Home
Digi Tech RV-7 User's Manual
Contents
1. OWNER DECLARATION OF CONFORMITY DigiTech 8760 S Sandy Parkway Sandy Utah 84070 USA Manufacturer s Name Manufacturer s Address declares that the product Product name HardWire RV 7 Product option All requires Class Il power adapter that conforms to the requirements of EN60065 EN60742 or equivalent conforms to the following Product Specifications Safety IEC 60065 7th ed 2001 EMC EN 55013 2001 A1 EN 55020 1998 Supplementary Information The product herewith complies with the requirements of the Low Voltage Directive 2006 95 EC and the EMC Directive 2004 108 EC Vice President of Engineering 8760 S Sandy Parkway Sandy Utah 84070 USA Date June 10 2008 European Contact Your local DigiTech Sales and Service Office or Harman Music Group 8760 South Sandy Parkway Sandy Utah 84070 USA Ph 801 566 8800 Fax 801 568 7583 Warning For your protection please read the following Important Safety Instructions Read these instructions 2 Keep these instructions 3 Heed all warnings 4 Do not use this apparatus near water 5 Clean only with dry cloth 6 Do not block any ventilation openings Install in accordance with the manufacturer s instructions 7 Do not install near any heat sources such as radiators heat registers stoves or other apparatus including amplifiers that produce heat 8 Protect the power cord from being walked on
2. Using the tip of a 1 4 guitar cable push one of the Release Pins in on either side of the Foot Switch and remove it from the pedal chassis Remove the battery from the battery compartment and disconnect the battery cable Connect a new battery to the battery cable and put it back in the bat tery compartment Make sure the battery cable does not interfere with the spring or pedal switch arm Place one hole of the Foot Switch over its corresponding pin Push the opposite pin in and lower the other side of the Foot Switch into place over the depressed pin Release the pin When the Foot Switch is properly fastened both release pins are flush with the outer side of the pedal Foot Switch 9VDC Battery Foot Switch Release Pin Ge Foot Switch d Release Pin d Pedal Chassis HardWire Performance Accessories The performance accessories make integrating a HardWire pedal into any pedal board a snap The following accessories are included e Hook and loop Pedalboard Pad designed to attach to the surfaces found on most commercial pedalboards e Foot Switch Glow Sticker easily visible on dark stages StompLock keeps your settings where you want them Hook and loop Pedalboard Pad To attach the Pedalboard Pad do the following l Peel off the existing rubber skid pad from the bottom of the pedal 2 Peel the adhesive protector from the back of the Pedalboard Pad 3 Apply the Pedalboard Pad
3. e Foot Switch Glow Sticker ook and loop Pedalboard Pad e Warranty card the signal tmost in What Does This Do Level Knob Controls the reverb level Turn this knob clockwise to increase and counter clockwise to decrease the reverb level 2 DC Adapter Jack Connect an optional Harman PS200R power supply to this jack Use the proper supply for your area s mains line voltage 3 Liveliness Knob Controls the amount of high frequency response in the Reverb s effect signal Turn this knob clockwise to increase and counter clockwise to decrease the high frequencies 4 Decay Knob Controls the length of time it takes for the Reverb to fade out Turn this knob clockwise to increase and counter clock wise to decrease the reverb decay time 5 Type Knob Selects one of 7 Lexicon reverbs ROOM fast decaying reverb great for a touch of ambience PLATE renowned studio reverb found on classic recordings REVERSE reverb in reverse quietly crescendos to full volume MODULATED lush modulating reverb ideal for chords GATED unique reverb with abrupt decay good for percussive playing HALL large encompassing reverb with warm decay SPRING classic surf reverb great for Rockabilly too Input Mono Connect your instrument the output of a pedal or an amp effects send to this jack Signals are heard
4. if the product is used with voltages outside of the range suggested by the manufacturer The foregoing is in lieu of all other warranties expressed or implied and DigiTech neither assumes nor authorizes any person to assume any obligation or liability in connection with the sale of this product In no event shall DigiTech or its dealers be liable for specia al or consequential damages or from any delay in the performance of this warranty due to causes beyond their control NOTE The information contained in this manual is subject to change at any time without notification Some information contained in this manual may also be inaccurate due to undocumented changes in the product or operating system since this version of the manual was completed The information contained in this version of the owner s manual supersedes all previous versions Introduction More than a remarkable achievement Hard Wire represents a co lection of significant improvements in effects pedals for guitar Hard Wire pedals pro vide a suite of well known effects each with superior tone and control But these pedals go above and beyond their peers providing such disti nguishing features as true bypass high voltage operation and true stereo processing with genuine Lexicon reverbs making them essential additions to chain of players who know about sound quality and demand the u performance Included Items ardWire RV 7 Stereo Reverb ardWire StompLock
5. bypassed When the Tails Switch is set ON the HardWire Stereo Reverb does not utilize true hardwire bypass If you always want to use true hardwire bypass set the Tails Switch to OFF When the Tails Switch is OFF reverb signal is cut off immediately when the effect is bypassed The Tai s Switch is located under the Foot Switch and is accessed by press ing in one of the Foot Switch Release Pins using the tip of a 1 4 guitar cable plug Once the Foot Switch is removed the Tails Switch is visible inside the chassis next to the button switch that turns the effect on and off Slide the switch to the left to turn Tails ON and to the right to turn Tails OFF O Tails Switch D O O ON OFF 41 Tails On Tails Off Amplifier Setup a PS200R optional RV 7 Stereo Reverb 6666 HardWire Effects Setup AMP RETURN PS200R optional AMP SEND Note If the amp effects loop has a mix control set the mix to 10076 full wet Battery Operation In the event that battery power is completely depleted Hard Wire pedals automatically switch into bypass This eliminates the need to remove the pedal from your pedal chain if the battery is dead To replace the battery do the following 2 3
