GE EAMD Installation Guide
Contents
1. 2 Tighten the 6 set screws to 18 26 inch lbs 2 3 Nm 3 Inspect installation to ensure fixture is secure screws be torqued to greater than 26 inch lbs INSTALLATION VERTICAL POLE MOUNTING This luminaire has been configured specifically to mount to a 2 inch pipe 2 3 8 OD 1 Place pole adaptor on 2 inch pole top 2 Tighten the 6 set screws to 18 26 inch lbs 2 3 Nm 3 Inspect installation to ensure fixture is secure These instructions do not purport to cover all details or variations in equipment nor to provide for every possible contingency to be met in connection with installation operation or maintenance Should further information be desired or should particular problems arise which are not covered sufficiently for the purchaser s purposes the matter should be referred to GE Lighting Solutions WIRING NOTE Make all electrical connections in accordance with the National Electrical Code and any applicable local code requirements Strain relief for incoming power must be provided in the pole top by customer Note Verify that supply voltage is correct by comparing it to name plate on fixture or carton Connect luminaire lead wires to supply wire Connections are to be made in interior of pole Connect black lead to L1 white lead to neu tral or L2 green lead to ground A wiring diagram is provided on a label inside luminaire for reference MAINTENANCE To maintain high efficiency of lens occasional2. cleaning outer lens sur face may be needed with frequency dependant on local conditions Use a mild soap or detergent which is essentially neutral pH pH ap proximately 6 to 8 non abrasive and which contains no chlorinated or aromatic hydrocarbons Wash thoroughly using a soft cloth Rinse with clean cold water and wipe dry GE Lighting Solutions 1 888 MY GE LED e www gelightingsolutions com 1 888 69 43 533 GE Lighting Solutions is a subsidiary of the General Electric Company Evolve and other trademarks belong to GE Lighting Solutions The GE brand and logo are trademarks of the General Electric Company 2011 GE Lighting Solutions Information provided is subject to change without notice All values are design or typical values when measured under laboratory conditions 35 201578 177 11 09
3. GEH 5985 GE INSTRUCTIONS Lighting Solutions GE Evolve LED Contemporary Domed Area Luminaire READ THOROUGHLY BEFORE INSTALLING SAVE THESE INSTRUCTIONS FOR FUTURE USE A WARNING Risk of electric shock e Turn power off before servicing See instructions GENERAL This luminaire is designed for outdoor lighting service and should not be used in areas of limited ventilation or in high ambient tempera tures Best results will be obtained if installed and maintained accord ing to the following recommendations Luminaire is designed to oper ate in ambient temperatures ranging from 40 C to 35 C and to be mounted horizontally with LED facing down as shown SPECIFICATIONS Weight 24 31 Ibs 11 14 kg EPA 0 97 Calculated using 0 81 Cd X Total Area of 1 21 ft IP Rating Optical 65 Standard Electrical Enclosure 44 UNPACKING This luminaire has been properly packed so that no parts should have been damaged during transit Inspect to confirm HANDLING Damage may occur if luminaire is improperly handled outside of pack Do not impact or stack luminaire after removal from packaging A WARNING Risk of Injury Unit will fall if not installed properly HORIZONTAL POLE MOUNTING e Follow installation instructions This luminaire has been configured specifically to mount to a 2 inch pipe 2 3 8 OD A WARNING 1 Place pole adaptor on 2 inch horizontal pole arm Under no circumstances should fixture mounting
Download Pdf Manuals
Related Search