Cooper Lighting RKD-148SL-10B User's Manual
Contents
1. RKD 148SL 10B amp RKD 148HO 10B Installation Instructions Installation instructions for converting two lamp or more industrial and strip type fluorescent fixtures to Slimline and High Output single lamp 48 reflectorized fluorescent fixtures Contents h WARNING Risk of fire or electrical shock Reflector kit installation requires knowledge of fluorescent lighting 1 48 1 2 reflector l fixture electrical systems If not qualified do not attempt installation Contact a qualified electrician 1 40 steal channel cover WARNING To prevent wiring damage or abrasion do not expose wiring to edges of sheet metal or other sharp 2 800 URS socket brackets A objects Reflector kit is not intended to be used for damp or wet locations 4 8 TEK screws Ea WARNING Risk of fire or electrical shock Fixture wiring battast or other electrical parts may be damaged when 2 955 SL 951 HO lamp holders sockets A drilling for installation of reflector kit hardware Check for enclosed wiring and components 2 quarter turn fasteners 2 self tapping loc screws WARNING Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation 2 wire connectors Selecting a ballast When selecting a Optional RAD E ballast the following considerations should 44 4 end of fixture row 7 Using steel channel cover as a be made Use only UL Listed Class P channel socket cover2. ram printed on the ballast label 11 Remove protective film coaling and install lamps 6 Beginning at one end of the channel install appropriate pre wired socket into first 800 URS bracket Using 8 TEK screws attach the bracket flush with the end of the fixture channel 12 Re connect power Note Dimensions and specifications subject to change without notice 5 Install ballast with sockets id attached to leads into channel Make pac PPY ae quarter turn 8 TEK self tapping mais Lil tastener screw loc screw 041293 Cooper Lighting METALUX P O Box 1207 Americus Georgia 31709 912 924 8000 Fax 912 924 5507
3. s and spacing jig place opposite bracket in RKD R row mount socket covers can be installed as shown Note When converting an 8 section of fixture feed the remaining two pre D wired 950 951 sockets above the bracket Repeat steps 6 and 7 placing center two brackets back to place and attach with 8 TEK screws Spacing between brackets is 40 thermally protected ballast It should be suitable for lamps lamp holders type It should not exceed voltage and wattage rating Ballast leads should be of proper wt SER length to avoid splicing Primary voltage of ballast should be selected according to supply source voltage 1 Disconnect Power steel channel cover 8 Using self taping loc screws attach reflector to the steel channel cover 2 Remove and discard lamps existing channel covers socket brackets and ballast Retain only a bare channel and channel end caps Please dispose of lamps and ballast properly and recycle if possible 9 Snap quarter turn fasteners into holes at each end of the reflector 10 Attach reflector and steel channel cover to the socket brackets using slots in brackets 3 With bare channel now begin installation of new retrofit kit 4 Prewire lamp holders sockets Insert lamp wire leads of new ballast into 950 951 socket wire terminals This should be completed according to the ballast manufacturer s wiring diag
Download Pdf Manuals
Related Search