Electrolux ZSH730 User's Manual
Contents
1. LOW mark on the power cable shows the ideal cable length Do not extend the cable beyond the RED mark Press the ON OFF button to switch the appliance on On initial start up full power is reached after approximately 1 2 seconds To rewind the power cable press the rewind button with foot and guide the cable with hand to ensure that it does not whip causing damage By moving the variable power control the suction power can be adjusted MAINTENANCE REMOVING THE CONTENTS OF THE DUST CONTAINER Never operate the cleaner without the dust container installed It is quite normal for the dustbin indicator to activate whilst using the cleaner Therefore before you commence cleaning turn the cleaner on without the tools attached if the indicator is activated then check for dirty filters and clean if necessary 32 21 22 23 22 21 If the dustbin indicator is activated than firstly check the air inlet channel of the appliance If it is clogged by big pieces of paper dust hair or other materials then clean it If after cleaning the dustbin indicator stayes activated check the HEPA Remove the dust container from the cleaner Remove the filter set from the dust container by taking it in the way indicated in the icon Remove the contents of the dust container Put the filter set back into the dust container Put the dust container back into the cleaner CLEANING THE FILTERS Filters should be replaced at least twice a y2. aE oF Yor_ ZSH710 A Electrolux ZSH720 ZSH730 Vacuum cleaner Operating instructions Salome oF Yor_ A Electrolux 72Sx02 01 O1 ZSH710 ZSH720 ZSH730 l 7 M al Qe La BE N fig 3 10 14 Depending on the model 11 Thank you for choosing an Electrolux Cyclone Power vacuum cleaner These operating instructions cover all Cyclone Power models This means that with your specific model some accessories may not be included DESCRIPTION OF PARTS 4 Suction inlet 12 Dual purpose floor A nozzle 2 Dust container NESE 5 indicator 13 Combination crevice nozzle brush 3 Variable power x control 14 Upholstery nozzle 4 Cable rewind button 15 Hard floor nozzle 5 On off switch 16 Turbo nozzle 6 Wheel 17 Cartridge filter 7 Dust container 18 Protector mesh 8 Carrying handle 19 Parking position 9 Hose 10 Telescopic tube Depending on the model 11 Metal tubes IMPORTANT SAFEGUARDS Read this instruction booklet carefully Before using the appliance check that the mains power voltage corresponds to the voltage shown on the rating plate Do not switch the appliance on if it appears to be faulty in any way or it has a damaged cord or plug Do not try to repair the appliance by yourself For repairs and accessories we are at your service from Monday to Friday from 8am to 6pm Always remove the plug from the p
3. ear or when they become visibly soiled Disconnect from electrical outlet before changing the filters lt Menalux We care for homecare Pi Mii Uhi i Wilii W Wiss PTAA BSL 20 www menalux com H From the Electrolux Group
4. ower socket when the appliance is not in use and before carrying out any cleaning or maintenance operations Never leave the appliance unattended when it is switched on Keep the appliance out of reach of children This appliance is for domestic use only Use as described in this instruction booklet Do not pull the appliance by the cord Do not unplug by pulling on the cord Do not use the cleaner with a damaged cable If the cable damaged it should be replaced at a service center This is not covered by the warranty Do not use appliance on wet surfaces or to vacuum liquids mud ash and burning cigarette butts Do not vacuum up any highly flammable or explosive substances or gases These materials can cause serious damage to the motor a damage which is not covered by the warranty Do not unplug the vacuum cleaner with wet hands Do not operate the vacuum cleaner too close to heaters and radiators stoves etc 1 Before you start using the vacuum cleaner please remove large or sharp objects from the floor to prevent damage to the dust container and hose INSTRUCTIONS FOR USE 20 20 Before placing into operation make certain that the filters are in the proper position To connect the hose into the suction inlet push it until it clicks To disconnect the hose from the suction inlet push the button at the end of the hose Unwind a sufficient length of cable and insert the plug into the power socket A YEL
Download Pdf Manuals
Related Search