Cornelius P/N 3626 User's Manual
Contents
1. IMI CORNELIUS INC Gz A One Cornelius Place ozel LS Anoka MN 55303 6234 3 Telephone 800 238 3600 Facsimile 612 422 3246 INSTALLATION INSTRUCTION UNIVERSAL 750 ICE BANK CONTROL KIT P N 3626 Step One A Remove the product lines and white washers C Remove the agitator motor Unscrew the hex Clip all poly ties nuts and screws holding the plate down Re move the plate B Unscrew the control box Disconnect the cord D Disconnect the tubes to the valves Raise the and agitator motor electrical leads Lay the basket and remove the ice bank control holder control box over the side of the unit by bending the top brackets 8 25 94 1 P N 185211007 Step Two B B Ice Bank Control gt T A P N 33 5794 000 Aa JE C 1 e FU a J Red Lead yp lt Black Lead P N 3576 E P N 3575 A Snap the new ice bank control bulb holder C Connect the red and black wire leads to the ice P N 3529 onto the second and third coil from bank control as shown the top B Place the ice bank control bulb into the holder and secure it with two poly ties P N 040056 000 Replace the basket and hook up the tubes to the valves P N 185211007 2 8 25 94 Step Three L H Bracket R H Bracket ea P N 3532 P N 3531 1 16 S G Dies Heat Sink Plates a Ml eae aca S O O Ice Ba2. nk Control relative to agitator motor angle 8 25 94 Apply the Warning Decal A to the plate Place the plate in the unit with the decal on the right hand side Tighten the plate to the basket with the hex nuts Apply the three screws to each side Remove the agitator fan blade Slide the rubber slinger off the shaft Remove the heat sink plates and remove the cover Replace the slinger onto the motor shaft While the shaft is being pushed up into the motor adjust the slinger to 1 16 clearance from the motor base Apply heat sink compound P N 000113 734 between the brackets G heat sink plates and the agitator motor and assemble these parts as shown Place the agitator motor assembly into the plate with the angle away from the ice bank control bulb Mark the mounting holes H using the bracket as a template Drill the four holes with a 29 drill bit Place heat sink compound between the bracket and the plate and screw in place Route the agitator motor electrical leads through the left rear hole in the plate P N 185211007 Step Four e Reconnect all product tubing Be sure the tapered white nylon washers are in place e Route the tubing through the back hole of the panel and tie in place e Apply the DANGER decal to the top of the control box e Snap the grommet and the snap bushing into the holes of the control box as shown e Place the ice bank control in the control box with the capillar
3. y tube going through the grommet Screw the ice bank control in place e Route the agitator motor electrical leads and the electrical cord through the snap bushing e Connect all wiring as shown e When connecting ground leads be sure to attach power cord ground lead first then apply a nut and tighten Then apply the ground lead from the agita tor motor and then the final nut Tighten securely Capillary Tube Agitator Motor Wire Grommet smooth S ZNANA Green Ground wire Agitator Motor Red Jumper Wire s J T T Black CN A i Bush Jumper Wire lt gt _ lt S Snap Bushing E Agitator Motor Wire Ribbed Qo NS ON Red Wire f Gray Power Cord Black Wire White Wire Green Ground Wire Gray Power Cord Gray Power Cord Power Cord Secure first to Control box P N 185211007 4 8 25 94
Download Pdf Manuals
Related Search