Fisher-Price J6982 User's Manual
Contents
1. WARNING To prevent serious injury or death from falls and being strangled in the restraint system e Fall Hazard It is dangerous to use this product on an elevated surface since child s movement may cause the product to slide or tip over Use only on a floor e Suffocation Hazard Never use on a soft surface bed sofa cushion since the product can tip over and cause suffoca tion in soft surfaces e Always use the restraint system e Not recommended for children who i Can sit up by themselves 6 months e Adjust the seat position for baby s comfort approximately until 9 kg 20 Ibs Lift the fabric skirt near the seat back of the frame o Never leave child unattended Upright Fasten the liner pad buckles Make sure you hear a click e Never use the toy bar as a handle Recline Unfasten the liner pad buckles Side to Side Head to Toe Swinging Direction Adjust the seat to change gliding motion to Side to Side or Head to Toe e Turn the seat for baby s comfort Securing Baby Restraint Belts 1 ay FIT LAN t fa ae _ Restraint Pad Place your child in the product Position the restraint pad between your child s legs e Fasten both restraint belts to the buckles on each side of the restraint pad Make sure you hear a click on both sides Check to be sure the restraint system is securely attached by pulling it away from your child The restraint syste2. the music switch to se Soothing S Playful O Off e Slide the volume switch to ai for low volume a for high volume Note Low battery power may cause this product to operate erratically no movement no sounds and the product may not turn off If this should happen remove and discard all batteries and replace with four new D LR20 alkaline batteries e Make sure your child is properly secured in the glider Grasp both handles as shown and lift Carefully carry the glider to another room Be sure to set the glider down only on the floor e The liner pad and headrest pad are machine washable Wash them separately in cold water on the gentle cycle Do not use bleach Tumble dry separately on low heat and remove promptly e The frame and toy bar may be wiped clean using a mild cleaning solution and a damp cloth Do not immerse the frame To remove the liner and headrest pad Feed the restraint belts back through the slots in headrest pad Pull to remove the headrest pad e Lift the fabric skirt near the footrest of the frame e Unfasten the liner pad buckles Pull to remove the liner pad bottom pocket from the footrest tube pull to remove the liner pad upper pocket from the seatback tube e To replace the pad refer to Assembly step 5 9
3. Tube Tighten and loosen all screws with a Phillips screwdriver Do not over tighten the screws Fastener Shown Actual Size Great Britain Mattel UK Ltd Vanwall Business Park Maidenhead SL6 4UB Helpline 01628 500303 www service mattel com uk Australia Mattel Australia Pty Ltd 658 Church Street Locked Bag 870 Richmond Victoria 3121 Australia Consumer Advisory Service 1300 135 312 New Zealand 16 18 William Pickering Drive Albany 1331 Auckland Asia Mattel East Asia Ltd Room 1106 South Tower World Finance Centre Harbour City Tsimshatsui HK China Malaysia Diimport amp Diedarkan Oleh Mattel SEA Ptd Ltd 993532 P Lot 13 5 13th Floor Menara Lien Hoe Persiaran Tropicana Golf Country Resort 47410 PJ Tel 03 78803817 Fax 03 78803867 2006 Mattel Inc All Rights Reserved and designate U S trademarks of Mattel Inc PRINTED IN CHINA Fisher Price Inc a subsidiary of Mattel Inc East Aurora New York 14052 U S A J6982a 0726 Battery Installation Assembly Hint We recommend using alkaline batteries for longer battery life 1 5V x 4 p LR20 qP e Loosen the screws in the battery compartment door and remove the battery compartment door e Insert four D LR20 alkaline batteries into the battery compartment e Replace the battery compartment door and tighten the screws e Low battery power may cause this product to operate erratically no movement no sounds and the prod
4. eded Never substitute parts Base Tubes e Lift both base tubes Position the hubs with the smooth side out e Fit the hubs onto the base tubes Hint The hubs are designed to fit the base tubes one way If the bubs do not fit on the base tubes check to be sure the smooth side is out Push the hubs down until you hear a click e Pull up on the hubs to be sure each is secure Assembly Position the pad onto the frame assembly The extra padded portion e Position the footrest tube so that it curves down shoud bedori ade Fit the ends of the footrest tube into the wide slots in the hubs e Position the seat back tube so that it curves down e Fit the ends of the seat back tube into the narrow slots in the hubs Seat Back Tube e Fit the upper pocket on the pad around the seat back tube e Insert a 8 x 3 2 cm screw into each hub and tighten Assembly Headrest Pad EPA CNIL Fit the lower pocket on the pad around the footrest tube Fasten the straps underneath the footrest tube to secure the lower portion of the pad Fit the restraint belts through the slots in the headrest pad Fit the headrest pad to the liner pad e Push down on the pad to be sure it is assembled properly If the pad falls through the frame you have not assembled it properly Please re read these instructions and re assemble the pad Fit the toy bar plugs into the frame sockets
