Coleman 16'X13' User's Manual
Contents
1. 16 X13 WHITE PINE with SCREEN ROOM Instructions apply to Part Number 9271 163 POLE ASSEMBLY PARTS When You Are Ready To Set Up Your Tent Select a level campsite clear of rocks branches and other hard or sharp objects Do not set up your tent under trees For best results in windy conditions position the end of tent into the wind See owners manual for more tips l Main Tent Poles Part No 9271 166 Side Tent Poles Part No 9271 167 Screen Room Ridge Pole Part No 9271 162 Screen Room Upright Pole Part No 9271 168 Rainfly Pole Part No 9271 161 Rainfly Part No 9271 164 Layout amp Positioning of Tent Layout and position tent with screen room facing desired direction illus 1 Stake down tent corners Do not stretch too tight Angle the stakes slightly toward the tent illus 2 Keep the floor taut Stake down the remainder of the Stake loops and unzip doors Assemble main tent poles black and side tent poles gray by interlocking the shock corded sections Insert the main tent poles black diagonally through the pole sleeves This will form an X in the center of the tent illus 1 Insert side tent poles gray through the pole sleeves at the ends of the tent illus 1 Connect Frame to Tent Insert one end of main tent pole end onto pin of pin amp ring system nearest the middle of the tent illus 3 4 Go to opposite end of pole2. Forms an arch Curved poles in pole sleeve illus 8 Curved ridge pole attaches to upright pole Pole ties Frame ties Assemble rainfly pole by interlocking piece into shock corded pole pocket on Insert rainfly pole into reinforced pockets underside of lus 10 5 located at the center edges of the Rainfly 2 Underside of rainfly underside of rainfly illus 9 amp 10 Tie underside of rainfly to the rainfly pole with pole ties illus 9 Drape rainfly over tent frame pole side down Rainfly pole should point out over screen room and rear window of tent Connect the eight elastic loops with S hooks found at the rainfly corners to the eight rings located at the end of the stake loops at the corners of the tent Secure rainfly with frame ties located on underside of rainfly illus 11 Stake out tent with four side guylines illus 11 poles Things You Should Know Under certain conditions cold weather high humidity etc condensation will form on the inside surfaces of your tent Condensation is caused by water vapor from your breath perspira tion or any wet clothing inside your tent It is NOT LEAKAGE through the tent fabric It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent e Never store tent even for a short period of time without drying it thoroughly and brushing off caked dirt Do
3. and gradually apply pressure to the pole forming an arch until you are able to insert the pin into the pole illus 3 4 Repeat for second pole Insert one end of side tent pole end onto pin of pin amp ring system at the corner of the tent illus 3 Go to opposite end of pole and gradually apply pressure to the pole forming an arch until you are able to insert the pin into the pole Repeat for second pole Attach frame clips on the tent tent to frame poles illus 3 amp 5 lus 1 2 Front of Screen Door ee Chain shock corded Main poles through pole sleeves lus 2 Stake loops properly staked illus 5 Frame clips SAA Side tent pole illus 3 Tent shown with main and side tent poles in place illus 4 Pin amp ring system located on the front amp rear of tent Raise Screen Room Assemble all chain shock corded Roof Pole When assembled will form a continuous arch with both ends pointing down illus 6 Insert square end of upright poles into curved roof poles and raise tent upright illus 7 amp 8 Angle screen room upright pole back toward tent body and insert pin of pin amp ring system into end of pole Repeat for second pole illus 7 illus 7 Tent shown without rainfly Attach Rainfly Illus 6 Curved Roof F Pole assembly illus 9 Insert Rainfly Pole Screen ridge pole sleeve
4. not pack stakes or poles inside your tent Use separate storage bag STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE TENT POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER DURING STORAGE Seam sealer has not been provided with your tent It is necessary and we recommend seam sealing your tent prior to camping Seam PRINTED IN SRI LANKA prev 11 00 Underside frame ties attach to tent illus 11 Tent shown completed e shown with pole inserted into pole pockets Guylines Pin inserted into screen room upright pole sealer may be purchased through your local retailer or at your local sporting goods store Do not leave your tent set up for weeks at a time be aware that exposure to the ultraviolet rays of the sun can seriously damage nylon material and or cause it to become discolored WARNING KEEP ALL FLAME AND HEAT SOURCES AWAY FROMTHISTENT FABRIC This tent meets the flamma bility requirements of C PAI 84 The fabric will burn left in continuous contact with any flame source The application of any foreign substance to the tent fabric may render the flame resistant properties ineffective THE COLEMAN CO INC 3600 N Hydraulic e Wichita Kansas 67219 1 800 835 3278 www coleman com MADE IN SRI LANKA
Download Pdf Manuals
Related Search