Dixon ZTR 424 User's Manual
Contents
1. TECHNICAL DATA BROCHURE ZTR 424 IMPORTANT READ OPERATOR S MANUAL BEFORE OPERATION Deluxe Seat Adjustment Easy hand lever allows forward and back movement of seat No bolts to loosen or tighten Mower Blade Operation To start mower blades pull out on blade drive switch handle then lift to ON position To stop mower blades move switch handle to OFF position Body Removal 1 Disconnect throttle cable from engine 2 Disconnect the rear wiring loom P N 4191 from the body by lightly squeezing the Econo Seal plug This plug is located at the left rear of the body 3 Remove 4 control lever bolts and remove upper control levers P N 1689 amp T690 4 Remove the 2 attach nuts on floor of body and unfasten latch located at center of body at the rear 5 Place height adjustment lever in vertical position engage parking brake and carefully lift body up and off chassis 6 Reverse the above procedure for assembly safety Checks 1 After reassembly while on seat attempt to start engine with mower deck engaged Engine should not start If engine does start return to an authorized Dixon dealer for adjustment or repair 2 Disengage the mower deck and start the engine With operator in normal mowing position engage mower deck and remove weight from seat The engine should stop If engine does not stop when operator rises from seat return to an authorized Dixon dealer for adjustment or repair Parking Brake Adjustment Remove b2. ody as described above Adjustment points are located at rear of trans axle on each side Remove cotter pin from swivel fitting P N 2172 Turn swivel fitting on brake rod P N 5100 in to tighten just enough to prevent brake from slipping when engaged CAUTION Over tightening may cause premature wear on brake band P N 5085 Mower Drive Belt Adjustment No adjustment necessary the spring loaded idler pulley maintains proper tension throughout the belt life Removing Mower Deck 1 Remove mower deck drive belt P N 6111 by pulling idler assembly P N 1671 away from belt and remove belt from rear pulley 2 Remove 4 attach pins P N 6107 and clips from 4 mower deck attach points and 2 stabilizer bars P N 6159 3 Raise front of mower chassis and roll free of mower deck for service and or replacement 4 Tore install reverse the above procedure Removing Mower Cutter Blade secure mower cutter blade P N 6092 from turning observe blade position when removing remove blade bolt from center of blade DIXON DIXON INDUSTRIES INC BOX 484 COFFEYVILLE KANSAS 67337 316 251 2000 A A A _Z TA P N 8514 9 83 illustration Transaxle Assembly Models ZTR 424 426 fe Fi Psy SOOT i 5 438 SS ser Pes 4201 4194 RR MN e o A 407 4076 HEADLIGHT SSEMBLT T
Download Pdf Manuals
Related Search