6. to the bottom of the pedal Foot Switch Glow Sticker To attach the Foot Switch Glow Sticker do the following Peel the adhesive backing from the Foot Switch Glow Sticker 2 Apply the Glow Sticker to the top of the Foot Switch StompLock To place the StompLock over the pedal knobs do the following Setthe knobs to your preferred setting 2 Gently push the StompLock over the top of the knobs 3 To remove the StompLock gently lift one side and then the other Specifications Controls Level Liveliness Decay On Off Pedal Jacks Input Mono Input 2 Output Mono Output 2 Input Impedance gt MQ stereo 2500 kQ mono effect on Output Impedance kQ effect on Input Impedance true hardwire bypass effect off Output Impedance true hardwire bypass effect off Power Supply 9V Alkaline Dry Battery or Harman PS200R 9V DC power supply Current Draw 75 mA typical at 9V DC Power Consumption 6 5 mW typical w optional PS200R power supply Dimensions 5 25 L x 3 5 W x 2 15 H Weight 1 3 lbs Optional Power Supply PS200R 100 100V 50 60Hz PS200R 120 120V 60 PS200R 230 230V 50 16 PS200R 240 240V 50 2 2 z HardWire EXTREME PERFORMANCE PEDALS 8760 South Sandy Parkway Sandy Utah 84070 PH 801 566 8800 FAX 801 566 7005 HardWire and DigiTech are trademarks of the Harman Music Group Inc Copyright Harma
7. at both out puts when only the Input Mono jack is used This jack enables battery power to the pedal when connected To prolong battery life disconnect the cable from the Input Mono jack when not in use If the optional Harman PS200R power supply is used cables can remain connected Input 2 Connect a second input to this jack for stereo operation Inputs and 2 are processed separately through the Stereo Reverb effect then fed to Outputs and 2 keeping true stereo separation between channels 8 Foot Switch Release Pins These two pins are spring loaded hinges that hold the Foot Switch in place See page 10 for informa tion on accessing and changing the battery See page 6 for more information about using and changing the Tails Switch settings 9 Indicator LED Lights when the effect is turned on When bat tery power is low approximately 5 minutes the Indicator LED begins to dim giving you advanced warning that very shortly you will need to replace the battery 10 Foot Switch Turns the effect on and off Il Output I Mono Connect this output to the input of a single guitar amplifier or amp effects return 12 Output 2 Connect this output to the input of a second guitar amplifier when a second amp is being used Note Use unbalanced mono instrument cables only Tails Switch The HardWire Stereo Reverb features a switch that allows the reverb signal to continue being heard after the effect is
8. ing and thus prevent potential negative effects on the environment and human health WARRANTY We at DigiTech are proud of our products and back up each one with the following warranty The warranty registration card must be mailed within ten days after purchase date to validate this warranty DigiTech warrants this product when used solely within the U S to be free from defects in materials and workmanship under normal use and service DigiTech liability under this warranty is limited to repairing or re lacin defective materials that show evidence of defect provided the product is returned to DigiTech WITH RETURN AUTHORIZATION where all parts and labor will be covered up to a period of one year this warranty is extended to a of six years when the product has been properly registered by mail or through our website A Return Authorization number may be obtained from DigiTech by telephone The company shall not be liable for any consequential damage as a result of the product s use in any circuit or assembly Proof of purchase is considered to be the burden of the consumer DigiTech reserves the right to make changes in design or make additions to or improvements upon this product without incurring any obligation to install the same on products previously manufactured The consumer forfeits the benefits of this warranty if the product s main assembly is opened and tampered with by anyone other than a certified DigiTech technician or
9. n Music Group Manufactured in the USA HardWire RV 7 Owners Manual 18 0488 Please visit us on the World Wide Web at www digitech com
10. or pinched particularly at plugs convenience receptacles and the point where they exit from the apparatus 9 Unplug this apparatus during lightning storms or when unused for long periods of time 10 No user serviceable parts inside Refer all servicing to qualified service personnel Servicing is required when the apparatus has been damaged in any way such as power supply cord or plug is damaged liquid has been spilled or objects have fallen into the apparatus the apparatus has been exposed to rain or moisture does not operate normally or has been dropped 11 WARNING To reduce the risk of fire or electric shock do not expose this apparatus to rain or moisture 12 Refer to labels on the unit including bottom cover or other markings and pertinent information If you want to dispose of this product do not mix it with general household waste There is a separate collection system for used electronic products in accordance with legislation that requires proper treatment recovery and recycling Private household in the 25 member states of the EU in Switzerland and Norway may return their used electronic product free of charge to designated collection facilities or to a retailer if you purchase a similar new one For Countries not mentioned above please contact your local authorities for a correct method of disposal By doing so you will ensure that your disposed product undergoes the necessary treatment recovery and recycl
Download Pdf Manuals
Related Search
Related Contents
ドラッグ&ドロップ対応 USB2.0リンクケーブル取扱説明書 User Manual Manuale Tecnico IT Technical Manual Kenroy Home 93089COP Installation Guide Christie H Series Brochure Mode d`emploi Thermomètre radio-piloté Venus 14208 Agilent OpenLAB クロマトデータシステム(CDS) Copyright © All rights reserved.
Failed to retrieve file