Cooper Lighting Halo L1763 User's Manual
Contents
1. Nee RE INSTALLATION INSTRUCTIONS FOR L1763 L2771 AND L2740 LAMPHOLDERS FOR USE WITH HALO TRACK SYSTEMS ONLY TO ADJUST HALO 2 SERIES LAMPHOLDER Halo 2 Lampholders can be used with Halo Miniature or Halo 2 Power Trac systems An adjustable contact allows you to select the circuit position Use a narrow bade screwdriver as Shown to adjust the contact Lift or lower the contact until it touches the plastic stop of the contact assembly For circuit 1 move contact to the down position For circuit 2 move contact to the up position Figure 1 TO USE HALO 2 LAMPHOLDER WITH MINIATURE POWER TRAC When using Halo 2 Lampholder with the Miniature Power Trac System L650 L651 L652 L653 adjustable contact must be in 1 DOWN position Figure 2 FIGURE 4 Mounting Adapter TO USE HALO 2 LAMPHOLDER WITH HALO 2 POWER TRAC When using Halo 2 Lampholder with the Halo 2 Power Trac System L640 1641 L642 L643 adjust the contact position of each lampholcer to the desired circut circuit 1 DOWN oF to circuit 2 UP Figure 2 3 TO INSTALL LAMPHOLDER Hold lampholder by the mounting adapter Insert contact head into Halo Power Trac Twist mounting adapter approximately Y4 turn 09 until mounting sieeve tab locks into Power Trac opening Figure 4 NOTE Forcing mounting adapter in wrong direction may damage the contact assernbly If mounting adapter will not turn easily twist adaptar in opposite direction Polarity2. amphoiders should not be installed in such a manner a9 to entrap excessive ambient heat around the fixture such as enclosed display windows showcases alcoves recessed coves etc Lamps Some 12V MR16 lamps are not compatib e with Halo Power Trac famphoidera Consut your local Halo representative for further information on dimming installation or tamp compatibility PER eee imme IL 60007 698500 Cooper Lighting Male 400 Busse Read Elk Grove Vilage iL 60007 698500
3. line on adapter must align with polanity line on Power Trac for proper installation Figure 5 TO REMOVE LAMPHOLDER Pull dawn on mounting adapter sieeve until tab is free of Power Trac channel opening Twist mounting adapter Ya turn 909 unti contact head is free and remove lamphoider from track Figure 6 h E900 Cooper Lighting Halo 400 Busse Road Elk Grove Village i 80007 6935C l2 ee _ RELAMPING INSTRUCTIONS FOR L1763 L2771 AND L2740 LAMPHOLDERS WARNING Before working on Power Trac fixture be sure to tum off AC power or remove fidure from Trac STEP 1 Allow uni to cool and then remove kom Trac Agura 1 STEP 2 Remove face plate assembly by pulling away from housing Figure 2 STEP 3 Unplug lamp by pulling straight out DO NOT TWIST Refer to relamp label on fixture for proper lamp Do not touch the MA16 bulb inside lamp reflector Figure 3 STEP 4 Place lamp back in socket STEP 5 Accepts L200 Accessory Baffle to reduce glare and spill light To instali Accessory Baffie slide iens out fom under springs drop baffle in place and raplace lens Figure 4 CAUTION Co not operate unit without lens in place LOW VOLTAGE CAUTIONS Dimmin Dimming quartz halogen tamps e 9 MR16 may reduce lamp life Low voltage lampholders with solid state or magnetic improper dimmer may cause damage to the transformer and shorten lamp ifa Consult factory for dimmer recommendations installation Low voltage l
Download Pdf Manuals
Related Search