Fisher-Price H7185 User's Manual
Contents
1. SWINg Seat moves front to back Seat moves side to side WARNING IMPORTANT KEEP INSTRUCTIONS FOR FUTURE REFERENCE www fisher price co uk Consumer Information N WARNING To prevent serious injury and or falls and being strangled in the restraint system e Always use restraint system Never rely on the tray to restrain child e Not recommended for children who can sit up by themselves 6 months approximately until 9 kg 20 Ibs e Never leave child unattended e It is dangerous to use this product on an elevated surface CAUTION This product contains small parts in its unassembled state Adult assembly is required Care e Remove the tray from the seat e Unbuckle the restraint system e Remove the pad elastic loops from the pegs and unfasten the pad fasteners from the seat e Remove the pad from the restraint system e Machine wash the pad and toys in cold water with a mild detergent Do not use bleach Tumble dry on low heat and remove promptly e To clean the seat restraint system tray mobile storage pouch toys and motorized frame use a mild cleaning agent and damp cloth Rinse with clean water to remove residue e Periodically check the swing for loose fasteners or broken parts and tighten as needed e Please read these instructions before use of this swing e Adult assembly is required e Tools needed for assembly Allen Wrench included and Phillip2. slide switch to d Music 7 Waves s Rain Babbling Brook O Music and Sounds Off To select a comfortable listening setting turn the volume dial Oe e e o o4 Hint The waterglobe mobile music or sounds will turn off after approximately seven minutes To restart waterglobe mobile music or sounds press the reset button for another seven minutes of use Problems and Solutions Problem Motor is not running no swinging Motor is running but swinging Stops after a few minutes No difference noticed in Swinging motion after power dial is adjusted Swinging motion too high even at the lowest setting Waterglobe lights mobile music sounds do not work and swing is off Music sounds do not work and power dial is set to Waterglobe lights does not work and power dial is set to Mobile does not work and power dial is set to Probable Cause Power is not on Batteries incorrectly installed Dead batteries Need to start swinging motion Swing motion setting is inappropriate for child s weight Weak batteries Swing did not have sufficient time to adjust to different setting Weak batteries Normal operation Power dial is not on correct setting Dead batteries Waterglobe lights mobile music sounds turn off automatically after seven minutes Music sounds switch is in OFF O position Music sounds turn off automatically after seven minutes Mobile waterglobe switch is in OFF O
3. compartment door e Insert four LR20 D alkaline batteries e Replace the battery compartment door and tighten the screws with a Phillips screwdriver e Protect the environment by not disposing of this product with household waste 2002 96 EC Check your local authority for recycling advice and facilities Europe only WARNING To prevent serious injury and or falls and being strangled in the restraint system e Always use restraint system Never rely on the tray to restrain child e Not recommended for children who can sit up by themselves 6 months approximately until 9 kg 20 Ibs e Never leave child unattended e It is dangerous to use this product on an elevated surface Waist Belt Restraint Belts e Place your child in the seat e Pull the crotch belt up between your child s legs and fasten both waist belts to the crotch belt Make sure you hear a click on both sides Button a Button Anchored End i i i i i i Ly i Free End O poms gqneweeeeeee ay To tighten the waist belts e Feed the anchored end of the waist belt up through the buckle to form a loop Pull the free end of the waist belt O To loosen the waist belts e Feed the free end of the waist belt up through the buckle to a z o TSS Caa T ppa et ee en La e l k ana form a loop Enlarge the loop by pulling on the end of the e Firmly pull the legs outward Make
4. or sharp edges DO NOT use if any parts are missing or broken Contact Mattel for replacement parts and instructions if needed Never Substitute parts Lower Leg e Position a lower leg so that it stands on a flat surface as shown e Fit a foot onto the end of the lower leg e Insert a 8 x 1 3 cm screw through the bottom of the foot and into the lower leg Fully tighten the screw with the Allen wrench e Repeat this procedure to assemble the other foot to the other lower leg Red Dot Up Upper Leg Straight End Button Hole Lower Leg e Position an upper leg so that the red dot is up e While pressing the button on the straight end of an upper leg insert the upper leg into a lower leg Make sure the button on the upper leg snaps into the hole in the lower leg e Repeat this procedure to assemble the other upper leg to the other lower leg Button Holes Up e Position the fabric panel with the button holes up e Position the legs so that the feet are away from you e Slide the fabric panel onto the upper legs Rivet Through Button Hole Button Hole e Fit the rivets on the upper legs through the button holes in top ends of the fabric panel Motorized Frame Elbow Foot Button Red Dot e Locate the R and L on the underside of each elbow foot The R indicates the right leg The L indicates the left leg e While pressing the upper button on the right leg fit it into the tube in the motoriz
