Fisher & Paykel HT90DBX1 User's Manual
Contents
1.2. Fisher amp Paykel Installation instructions and User guide GB IN Contents Safety and warnings Unpacking your wall canopy Preparing to install Installation instructions Operating your wall canopy Cleaning and maintenance Warranty and service Wiring diagram Important SAVE THESE INSTRUCTIONS The models shown in this User Guide may not be available in all markets and are subject to change at any time For current details about model and specification availability in your country please visit our local website listed on the back cover or contact your local Fisher amp Paykel dealer un dA 12 13 Safety and warnings L A WARNING Electrical Shock Hazard Always disconnect the appliance from the mains power supply before carrying out any maintenance or repairs Connection to a good earth wiring system is essential and mandatory Alterations to the domestic wiring system must only be made by a qualified electrician Failure to follow this advice may result in electrical shock or death A WARNING Weight Hazard The wall canopy is heavy Please ensure adequate care is taken when installing the wall canopy to prevent personal injury The wall canopy must be installed onto a solid wall stud beam or truss Weight of the product is 28 5 kg Important safety precautions To avoid hazard follow these instructions carefully before installing or using this appliance Please make
3. the building Exhaust air must not be discharged into an existing flue that is used for exhausting fumes from appliances burning gas or other fuels There must be adequate ventilation of the room when the wall canopy is used at the same time as appliances burning gas or other fuels A partial vacuum in the room could result in too high a concentration of gas in the air When the canopy is turned on at the same time as other appliances powered by energy other than electricity the air outlet must not be greater than 4 Pa 4x10 5 bar The minimum distance between the cooktop surface and the filters of the wall canopy shall be 600 mm or 650 mm if installed over a gas cooktop Stainless steel is very easily damaged during installation if abraded or knocked by tools It is recommended to protect the top of the canopy with cardboard or polystyrene during the installation to minimise the risk of damage occurring Safety and warnings L3 Children must be supervised to ensure that they do not play with the hood This canopy is not designed to be used by people including children with reduced physical sensorial or mental capacity or who lack experience or knowledge about it unless they have had supervision or instructions on how to use the hood by someone who is responsible for their safety You must read the details concerning the method and frequency of cleaning There is a fire risk if cleaning is not carried out in accordan
4. this information available to the person installing the appliance doing so could reduce your installation costs This appliance must be installed and connected to the mains power supply only by a suitably qualified person according to these installation instructions and in compliance with any applicable local building and electricity regulations Failure to install the appliance correctly could invalidate any warranty or liability claims N Safety and warnings If the power supply cable is damaged it must be replaced by the manufacturer its service agent or similarly qualified person in order to avoid a hazard To comply with electrical safety regulations this canopy must be connected to a socket near the appliance The socket must be accessible or have an accessible isolating switch to enable the end user to isolate the canopy from the power for the purpose of internal cleaning or maintenance A power outlet should be within 750 mm of the motor assembly and can be either on the wall behind the chimney or in the ceiling Always switch the power off prior to installation servicing or cleaning the wall canopy Ducting accessories are not supplied All ducting must comply with local requirements and building codes Before connecting any pipes consult municipal ordinances to ensure that any applicable regulations concerning the discharge of exhaust air are adhered to and request permission from the person in charge of
5. ce to be drilled is clear of any electrical cables or pipes etc The stainless steel and glass surfaces of the canopy are very easily damaged during installation if grazed or knocked by tools Please take care to protect the surfaces during installation Protect the cooktop surface below with cardboard or the like to prevent damage occurring whilst the wall canopy is being installed above The manufacturer shall not be liable for failure to observe all safety regulations in force for the correct and normal operation of electrical parts Ducting options Recirculation To recirculate your wall canopy please purchase a recirculation kit part no 791820 The recirculation kit is required to channel the air out through the side vents at the top of the flue Note a ducting hole is not required in the wall or ceiling if a recirculation kit is fitted Ducting For ducted installation it is recommended that you use 150 mm diameter rigid or semi rigid ducting This will require a 160 mm min round hole in the ceiling which the decorative chimney will cover Care should be taken to align the canopy with the decorative chimney allowing sufficient clearance to accommodate the ducting For optimal efficiency use smooth wall solid galvanized or plastic ducting for reduced noise and increased airflow Flexible ducting should only be used as a last resort ie in difficult installations and if used ensure that it is pulled tight The smoothe
