DVS 99000153 User's Manual
Contents
1. Blower DVS Ga amp erkshire Tree of Life Prairie Cedar 2001 Allegiance Part 99000153 CHECK CONDITION OF SHIPMENT Upon receipt of this kit check the condition of the packaging Damage to the package should be noted on the carrier s freight receipt Any damage claims as a result of shipping must be handled through the shipper Travis Industries will provide assistance in resolving shipping claims or replacing items not included in the package Please report any missing items immediately COMPATIBILITY e Lopi Berkshire e Tree of Life e Avalon Prairie e Avalon Cedar e Lopi Allegiance 2001 model ITEMS NEEDED FOR ASSEMBLY e 11 32 Socket Wrench e 1 4 Nutdriver e 1 2 Open End Wrench PACKING LIST e Blower Assembly e Wiring Harness e Thermodisk e Two Rubber Grommets with spacers e Two Nuts and Washers e Stud Plate e Rheostat with attachment nut amp lock washer e Rheostat Knob INSTALLATION INSTRUCTIONS WARNING Turn the gas control valve to off and make sure the appliance has fully cooled prior to conducting service 1 Attach the two black wires on the included wiring harness to the thermodisk orientation does not matter Then slide the thermodisk into the holder underneath the burner pan at the right rear of the stove All Models Except the Tree of Life and e Q DA Snap Disk Bracket 2007 Berkshire Oe ne attached to stove x gt Snap Disk Snap Disk Wires on Wiring Harness Black orientation does not2. e Part 99000153 3 Slide the left side of the blower mounting bracket over the grommets on the left mounting bracket attached to the stove see the illustration below Then insert the stud plate through the right side grommets and through the right mounting bracket on the stove Secure the stud plate with the included washers and nuts Make sure the bracket Left Mounting y slides into the groove on Bracket on the rubber grommets Right Mounting A Blower Mounting Grommet 9 of i Rubber 7 on stove Bracket Stud Plate ia Blower Mounting Bracket Stud Plate e Blower Mounting Bracket 11 32 Qe Socket Washer Cg Nut 4 Make sure all of the wiring is placed away from the blower impeller and the bottom of the burner Use lock ties if necessary to ensure no wires are damaged 1a Page 3 of 4 TRHOUSE OF FIRE 4070219 Blower DVS GAS erkshire Tree of Life Prairie Cedar 2001 Allegiance Part 99000153 5 Open the control cover following the directions below Remove the button plug and install the rheostat Loosen the two screws holding the control Attach the rheostat wires to the two NOTE make sure the box in place This allows access to the quick connects inside the control fiberglass heat shield is in back of the control box box orientation does not matter place when re attaching the control box all models except SB Control Box the cedar Phillips z Screwdriver Attach the rheos
3. matter Remove the snap disk cover plate below Attach the snap disk the burner on the left side when facing using the screws the stove from the front removed in step a oe i g Tree of Life and 2007 Berkshire Attach the wires g labeled snap disk to Snap Disk Wires the snap disk Black orientation does not matter 1a Page 1 of 4 TRHOUSE OF FIRE 4070219 Blower DVS GaS erkshire Tree of Life Prairie Cedar 2001 Allegiance Part 99000153 2 Place the blower near the rear of the stove Attach the wiring in grommets following the directions below Remove one of the screws holding the mounting bracket in place Insert the screw through the eyelet on the green ground wire and replace J 1 4 Nutdriver _ Attach the black and white wires B labeled Blower to the blower Y _ PA orientation does not matter oe g Route the wires labeled Valve on off and Solenoid under R the burner pan to a location Attach the molex connector YY near the gas control valve e gt Janorriit HESTOVE Attach the two wires leading gt lt Slide the rubber grommets with from the control box to the two spacers inserted inside onto the IN UNTIL INSTALLATION IS block wires labeled Rheostat fan mounting bracket COMPLETE 1a Page 2 of 4 TRHOUSE OF FIRE 4070219 Blower DVS GAS erkshire Tree of Life Prairie Cedar 2001 Allegianc
4. tat to the control panel with the included nut and star washer C 1 2 Wrench Rheostat Attach the knob NOTE this tab fits into the hole on the mounting bracket 6 If using the modulating remote thermostat attach the red and brown wires to the gas control valve Attach the red and brown wires to the top and bottom terminals on the gas control 7 Plug the blower in Let the heater achieve operating temperature and test blower operation w Page 4 of 4 TRHOUSE OF FIRE 4070219
Download Pdf Manuals
Related Search