Coleman 200001391 User's Manual
Contents
1. When You Are Ready To Set Up Your Tent Select a level campsite clear of Main Tent rocks branches and other hard Poles or sharp objects Rainfly Do not set up your tent under trees Poles For best results in windy conditions do not position the door of tent Vertical Hinged Door into the wind Pole Hinged Door Pole T Layout amp Positioning of Tent Pole Assembly Layout and position tent with door facing desired direction illus 1 Unzip door Stake down tent corners only using the rings at the end of the stake loops Keep the floor taut illus 2 Assemble frame poles by interlocking shock corded poles This will make two long poles Insert the poles diagonally into pole sleeves The center of the poles should cross forming an X in the middle of tent illus 1 Assembled poles inserted through pole sleeves illus 2 Tent stake through ring FOSSIL CREEK XL 12 x11 Instructions apply to Part Number 200001391 POLE ASSEMBLY PARTS Part No 9240 1151 Part No 9240 1161 Part No 9240 1131 Part No 9240 1141 Rainfly Part No 9240 1121 Connect Frame to Tent 2 Insert one end of the main tent pole onto pin of pin amp ring system at the tent corner illus 3 Go to opposite end of pole and gradually apply pressure to the pole forming an arch until you are able to insert the pin into the pole Repeat for second pole illu2. J end into bottom pole stop and zip sleeve Pole inserts X Long Door into sleeve Pole inserts closed illus 9 10 and zips in into sleeve Attach and stake out guylines illus 8 and pole stops then zips in illus 9 Hinged Door Pole Stop illus 10 Hinged Door Things You Should Know Under certain conditions cold weather high humidity etc condensation will form on the inside surfaces of your tent Condensation is caused by water vapor from your breath perspiration or any wet clothing inside your tent It is NOT LEAKAGE through the tent fabric It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent Never store tent even for a short period of time without drying it thoroughly and brushing off caked dirt Do not pack stakes or poles inside your tent Use a separate storage bag STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE TENT POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER DURING STORAGE PRINTED IN CHINA Rev 1 07 Do not leave your tent set up for weeks at a time be aware that exposure to the ultraviolet rays of the sun can seriously damage material and or cause it to become discolored WARNING KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC This tent meets the flammability requirements of CPAI 84 The fabric may burn if left in continuous con
3. s 4 illus 4 Fd Tent frame set up illus 3 Insert pole end onto pin amp ring Attach Tent to Frame Using Frame Clips Attach frame clips along the edges of tent to frame poles illus 5 illus 6 Make any adjustments to the tent corner stakes that are needed Attach Rainfly Assemble rainfly pole by interlocking shock corded pole Insert rainfly poles into pole sleeves located at the center edges of the underside of rainfly illus 7 Drape rainfly over tent frame pole side down Rainfly poles should cover door and rear N Grommets for rainfly poles illus 5 Frame clips Pole Attachments window illus 8 Connect the four elastic loops with S hooks Completed found at the rainfly corners to the rings located tent with an on the stake loops illus 8 raintly f Rainfly poles Insert the tips of the rainfly poles into the grommets Underside Secure rainfly with attachments located on of rainfly underside of fly illus 8 i lt N attaches to Assemble and insert short Vertical Hinged D frame Door Pole through vertical sleeve and into d poles bottom pole stop Gently apply pressure to a insert top end into top pole stop and zip sleeve ie ay closed illus 9 10 Wea eon lines Assemble and insert long Hinged Door Pole through curved door sleeve and into top pole stop Gently apply pressure to insert bottom Vertical Door
4. tact with any flame source The application of any foreign substance to the tent fabric may render the flame resistant properties ineffective THE COLEMAN CO INC 3600 N Hydraulic e Wichita Kansas 67219 1 800 835 3278 www coleman com MADE IN CHINA
Download Pdf Manuals
Related Search