6. ce with the instructions Never leave frying food unattended since grease can overheat and catch fire The risk of fire is even greater in the case of used oil Do not flamb under the wall canopy Never use the wall canopy without the filters in place During climatic conditions causing electrical interference it is possible that the device may stop working By switching the device OFF and ON the device will resume normal operation safety During an electrostatic discharge ESD it is possible that the device will stop working By switching the device OFF and ON the device will again work as intended There is no risk and no risk will appear nopy 4 Unpacking your wall ca Installation instructions L_5 Please read this instruction manual carefully in order to obtain the best results from the use of the wall canopy If you need any technical help or would like more information about our products please do not hesitate to contact your local Fisher amp Paykel retailer Preparing the wall canopy for installation Before installing your wall canopy Please read the instructions carefully Unpack the canopy and check that all functions are working Ensure that the voltage V and the frequency Hz indicated on the serial plate match the voltage and frequency at the installation site Check that the area behind the installation surfa
7. owing functions Filter cleaning alert indicator ref A Activated regularly as a reminder of the need to clean filters and deactivated with a single press Timer button ref B The fan will operate for 15 minutes before automatically turning off Light button ref C Turns the lights ON and OFF Press and hold button to adjust the level of light Power ON OFF ref D Fan speed buttons 1st 2nd 3rd and 4th speed Ref E Using the automatic timer To operate the automatic timer Select the fan speed Press the button for two seconds until the LED light blinks The timer will work for 5 minutes at the current speed and 5 minutes at each of the lower speeds until coming to a complete stop At the end of this time the motor will stop and the light will go out Fig 1 Touch control panel To cancel the timer press the timer button once and the motor will stop 10 Cleaning and maintenance Important Never use abrasive or oil based cleaners Maintenance Before performing any cleaning or maintenance on your wall canopy ensure that the power supply is switched OFF to the hood The wall canopy should be cleaned regularly using a mild liquid detergent to avoid a build up of grease occurring Grease deposits are corrosive which can damage to your wall canopy Note in areas of high humidity or coastal environments cleaning should be carried out frequently Aluminium filters Depending on
8. r straighter and shorter the ducting the quieter and more efficient the wall canopy will perform All ducting must comply with local requirements and building codes Installation instructions MIN 650 MIN 400 Installation instructions L_7 c ei c 2 CO 1 KG KG Ua er IN x 1 1 1 Operating your wall canopy L2 Touch control panel This panel is located on the front part of the hood and includes the foll
9. uminium filter 791761 Replacement light bulb 791822 N Warranty and service Before you call for service or assistance Check the things you can do yourself Refer to the installation instructions and your user guide and check that your product is correctly installed you are familiar with its normal operation If after checking these points you still need assistance please refer to the Service amp Warranty book for warranty details and your nearest Authorised Service Centre or contact us through our website listed on the back cover Product details Fisher amp Paykel Appliances Model Serial no Date of purchase Purchaser Dealer Suburb Town Country 13 Wiring diagram Switch Control VOLTAGE CONTROL SWITCH CAPACITOR MOTOR TC 220V 230V 240V 50Hz 64001585 64801590 JIN Blue Light Brown Light Fisher amp Paykel ner amp Paykel 2013 All rights reserved specifications in this booklet apply to the specific products described at the date of issue Under our policy of continuous nprovement these specifications may change at any time You therefore check with your Dealer to ensure this booklet correctly es the product currently available PN 590628A CATA PN 60812660 07 2013
10. use and at least once a month the aluminium grease filters should be removed and cleaned in a dishwasher or with hot soapy water If washed in a dishwasher the filters should be placed in an upright position to prevent food from falling on them After rinsing and drying replace the filters by reversing the following instruction for removal Note some discolouration of the frames may occur Removing the aluminium filters wn 4 Cleaning and maintenance Li Carbon filters Active carbon filters are disposable items designed to remove grease and odours from cooking vapours before the air is channelled back into the kitchen The active carbon filters must be replaced periodically to work properly at least once every three months depending on the frequency with which the wall canopy is used Fitting the carbon filter Replacing the light bulb Before changing the light bulb ensure the wall canopy is disconnected from the power supply Remove the aluminium grease filter refer to page 10 to see how to do this If canopy is in recirculation mode remove charcoal filter refer to fitting the carbon filter section above to see how Replace light bulbs with maximum 50 Watts Reinstall carbon filter if required and refit the aluminium filter Accessory Part number Recirculation kit 791820 Replacement carbon filter 791758 Replacement al
Download Pdf Manuals
Related Search