Craftsman 2 Jaw Large Gear Puller Instruction Manual
Contents
1. 2 Arm 7 Ton Gear Puller Instructions Assembly required 1 Wear appropriate eye protection Assemble the puller to satisfy reach and spread requirements a Arms can be swapped end to end and tip can be in or out depending on the job requirements b Reach can be modified by using any of the three holes in the arms c Make sure that the same gripping ends are used on both arms and the same holes are used on both arms 3 Adjust the nuts on the linking arms to allow free movement for the arms 4 Place puller over the part to be pulled and tighten the center pressure screw checking that the gripping surfaces are seated properly and the jaws are parallel with the screw 5 Tighten the center pressure screw until the parts is pulled yy sz Body gt gt gt o 7 gt gt gt gt gt gt gt 7 NOTES e Do NOT exert pressure over the stated capacity of the puller e Do NOT modify the puller in any way e Do NOT use power tools on gear pullers e Lubricate the pressure screw before initial use and then lubricate regularly e Inspect the entire tool for damage before each use do not use if damaged e The black oxide finish as provided on the screw and body may leave a dark residue on hands and clothing when new
Download Pdf Manuals
Related Search