De'Longhi SDH2000 User's Manual
Contents
1. on given u or instruction concerning the use of the appliance by a person Fe for their safety Young children should be supervised to ensure that they do not play with the appliance Position the appliance in such a way that the plug and socket are easily accessible even after installation Do not use the appliance in rooms with a surface area of less than 4 m The appliance is fitted with a tip over switch fig 3 which turns the appliance off if it falls over To restart the appliance simply place it upright again Do not locate the heater immediately below the GPO socket outlet A safety device shuts the radiator down in the case of accidental overheating To reset unplug the appliance from the mains socket for a few minutes remove the cause of overheating then plug in again Warning In order to avoid overheating do not cover Important never under any circumstances cover the apne during operation as this would lead to dangerous overheating of the appliance itself 1121006IDL 03 082. remote control is not available The MODE button can only be used to select the power level MIN MED MAX Both sides are active 3 TABLE OF POWERS Power levels Med _ M Max sanii Min ae d e Select the operating mode using the Z and _ buttons on the remote control The lt gt button selects the radiating side you want to activate front side active e back side active a front and back sides active gt OPERATION The 22 button selects the required radiating power a MIN T a eu MED i _ T MAX Use the and buttons to set the comfort temperature The F C button selects the preferred temperature scale The ON STAND BY button switches the appliance from STAND BY to ON and viceversa Press the button to activate the frost prevention function This function keeps automatically the room at a room temperature of 7 C ASF Count Down TIMER Delayed shutdown turns the appliance off automatically at the set time To programme press the TIMER button The display shows the preset time or the time set previously Use the or buttons to set the time you want the appliance to go off Confirm by pressing the OK button TIMER OFF is displayed To deactivate programmed shutdown press the TIMER button twice or the CANCEL button 4 MAINTENANCE Before carrying out maintenance always unplug from the mains and wait for the appliance t
3. ELECTRIC RADIATOR ECLIPSE Instructions for use SDH2000 ON STAND BY button MODE button selects modes fig 1 Remote control receiver TOS tip over switch Main switch fig 2 OPERATION AND USE OF THE ELECTRIC RADIATOR Thank you for choosing a electric radiator For best results and maximum safety read these instructions carefully before using the radiator Use the appliance for domestic use only ELECTRICAL CONNECTIONS Before plugging the appliance into the mains socket check that e the mains power supply corresponds to the value indicated on the rating plate on the back of the appliance e the power socket and electrical circuit are adequate for the appliance e the mains socket matches the plug If this is not the case have the plug replaced e the mains socket is adequately earthed Failure to follow these important safety instructions absolves the manufacturer of all liability 1 GENERAL INSTRUCTIONS e The appliance can be operated from either the control panel or the remo te control From the control panel only the mains functions are available while on the remote control all functions are available e To start the appliance open the door at the back see fig 2 and turn the main switch on is displayed NB This replaces the time display until the appliance receives a signal from the remote control After this the time set on the remote control is displayed e Pres
4. o cool own This radiator requires no particular maintenance Simply dust with a soft dry cloth Never use abrasive powders or solvents If necessary remove accumulations of dirt using a vacuum cleaner 5 IMPORTANT SAFEGUARDS When you turn the appliance on for the first time operate it at maximum for at least two hours During this time you should ventilate the room to Mi the new smell given off It is nor mal for the appliance to make squeaking noises when first turned on Never use the radiator near baths sinks showers or swimming pools Never use the radiator to dry laundry Never lay the power cable on top of the radiator when it is hot Use the radiator in a vertical position only IF the power cable is damaged it must be replaced by the manufacturer an authorised technical service centre or qualified personnel in order to avoid all risk You are recommended to keep the appliance out of draughts as they could reduce efficiency Prolonged use is not recommended as the radiator could overheat As with all electrical appliances the instructions aim to cover the largest possible number of situa tions Caution and common sense should nevertheless be used when operating the appliance particularly in the presence of children This appliance is not intended for use by persons including children with reduced physical sen sory or mental capabilities or lack of experience and knowledge unless they have
5. s the ON STAND BY button on the control panel or on the remote control to start the appliance on The appliance can now be operated u from either the control panel or the remote control 2 OPERATION FROM THE REMOTE CONTROL INSERTING OR REPLACING THE BATTERIES e Remove the cover on the rear of the remote control e Insert two RO3 AAA 1 5V batteries in the correct position see instruc tions inside the battery compartment e Put the cover back in place NB If the remote control unit is replaced or disposed of the batteries must be removed and disposed of in accordance with current legislation as they are harmful to the envi ronment SETTING THE TIME e When the batteries are inserted the time display starts flashing Use the and buttons until the required time is displayed Press the or buttons and hold them down to run through the minu tes and hours quickly e To confirm the selected time press the OK button When the first command is transmitted from the remote control the time set on the remote control is shown also on the appliance display e When setting the current time the time can be zeroed quickly by pressing the CANCEL button e The 12 24h button selects the way the time is displayed on the clock and timer 3 OPERATING FROM THE CONTROL PANEL Bobs STAND BY BUTTON turns the appliance on in the last mode set or in stand by awaiting com mands MODE BUTTON enables the appliance to be used when the
Download Pdf Manuals
Related Search