5. m should remain attached Anchored End Anchored End To tighten the belts Feed the anchored end of the restraint up through the buckle to form a loop Pull the free end of the restraint Q To loosen the belts Feed the free end of the restraint up through the buckle to form a loop Enlarge the loop by pulling on the end of the loop toward the buckle Pull the anchored end of the restraint to shorten the free end of the belt O Please Note After adjusting the restraint system to fit your child make sure you pull on it to be sure it is securely fastened Starting Gliding Motion e Make sure your child is properly secured in the seat e Slide the power speed switch to slow fac or fast Hint In most cases the slow setting works best for a smaller child while the fast setting works best for a larger child If gliding stops while using the slow setting try the fast setting Give the seat a light push to start the gliding motion again Be sure to turn this product off when not in use Slide the power speed switch to the off setting O For best performance make sure this product is used on a completely level surface Note If gliding motion is slow in one direction and you hear a winding or grinding noise you may be using this product on an inclined surface Use this product only on a completely level surface Muse ___Rsom to Room Portability Choose the style of music for baby Slide
6. uct may not turn off If this should happen remove and discard all batteries and replace with four new D LR20 alkaline batteries Protect the environment by not disposing of this product with household waste 2002 96 EC Check your local authority for recycling advice and facilities Europe only Battery Safety Information In exceptional circumstances batteries may leak fluids that can cause a chemical burn injury or ruin your product To avoid battery leakage e Do not mix old and new batteries or batteries of different types alkaline standard carbon zinc or rechargeable nickel cadmium e Insert batteries as indicated inside the battery compartment e Remove batteries during long periods of non use Always remove exhausted batteries from the product Dispose of batteries safely Do not dispose of this product in a fire The batteries inside may explode or leak e Never short circuit the battery terminals e Use only batteries of the same or equivalent type as recommended Do not charge non rechargeable batteries e Remove rechargeable batteries from the product before charging e If removeable rechargeable batteries are used they are only to be charged under adult supervision IMPORTANT Before assembly and each use inspect this product for damaged hardware loose joints missing parts or sharp edges DO NOT use if any parts are missing or broken Contact Mattel for replacement parts and instructions if ne
7. www fisher price co uk Consumer Information IN IMPORTANTI Please remove all parts from the package and identifv them before assembiv Some parts mav be packed in WARNING the pad To prevent serious injury or death from falls and being strangled in the restraint system e Fall Hazard It is dangerous to use this product on an elevated surface since child s movement may cause the product Headrest Pad to slide or tip over Use only on a floor e Suffocation Hazard Never use on a soft surface bed sofa cushion since the product can tip over and cause suffoca tion in soft surfaces e Always use the restraint system e Not recommended for children who can sit up by themselves 6 months approxi mately until 9 kg 20 Ibs e Never leave child unattended e Never use the toy bar as a handle CAUTION This package contains small parts in Its unassembled State Adult assembly Toys may be different is required O IMPORTANTI Please keep these instructions for future reference 2 Hubs as thev contain important information e Please read these instructions before assembiv and use of this product e Use from birth until child becomes active and can climb out of the seat e Maximum weight 9 kg Adult assembly is required Parramn e Tool needed for assembly Phillips screwdriver not included Requires four D LR20 alkaline batteries not included 8 x 3 2 cm Screw 2 for operation Footrest
Download Pdf Manuals
Related Search