Greenway Home Products Muskoka MEF2822CWG User's Manual
Contents
1. Assembly Instructions Instructions d assemblage Instrucciones de montaje HOME VARRAJ iN RANTIE LA Majo ry anata EN SU PROPI El A MEF2822CVVG SAVE THESE INSTRUCTIONS CONSERVER CES INSTRUCTIONS GUARDE ESTAS INSTRUCCIONES REV04 Musk ka TIPS FOR THE ASSEMBLY OF YOUR NEW MANTEL e Before you begin assembly locate the instructions and hardware Take out all the parts and compare them to the diagrams below Be sure you have all the parts and can identify them e A helping hand is always good Assemble your mantel with an adult assistant if possible Some pieces are heavy and will need to be held by a helper Assembly time will take approximately 30 60 minutes OUTSIDE VIEW ger a a INSIDE ag VIEW TOP 1PC ZZ 2822CWG 08 BASE 1PC ZZ 2822CWG 01 CORNER BOTTOM FIREBOX SHELF 1PC SUPPORT 1PC ZZ 2822CWG 11 ZZ 2822CWG 09 LEFT FRONT LEFT SIDE RIGHTFRONT RIGHT SIDE PANEL IPC PANEL 1PC PANEL IPC PANEL 1PC ZZ 2822CWG 05 ZZ 2822CWG 03 ZZ 2822CWG 04 ZZ 2822CWG 02 UPPER FACING LOWER PANEL 1PC FACING PANEL 1PC o ZZ 2822CWG 06 ZZ 2822CWG 07 CORNER UPRIGHT SUPPORT 1PC ZZ 2822CWG 10 lt ES 20PCS 20PCS INCLUDES 1 SPARE CORNER ATTACHMENT 1PC ZZ 2822CWG 08 1 WINGNUT AND LOCK WASHER ANTI TIP DEVICE 2 SETS 1 GET READY TO START St ep t Before assembly use scissors to unwrap the parts from the packaging DO NOT use Re an i a box cutter or exacto knife as you may cut into2. eir Distributor or Greenway Home Products within the warranty period The obligation of Greenway Home Products under this warranty is expressly limited to such replacement or repairs The provisions of this limited warranty shall not apply to the following 1 Accidents Unauthorized repairs or alterations Normal maintenance Changes made to other units manufactured after this mantel was manufactured Incidental damages caused by failure of the mantel such as inconvenience or loss of use Improper installation 9 oO PON The provisions of this limited warranty shall not apply to deterioration due to wear and exposure beyond the following limitations 1 For 180 days from the date of purchase for exterior finished surfaces Due to the properties of natural wood Greenway Home Products makes no warranty against mineraling of wood components Greenway Limited Warranty is void unless the following conditions are adhered to 1 Warranty registration must be completed and returned to a Greenway Home Products 2 All warranty repairs must be preauthorized by a Greenway repair facility 3 Greenway reserves the right to inspect defective parts that have been replaced under warranty Dealer is expected to hold defective parts for 60 days 4 Only parts and accessories and other material available through Greenway Home Products are to be used in the performance of warranty service 5 Purchasers are responsible for presenting notifying their Distrib
3. ight of the corner triangle Now attach the corner bottom support to the corner upright support by insert and tightening 1 wing and 1 lock washer Step 8 Take your electric firebox out of its packaging and position it between the 2 legs of the mantel Once you are close to the wall plug the firebox into the nearest outlet The firebox comes with 3 metal brackets and 20 black screws These metal brackets must be attached to both the sides of the firebox and the mantel to ensure that your firebox does not move around as you use it 2 of the brackets have 2 large holes on one side These large holes line up with 2 screws on the side of the firebox The other screws provided must be inserted into the holes at the other end of the bracket and into the firebox The other side of each bracket attaches to the mantel The 3rd bracket has no holes on 1 side That side should go up against the firebox top but should not be attached as the heater sits right underneath the bracket Only the mantel side should be attached If you have any questions about the firebox please reference the installation instructions that come with the firebox Please reference the Quick Tips section of that instruction manual NOTE Some fireboxes come with pre attached trims Step 9 You are now ready to position your mantel against the wall This step requires 2 people to move the unit Anti tipping device At this point you must attach the anti tipping device to yo
