moved cleaned or when it is idle If the power cord is bad to avoid risk it is required to replace it by the technicians of our special shop or the customer care department Keep the pin of the power plug clean Do not put the machine at damp place like the bathroom Never wash it with water Do not place wet laundries on the control panel In case the washing machine is installed Do not wash water proof laundries like on ground with carpet do not block the the raincoat bike covers etc to avoid ventilation hole with carpet abnormal vibrations in spinning Ventilation hole at the bottom of the washing machine amp 9 9S Do not let the machine share one receptacle with other electric appliances If2. the whitener with container Pour it slowly into the washing tub e Avoid using whitener on laun dries with color or pattern as they are prone to lose color The whitener shall not touch the laundries directly Refer to the user s manual for the usage and quantity of the whitener For powder whitener please dissolve it before using Washing sequence Wash timer ie set to below 2 minute irst set to 6 minute then turn it back it can increase the service life of the timer e WASH TIMER WASH TIMER WASH SELECTOR 4 CYCLESELECTOR 1 Fill small quantity of water 2 Add the powder Run for 30 seconds to dissolve it completely 3 Put it in the laundries Select suitable water level The instant dissolving of the washing powder 1 Prepare warm water of 30 C anda container 2 Add the powder while stirring to fully dissolve it The powder is more prone to pollute the laundries than the detergent Therefore please use it with proper quantity e Dosage of different washing powder is different Please refer to the instruction of the washing powder for the detail dosage Spin timer He set to below 1 minute irst set to 2 minute then turn it back it can increase Water inlet the service life of the timer WATER INLET SPIN TIMER Washing sequence Wash The input water level should 1 Fill the water not exceed the labled position Set the water filling selector at th
3. not the machine may stop at mid way less than 26mm and the length shall not exceed 1 5m 2 Do not ramp or press the drain hose 3 If the drain hose is too long cut it at mid If the extrahose is toolong cut it point To make smooth drainage cut the either atA orat B point front end of the hose slantingly a te i p Install the water inlet hose Water inlet pipe Please install the water inlet accordingto the machine Water filling entrance Control panel s frame Figure 1 Insert the Water inlet pipe into the Water filling entrance If want todemount the water inlet pipe pull it out Preparation before washing Preparation before washing 1 Connect the water inlet hose 2 Confirm that the washing machine is properly grounded Then insert the power plug into the receptacle Do not connect the ground terminal to the gas pipe and tap water pipe 3 Put down the drain hose 4 Slanting or uneven floor may result in unstable working or abnormal noise Please make the machine stand horizontally Pay attention to followings before washing the laundries Check if the laundries has special requirement on washing Clear the pocket Take out the coins sand hairpins etc is A Tie the long strips fasten the buttons close zippers The quantity of the laundries shall not be too large Stretch and loosen the laundries before putting them in the tub 2 When
4. D If it is set at DRAIN it will be rather difficult for the frozen water to melt When the water is frozen Pour hot water below 50 C into the wash tub to soak it completely Then turn the pulsator with hands gently Please confirm the drainage can work normally before next using Trouble shooting If there s breakdown please pull off the power plug before checking Problem The machine does not act Possible reason Is there power failure Is the power plug loose Is the pulsator twisted by foreign materials The draining does not work Is the drain hose frozen Is the drain hose blocked by foreign material Are there laundries falling to the outer side of the spin tub There s abnormal sound during washing e Are there hair pin coins or metal items brought inside the tub There s abnormal sound and violent vibration during spinning e Is the machine slanting Is the gland pressed evenly e Are there laundries falling to the outer side of the spin tub e Are the laundries in spin tub too much There may be some water flowing out of the drain hose in the first use of the machine e t is the water remained in the factory inspection of performance Packing list C Name Quantity User s manual One piece e Warranty card One piece crt l Water inlet hose One piece mms H Gland One piece Twin tub washing ma
5. Twin tub Washing Machine User s manual Haile Model HLP455E e Please read this manual carefully before using Retain it for future reference e The machine is for cold water connection only Contents Fis of the parts semen eee A Safety precautions 1S Ge Oe Be en ae ketei 9 Installation and adjustment sssssssss gt 4 Preparation before washing t 5 The musts in washing Ha REG Beware Usa eee ee 6 Usage of the detergent stsrtrttt errr ete 6 Washing SEQUENCE ce 6 Disposal after washing paaa ada dadaa a aa a a ee a 8 Trouble Shooting Answer to question 8 a list amp Specification the back a Names of the parts Outer cover of the spin tub Wash tub cover Wash timer Water filling entrance Wash tub Spin timer Wash selector Inner cover of the spin tub Control panel Spin tub Power cord Cabinet Hook of fixing the drain hose Back cover Drain hose Pulsator Base frame Filter cover Cabinet handle Bottom foot Meaning and description of the symbols Contents marked with that symbol are related to the safety of the product and the personal safety of the users Please operate in strict conformity to the contents otherwise it may cause damage of the machine or injure the personal safety of the user Warning sign Forbidding sign Contents marked with that symbol are actions
