GE 19214 User's Manual
Contents
1. Chime Tune Setting change the tune on the wired chime Wired Chime Installation Instructions for Wired Chime Front Door Dip Switch Power Requirement 16VAC 180mA maximum Rear Door Dip Switch 2 Select the desired chime sound from the table below Included hardware 1 Chime 4 Plastic screw anchors 4 4x25mm screws for anchors Chime Sound Table Required Tools Position 1 2 3 Wire stripper cutter small flat blade Westminster OFF OFF ON screwdriver Phillips screwdriver drill Ding Dong OFF ON OFF and drill bit 5 32 Knock ON OFF OFF Bronze Chime OFF ON ON Removing Front Cover Cuckoo Clock ON OFF ON The following instructions explain how to Foghorn ON ON OFF remove the front cover of the wired Gong ON ON ON chime 1 With the cover face down hold the front cover while sliding the back plate to the left 2 Using your finger gently pry up on the back cover plate The back plate with the paper product label should come away easily ON Switch On up OFF Switch Off down A WARNING Do not exceed 16VAC input to the chime Installation 1 Remove the cover from the old door chime disconnect the transformer and pushbutton wires label them for The following instructions explain how to 1 Remove the chime cover and locate the two 3 position dip switches shown below2. reference Remove the old chime 2 Install new chime a Remove the front cover from the chime b Pull the pushbutton and transformer wires through the slot in the base of chime c Mark the 4 holes using the base as a template with the arrow pointing up d If using the screw anchors drill 4 5 32 holes and insert the plastic screw anchors Otherwise drill a 3 64 pilot hole for the screws e Mount the chime base using the 4x25mm T f Attach the two wires from each pushbutton as shown in the wiring diagram For each push button one wire should be connected to the Common screw and one wire should be connected to the Front or Rear screw g Attach the wires from the chime transformer to the transformer connections as shown in the wiring diagram There is no polarity requirement h Slide the front cover on the back plate of the chime Rear Front Wiring Diagram Door Door Button Button Chime From 16V 4C Transformer For technical support contact Jasco Products Company at 1 800 654 8483 or www jascoproducts com Made in China Hecho en China is a trademark of General Electric oy and is used under license to Jasco Products Company LLC 10 E Memorial Road Oklahoma City OK 73114 www jascoproducts com Rev 08 13 08 19214 2
Download Pdf Manuals
Related Search