Extron electronic Low Profile Floor-Mount Raceway System for A/V Connectivity AVTrac User's Manual
Contents
1. AVTrac Connectivity Box Installation Guide Before installation of the AVTrac connectivity box the base track must already be installed For full information about AVTrac installation consult the AVTrac Installation Guide Install the connectivity box as follows 1 Remove the cover panel and end plates from the connectivity box One end has three mounting holes ea 3 Mounting Holes in the base the other has two The end with three UX holes faces toward the wall Align the end with lt SDN 2 Mounting Holes two mounting holes with the end of the base L S Nir track SS Sy z Se vo End Plate Mark where the holes in the bottom of the connectivity box lie over the base track and using a 1 4 metal bit not provided drill at least three holes through the track Using the provided masonry bit drill 5 32 diameter by 11 2 deep pilot holes into the concrete through the predrilled holes in the track Reposition the connectivity box in the correct orientation over the track the end of the box with three holes must face back toward the wall Using at least three of the provided 3 16 masonry screws secure the box to the track and floor Populate the lid of the box with the required Architectural Adapter Plates and AC power modules Run cabling as necessary and reattach the end plates and cover panel AVTrac Power Module Installation Guide Before installation of the AVTrac Power Module the AVTrac base2. 5 400 883 1568 971 4 2991800 Rev B From AVTrac AC 800 633 9876 Inside USA Canada Only Inside Europe Only Inside Asia Only 81 3 3511 7656 FAX Inside China Only 971 4 2991880 FAX 1108 Inside USA Canada Only Power Module einai 1 919 863 1794 31 33 453 4040 65 6383 4400 86 21 3760 1568 1 714 491 1500 1 919 863 1797 FAX 31 33 453 4050 FAX 65 6383 4664 FAX 86 21 3760 1566 FAX 1 714 491 1517 FAX
3. track and connectivity box must already be installed For full information about AVTrac installation consult the AVTrac Installation Guide Install the AC module as follows ed All electrical installation should be Module performed by qualified personnel in accordance with local and national electrical codes EZENN Switch off all electrical power before connecting the AC conduit to a junction box and keep power off until installation is complete To Main Circuit 1 Install the power module at the end of the connectivity box that is closest to the wall Slide the side tabs into the slots on the side of l White or Blue neutral the connectivity box and mount the power module on the stud s in the floor of the box see the figure above right Secure the module to the stud s by hand tightening the provided 6 32 nut s Black or Brown hot 2 Run the unattached end of the conduit and connect it to a convenient junction or Green circuit box see the figure at left Extron recommends that the junction box be or Green Yellow z ground directly wired to the main circuit AC Conduit 07g The module does not have a fuse and is rated at 15 A maximum for US modules and or Cable 10 A maximum for international modules t Extron USA West Extron USA East Extron Europe Extron Asia Extron Japan Extron China Extron Middle East 68 1617 01 Headquarters 800 633 9876 800 3987 6673 4800 7339 8766 81 3 3511 765
Download Pdf Manuals
Related Search