6. chine e One set S Specification Maximum 17 Water level L Injection pressure MPa 0 02 0 2
7. e WASH side a Set the water level adjusting lever to needed line as Please note that the input water voltage should be NEF controled between 0 02 0 2MPa Fill the water and add the dissolved washing powder to make the water level reach the preset position Run washing program for some time to stir and dissolve the powder completely Figure 1 rey 3 Put in the laundries If the water quantity is z insufficient please add water 4 Select the current WASH TIMER Select the strength of the current according to SNe et Figure 3 the laundries Select the washing time according to the 2 laundries Figure 2 Figure 3 5 After washing set the WASH SELECTOR CYCLE SELECTOR at SPIN Figure 4 Figure 4 P h Midway spinning a pA 1 Put the laundries into the spin tub evenly and smoothly 2 Spin 1 Put the gland in properly Please put in the gland properly even Proper erat Proper No gland if the laundries quantity is small 2 Close the inner and outer cover of the Outer cover of fj The spin tub spin tub 3 Spin for 1 2 minutes Inner cover of ee The spin tub 3 If the water quantity filled is too large the water may flow out from the wash tub side Please twist the water tap to limit the water filling Rinsing Spinning 1 Put the laundries into the spin tub evenly and smoothly 1 Put the laundries into the wash tub Select Suitable current according to the laundries 2 Press the gland in
8. the power plug is damaged or the plugging into the receptacle is loose do not use the plug any more Safety precautions Do not stretch hands into the working machine It is dangerous even if the rotation is slow Take special care of the children Do not decompose repair or alter the machine by yourself Do not put any hot or heavy items such as the kettle with hot water on the washing machine Do not wash laundries with volatile materials such as thinner petrol etc Handicapped or children without care shall not use the machine Keep the machine away from direct sunlight and heat source like the heater To protect your laundries and wash ing machine please take out all of the coins buttons sand hairpin and other foreign materials before washing lt So Please check if the water faucetis open and if the connection of the water inlet pipe is proper tis suggested to use foamless washing powder Installation and adjustment Please install and adjust the machine according to the requirement of the manual It is very important to your security and correct operating the machine Usage of the drain hose The drain hose shall drain smoothly 1 The height of the drain hose shall be 4 lf extra drain hose is needed please less than 10cm or the drainage will not make separate purchase The inner be smooth and cost such long time that diameter of the extra hose shall
9. the pulsator is running the buttons of the laundries may cause noise For the sake of discretion please put the laundries with buttons into other laundries aoo it over before putting in f Do not put those laundries polluted by chemicals into the washing machine directly Check if the laundries are applicable for washing with machine Divide the laundries that are not colorfast from other laundries Put those laundries difficult to absorb water into water with hand For those laundries with heavy soil please first remove the dirt like mud or dust For the parts with heavy soil please apply detergent on them in advance which can make it easier to remove the soil For those laundries that may get lint ball and those with long fur tum Operating instructions The capacity of washing and spinning of the machine refer to the largest weight of the standard laundries under dry condition that can be washed or spinned in one time The thickness size type of the cloth will influence the actual washing capacity It is suitable to put in reasonable amount of laundries and the laundries can be turned round in washing for one time washing Do not select high water level for laundries less than 1 0kg so as to avoid splashing of water Usage of the detergent How to lise the whitener How to use the washing powder Direct dissolved in the machine Fill water to decided level Dilute
10. the tub properly Close the inner and outer cover of the spin tub 2 Fill the water 3 Spin a Purane water ee according to Select suitable spin time according to the laundries and the laundries quantity do spinning During spinning if there is abnormal sound it is generally owning to slanting placement of the laundries 3 Rinse Please stop the machine and reorder the laundries Adjust the wash timer to 5 7 minutes to do 4 In spinning it will pause the work if you open the outer rinsing cover of the spin tub Close it to resume the spinning Maintenance and cleaning e Please first pull off the power plug from the receptacle before cleaning e Wipe the complete unit with soft After washing dismount the water inlet hose cloth twisted dry Wipe with neutral detergent if Do not store water in the tub for long period too dirty Do ASE nach it directly by water Discharge the water immediately after each using Pull off the power plug and hang up the power cord Hang up the drain hose Wipe off the water drops on the surface and inside the tub with clean soft cloth Open the cover of the wash tub and the inner outer cover of the spin tub for some time about one hour then close them Trouble shooting When the remained water is frozen Prevent the freezing be sure to discharge the water completely after using After complete draining set the WASH SELECTOR at STRONG or STANDAR
Download Pdf Manuals
Related Search