Cooper Lighting BCVE User's Manual
Contents
1. CHARLESTON GRAPHICS INC 1961 0817 1274 INSTALLATION INSTRUCTIONS IMPORTANT Read carefully before installing fixture Retain for future reference BC BW BWVE BCVE BCHE BWHE SERIES LUMINAIRES INCANDESCENT AND COMPACT FLUORESCENT 6 93 IMI 313 General Upon receipt of fixture thoroughly inspect for any freight damage which should be brought to the attention of the delivering carrier Compare the catalog description listed on the packing slip with the fixture label on the housing to assure you have received the correct merchandise Safety This fixture must be wired in accordance with the National Electrical Code and applicable local codes and ordinances Proper grounding is required to insure personal safety Carefully observe grounding procedure under installation section All work should be done by a qualified electrician WARNING Make certain power is OFF before starting installation or attempting any maintenance CLEANING The reflector and lens may be cleaned with any non abrasive cloth and mild detergent i e 409 Cleaner Cleaning should be done on the lens at room temperature and out of direct sunlight To remove paint lipstick marker etc the following solvents may be used RECOMMENDED a solution of three 3 parts alcohol one 1 part TOLUOL OR four 4 parts alcohol one part Methylethylketone MEK Also safe but less effective Naphtha Butyl Cellosolve Kerosene NEVER USE Gasolin2. e Benzene Acetone Carbon Tetrachloride or highly alkaline cleaners Never clean Luminaire while energized or while lens is hot WARNING If the lens has a Factory applied trim color these solvents will also remove this paint Replacement of the entire lens is recommended in this case Remove the four 5 10 knock outs Make wiring connections OO Rs GD on the back wall side of the plate Remove lens using a torx screwdriver for screws with center pin Determine correct fasteners to use for the mounting surface Fasteners should be 1 4 normal The mounting gasket may be used as a template to lay out the fastener locations Place two of the mounting screws through the mounting plate and position the mounting gasket into position 7 Position mounting plate on wall in one of the UP orientations according to the embossed arrows on the mounting plate Check position of internal reflector if equipped see Note 8 Start mounting fasteners but do not tighten 9 Check the gasket position At least 1 4 of gasket should extend beyond the mounting plate all the way around 10 Tighten all four mounting fasteners 11 Install lamp Screw base lamps should be tightened then loosened one to two turns then re tightened This will properly seat the lamp for best mechanical and electrical connection 12 Replace lens tighten screws NOTE For optional Internal Reflectors If the fixture has a ref
3. lector attached to the mounting plate it should be positioned above the lamp If the lens has a portion Painted Out to form an Eyelid this portion should be positioned toward the ceiling and over the internal reflector COOPER Cooper Lighting These instructions do not claim to cover all details or variations in the equipment procedure or process described nor to provide directions for meeting every possible contingency during installation operation or maintenance When additional information is desired to satisfy a problem not covered sufficiently for user s purpose please contact your nearest representative CHARLESTON GRAPHICS INC 1961 0817 1274 Photoelectric Control A Photoelectric Control may be added by first obtaining the following accessories from your Cooper Lighting Distributor Surface Conduit Box CAT SCB Photocell Kit CAT PB 120V OR PB 277V Follow the instructions provided with the kit installing the photocell in an unused conduit entry location which positioned the Photocell in a horizontal orientation
Download Pdf Manuals
Related Search