Command Communications 605 User's Manual
Contents
1. For Technical Support Call our Technical Service Department Monday through Friday 9 a m to 5 p m EST 1 800 TEC TOYS or 1 800 832 8697 customer_support enablingdevices com Switch Modifier 605 USER S GUIDE Enabling Devices 385 Warburton Avenue Hastings on Hudson NY 10706 Tel 914 478 0960 Fax 914 478 7030 www enablingdevices com Now with intention This ingenious box turns any momentary switch into a latch or timed switch We ve added an intention adjustment which requires the user to hold the switch for a specific amount of time 1 15 seconds before the device is triggered Great for those with uncontrolled movements or tremors Once the intention time is set choose momentary latch or timed modes In the momentary mode your toy or device will stay on as long as you maintain pressure on the switch In the latch mode your device will turn on when the switch is pressed once and will turn off when the switch is pressed again In timed mode your toy or device will stay on for a preset amount of time 0 to 120 seconds The time can be adjusted from 0 120 seconds by turning a knob Size 442 x 242 x 1 Requires 1 9 V Battery OPERATION 1 Carefully turn the switch s control box over to reveal the battery compartment cover Slide the battery cover off and install one 9 Volt battery Please use alkaline batteries only e g Duracell Energizer Brands Do not use rechargeable or non alkaline type batteries as they2. battery Action 2 Make sure all connections between the Switch Modifier and your Toy Device are tight There should be no gaps Action 3 Check your Toy Device with another switch to rule the Switch Modifier out as the source of the problem Care of Unit The switch Modifier can be wiped clean with any household multi purpose cleaner and disinfectant We recommend Simple Green which is a non toxic biodegradable all purpose cleaner Do not submerge the unit as it will damage the contents and the electrical components Do not use abrasive cleaners as they will scratch the surface of the unit Rev 6 2 08
3. itch Modifier is set for Time function Therefore if you will use the Switch Modifier Time function when in Intention Mode you must first set the time in Standard Mode before switching to Intention Mode The Switch Modifier will remember the time setting indefinitely until the Time is readjusted in Standard Mode Switching to Intention Mode 1 Connect the capability switch and device as detailed above Make sure the Switch Modifier is off for approximately 10 seconds Failure to wait 10 seconds may prevent the Switch Modifier from switching in and out of Standard and Intention Mode 2 Press the capability switch before turning ON the Switch Modifier and keep it pressed Then turn ON the Switch Modifier Continue to keep the capability switch pressed for 5 seconds The Switch Modifier should now be in Intention Mode 3 Set the Time Momentary Latch Switch to the function you wish to use 4 Adjust the knob to adjust Intention Time This is the amount of time needed for the capability switch to be constantly pushed before the device will activate Rotating the knob fully clockwise will allow the device to activate immediately while full counterclockwise will take a full 15 seconds before the device will activate The Momentary Latch Time functions are as outlined in the Standard Mode instructions above Troubleshooting Problem Switch Modifier does not work Action 1 Check battery for freshness if weak or dead replace with new
4. will not work Slide cover back on 2 Make sure the unit is turned off Plug your switch into the jack marked Switch Plug the device or toy you want to activate into the jack marked Device Turn the unit ON by sliding the switch to the ON position Set the Time Momentary Latch Switch to the function you wish to use Momentary The device will operate as long as the capability switch is pressed Releasing the switch will shut off the device Latch Pressing the capability switch once and releasing it will activate the device Pressing the capability switch again and releasing it will shut off the device Time Pressing the capability switch will activate the device for a preset amount of time Time is adjusted by rotating the small knob on the side of the unit and can be adjusted from a fraction of a second to 2 minutes 120 seconds The device will then shut off regardless if the capability switch is pressed or not To activate the device for another timed cycle the capability switch must be released and pressed again Using the 605 Switch Modifier Intention Mode Intention Mode allows the user to activate the device as in the Standard Mode above only after pressing the capability switch for a preset amount of time The intention time can be adjusted from a fraction of a second to 15 seconds The time is adjusted by rotating the small knob on the side of the unit Note that this knob is the same knob used to adjust time when the Sw
Download Pdf Manuals
Related Search