5. position or mobile only lt position Waterglobe lights mobile turn off automatically after seven minutes Mobile waterglobe lights switch is in OFF O position or waterglobe only position Mobile waterglobe lights turn off automatically after seven minutes Solution Turn the power dial to one of six settings Remove the batteries and replace in correct orientation as indicated inside the battery compartment Replace all four batteries with four fresh D alkaline batteries To start swinging motion give the seat a light push Adjust the power dial to a higher speed setting and give the seat a light push Replace all four batteries with four fresh D alkaline batteries Allow the swing time to adjust to new setting Replace all four batteries with four fresh D alkaline batteries To slow swinging motion place one end of a blanket underneath your child and let the other end drape down while swinging Position the power dial to the position Replace all four batteries with four fresh D alkaline batteries Press the reset button to restart waterglobe lights mobile music sounds for another seven minutes Slide music sounds switch to desired setting fp we g4 7 Press the reset button to restart music sounds for another seven minutes Slide mobile waterglobe lights switch to desired setting P Press the reset button to restart waterglobe lights mobile for another seven minutes Sli
6. sure the buttons snap loop toward the buckle Pull the anchored end of the waist into the notches in the motorized frame belt to shorten the free end of the waist belt O e Check to be sure the legs are locked into position by Note Check to be sure the restraint is securely attached by pushing the legs inward The legs should not move pulling it away from your child 4 PRESS 7 Seat Tube Button Seat Tube ENA os i rs x A _ i ET CO Using the Tray e Fit the tabs on the tray into the slots in the sides of the seat e To remove the tray pull one edge of the tray out and lift Button W You can adjust the motion of the swing side to side or front to back e Press the seat tube button to unlock the seat tube eer e Rotate the seat tube to the desired position I S ee 44 F 44 l 1 Lower Leg Button Cote SJe z a ka esa Aa gt ai T s gt Storage e Press the buttons on the back of the motorized frame while pushing the legs inward e Lean the swing frame against a wall for storage IMPORTANT Remove the batteries for long term storage of Seat Hint The legs may be disassembled for long term storage Press the button on each lower leg and remove them from the upper legs Press Seat Position Buttons You can adjust the seat to two different positions Recline or Upright e From behind the seat press both seat position buttons e Push
7. the seatback up until the buttons snap into the upright position e Push the seatback down until the buttons snap into the recline position Swing Waterglobe and Mobile Use Power Dial Swing Waterglobe Mobile ON Waterglobe Mobile ON oa Reset Button Mobile Waterglobe Music Sounds Switch Switch Volume Dial Swing e Turn the power dial to the ON position The swing begins swinging e Select any of six speed settings 7 gi e Be sure to turn swinging OFF O when not in use Hints e As with most battery powered swings a heavier child will reduce the amount of swinging motion on all settings In most cases the low setting works best for a smaller child while the high setting works best for a larger child o f the low setting provides too much swinging motion for your child try placing one end of a blanket underneath your child and let the other end of the blanket drape down while swinging Waterglobe Mobile Music and Sounds Turn the power dial to to turn power ON for waterglobe mobile music and sounds Hint The swing does not work on this power dial setting If you d like to use the waterglobe mobile music or sounds and swing at the same time turn the power dial to any of the six speed settings To select waterglobe mobile slide switch to Mobile X Lights Waterglobe Mobile and Lights Waterglobe O Mobile and Lights Waterglobe Off To select sounds or music
8. de mobile waterglobe lights switch to desired setting Press the reset button to restart mobile waterglobe lights for another seven minutes