4. ox Position this panel with the granite side facing the front of the mantel Line up the holes on each side and insert and tighten 1 wingnut and 1 lock washer on each side Step 6 Get your assistant and locate the top of your mantel This top is very heavy It will take 2 people to lift and position it in place Ensure the top goes over the positioning guide located on the header The top must go over this guide to be positioned correctly Line up the holes on the top of the mantel insert and tighten 5 wing nuts and lock washers 2 Step 7 If you are using this mantel in a corner application locate the triangular piece of wood which attaches to the mantel to create the corner unit You must attach this piece for all corner applications Slide the corner bottom support into the channel located at the middle of the back of the hearth base Place the top corner attachment on the floor upside down Protect it from damage Attach the corner upright support to the corner attachment by lining up the hole in the corner upright with hole in the corner top insert with 1 nut and 1 lock washer Simply take the triangle and slide the brackets with the holes onto the pins which are already attached to the mantel Once the triangle is attached push it up so it is level with the mantel and lock it into place To lock it into place simply turn the horizontal wooden blocks attached to the underside of the mantel into a vertical position to support the we
5. the mantel pieces inside the box and l l damage the finish Check for the hardware bag which is red and located inside the packaging taped to the top box Be sure you DO NOT discard any pieces Step 1 Locate the base and place it on the floor Do not put it up against the wall at this point in the assembly as you need to get in behind the mantel to insert several wingnuts lock washers and firebox screws Step 2 Locate the left side panel and the left front panel Facing the front of the base take the left side panel positioning it so the holes in the blocks on the bottom line up with the holes on the base Position the left front panel next to the left side panel lining up the holes in the blocks with the holes on the base Attach the left front and side panel to the base by inserting and tightening 1 wingnut and 1 lock washer to each piece Attach the left side and front panels together by inserting and tightening 3 wingnuts and 3 lock washers Step 3 Repeat Step 2 but with the right side panel and the right front panel Step 4 Locate the lower facing panel and the firebox shelf Attach the lower facing panel by placing the granite side to the front then line up the holes on each side and insert 1 wingnut and 1 lock washer into each Place the firebox shelf in behind right up against the lower facing panel Step 5 Locate the granite upper facing panel that will be attached to the left and right legs and will sit above the fireb
6. ur mantel and your wall This device is a safety feature that will prevent your mantel from tipping over if a weight is applied which can unbalance the unit DE gt be VVARRANTY Greenvvay Home Products is pleased to offer in home vvarranty repairs Please refer to your Firebox Use and Care Guide for vvarranty information on your Firebox DO NOT RETURN THIS PRODUCT TO THE STORE Please contact Customer Service at 1 866 253 0447 Monday to Thursday from 8 30AM to 5 00PM EST Friday from 8 30AM to 4 00PM EST Web www greenwayhp com Email support greenwayhp com Canada 400 Southgate Dr Guelph Ontario Canada N1G 4P5 USA 6507 Fairfield Dr Northwood Ohio USA 43619 Limited Warranty Definitions Greenway Home Products Greenway Manufacturer Mantel Mantel manufactured by Greenway Home Products Purchaser Purchaser of the Mantel Distributor Facility authorized to sell Greenway Home Products Warranty Card Greenway Home Products Limited Warranty Registration Card identifying the Purchaser and product model Greenway Limited Warranty Greenway warrants to the Purchaser that the Mantel is free from defects in material and workmanship under normal use and service for 1 year 1 year limited parts from the date of purchase All warranty repairs must be preauthorized by Greenway Home Products Greenway will at its option replace or repair free of charge any defective part which the Purchaser shall notify th
7. utor as soon a problem exists The warranty repairs should be completed in a reasonable amount of time from the date of authorization Not to exceed 30 days past notification This limited warranty is expressly in lieu of any other expressed or implied warranty including any implied warranty or merchantability or fitness for a particular purpose and of any obligations or liabilities on Greenway Home Products which neither assumes nor authorizes any other person to assume for it any other liability in connection with the Mantel manufactured by it The warranty is null and void if used in commercial or industrial applications QD reenway Home Products
Download Pdf Manuals
Related Search