9. ed frame Make sure the upper button on the right leg snaps into the hole in the tube e Repeat this procedure to assemble the left leg to the motorized frame e When the legs are assembled correctly to the tubes in the motorized frame you should not see the red dots Button e Stand the assembly upright e Pull the legs out so that the buttons snap into the holes in the motorized frame e When standing behind the product all four feet should be flat upon the floor And check for an L marking on the left foot and an R marking on the right foot e f the feet are not flat upon the floor or the left and right feet have been reversed remove both lower legs from the upper legs Replace them onto the opposite upper leg Ruffle e Position the seat upright e Place the pad onto the seat with the ruffle toward the top of the seat e Fold the bottom of the pad up Insert the crotch belt through the slot in the pad Make sure the crotch belt is not twisted Elastic Bottom View e Fold the top of the pad down e Insert the two elastic loops on the pad through the holes in the seat bottom e While holding the elastic loops in place turn the seat face down e Hook the elastic loop on the left side onto the peg on the right side e Hook the elastic loop on the right side onto the peg on the left side Hint The elastic loops should cross over each other when attached correctly to the pegs e Inser
10. s Screwdriver not included e Requires four LR20 D alkaline batteries for operation not included e Maximum Weight Limit 9 kg 20 Ibs IMPORTANT If your child weighs less than 9 kg 20 Ibs but is really active and appears to be able to climb out of the swing immediately discontinue its use e Product features and decorations may be different than shown in photos GREAT BRITAIN Mattel UK Ltd Vanwall Business Park Maidenhead SL6 4UB Helpline 01628 500303 www service mattel com uk AUSTRALIA Mattel Australia Pty Ltd 658 Church Street Locked Bag 870 Richmond Victoria 3121 Australia Consumer Advisory Service 1300 135 312 NEW ZEALAND 16 18 William Pickering Drive Aloany 1331 Auckland ASIA Mattel East Asia Ltd Room 1106 South Tower World Finance Centre Harbour City Tsimshatsul HK China MALAYSIA Diimport amp Diedarkan Oleh Mattel SEA Ptd Ltd 993532 P Lot 13 5 13th Floor Menara Lien Hoe Persiaran Tropicana Golf Country Resort 47410 PJ Tel 03 78803817 Fax 03 78803867 Motorized Frame __J Allen Wrench Fabric Panel Tray Pad with Headrest 2 Upper Legs Seat with Restraint System 2 Lower gt 2 Feet Note Tighten the screws with the enclosed Allen wrench Me E 8 x 1 3 cm Screw 2 M5 x 30 mm Bolt 2 M5 Lock Nut 2 ALL SHOWN ACTUAL SIZE IMPORTANT Before assembly inspect this product for damaged hardware loose joints missing parts
11. t the tray tabs into the slots in each side of the seat e Turn the seat upright e Fold the top of the pad down Insert the waist belts through the slots in the pad Make sure the waist belts are not twisted Lower Seat Tube e Fit the lower seat tube into the short tube on the seat back e Fit the pad edges around the rim of the seat e Hook the two fastener straps on each side of the pad onto the rim on each side of the seat Fisher Price Inc a subsidiary of Mattel Inc East Aurora NY 14052 U S A PRINTED IN CHINA 2007 Mattel Inc All Rights Reserved and designate U S trademarks of Mattel Inc H7185b 0726 e First fit an M5 lock nut into an opening in the short tube Make sure the rounded side of the lock nut faces out e Next insert an M5 x 30 mm screw through the opening in the opposite side of the short tube Fully tighten the screw with the Allen wrench e First fit an M5 lock nut into an opening in the upper seat tube Make sure the rounded side of the lock nut faces out e Next insert an M5 x 30 mm screw through the opening in the opposite side of the upper seat tube Fully tighten the screw with the Allen wrench Upper Seat Tube e Tip the assembly on it s side on a flat surface e Fit the lower seat tube into the upper seat tube e Turn the assembly upright e Fit the string below the knot of a toy through the slot in a clip on the mobile e Pull down on the toy to be sure it is sec
12. ure on the mobile e Repeat this procedure to assemble the other three toys to the mobile Battery Installation Battery Safety Information In exceptional circumstances batteries may leak fluids that Hint If the swinging motion becomes noticeably can cause a chemical burn injury or ruin your product Slower or sounds and lights become faint or stop To avoid battery leakage remove the batteries and replace them with four new e Do not mix old and new batteries or batteries of different LR20 D alkaline batteries Dispose of exhausted types alkaline standard carbon zinc or rechargeable batteries properly nickel cadmium e Insert batteries as indicated inside the battery compartment e Remove batteries during long periods of non use Always remove exhausted batteries from the product Dispose of batteries safely Do not dispose of product in a fire The 1 5V 7 batteries inside may explode or leak LR20 D e Never short circuit the battery terminals e Use only batteries of the same or equivalent type as recommended e Do not charge non rechargeable batteries e Remove rechargeable batteries from the product before charging e f removeable rechargeable batteries are used they are only to Battery Compartment Door be charged under adult supervision Hint We recommend using alkaline batteries for longer battery life e Loosen the screws in the battery compartment door with a Phillips screwdriver e Remove the battery
Download Pdf Manuals
Related Search