Cardinal Gates MG15 User's Manual
Contents
1. 30265 You must include the following 1 Proof of purchase store receipt etc 2 Brief note describing problem with gate 3 Full return address along with phone number FOR FURTHER ASSISTANCE Call 1 800 318 3380 CARDINAL GATES If it s a Cardinal It s the Best 15 St John s Circle Newnan GA 30265 770 252 4200 www cardinalgates com2. assembly G against opposite wall and extend gate until at least 12 of Safety bracket will interlock with flange of latch Mark position of latch assembly screw holes with pencil Swing gate out of way and mount latch assembly to wall Check closure of gate and tighten set screws from STEP 5 by removing shipping tabs to secure gate width GATE IS RECOMMENDED FOR CHILDREN UP TO 24 MONTHS W ARNIN G TO PREVENT SERIOUS INJURY OR DEATH SECURELY INSTALL GATE OR ENCLOSURE AND USE ACCORDING TO MANUFACTURER S INSTRUCTIONS NEVER USE WITH A CHILD ABLE TO CLIMB OVER OR DISLODGE OPEN THE GATE ENCLOSURE NEVER LEAVE CHILD UNATTENDED USE ONLY WITH THE LOCKING LATCHING MECHANISM SECURELY ENGAGED GATE MAINTENANCE When used outdoors we suggest spraying hinge and latch parts with a marine corrosion inhibitor by CRC or equivalent This can be obtained normally at marinas or auto parts stores Remove set screws when separating frames for cleaning A stainless steel hardware set is available Please call for information To clean rinse with lukewarm water wash gently with mild soap or Sa ai and lukewarm water using a soft cloth or sponge Rinse again Dry with a soft cloth or sponge to prevent water spotting DO NOT SCRUB or use brushes or squeegees GATE CARE amp REMINDERS At CARDINAL GATES INC we pe what we believe to be the very best and most user friendly gates available Our gates are built to last many years with proper use and
3. care Here are a few suggestions e Close gates gently do not slam to prevent damage to latch mechanism e When closing be sure safety bracket on gate frame engages as depicted in instructions e For safety always close gate when not in use Children should not be allowed to swing on an open gate as this can damage hinge mount e Keep allen wrench in a secure place We suggest removing set screws when separating sections for cleaning Periodically check all screws bolts etc for security and proper adjustment CARDINAL GATES INC offers many accessories such as extensions stair kits and other safety products Check with your dealer or call CARDINAL GATES INC at 1 800 318 3380 We sincerely hope that you thoroughly enjoy many years of service from your CARDINAL GATE GATE WARRANTY Your Cardinal Gate is warranted to be free of manufacturing defects for a period of one year from the date of purchase when used in homes and according to manufacturers instructions When used commercially such as day care centers the warranty is 90 days Cardinal Gates Inc will either repair or replace at our option any parts necessary to correct defects in material or workmanship during the warranty period The warranty disclaims liabilty for incidental special and consequential damages of any nature TO EXERCISE WARRANTY Ship your gate in a protective carton freight prepaid to CARDINAL GATES INC 15 St John s Circle Newnan GA
4. MG15 Auto Lock Gate ASSEMBLY INSTRUCTIONS 1 Install hinge bracket A to wall stationary side of gate using Phillips screw C beginning 6172 above floor Surface Use ruler on left edge of this sheet to measure from floor REPEAT AT BOTTOM OF GATE WY Lu O I mM VY Lu Lu I e WY lt I m lt O LL O L QO m ep Ww m I H 3 Insert eye bolts D into top and bottom 4 of hinge side gate side with three holes Be sure nuts are tight LOOSEN AT TOP AND BOTTOM OF GATE TO ADJUST GATE WIDTH 5 Use Allen wrench F to unscrew set screws on top and bottom of gate to extend gate to fill door i opening ONLY LIGHTLY TIGHTEN AND LEAVE SHIPPING TABS IN PLACE NOT TO MAR GATE _ FINISH You will remove shipping tabs during final tightening a Ce A ONE WAY a STOP BRACKET S Install one way stop bracket I on one side of latch if you wish to have gate open in only one direction ule Install second screw C in top of hinge bracket securing it to the wall Hang gate by inserting hinge rod B through top of mounted hinge bracket A through upper plastic shoulder washer E through both eye bolts through lower plastic shoulder washer E and finally through bottom of hinge bracket To secure hinge insert key ring H through hole in end of hinge rod MOUNT LATCH ASSEMBLY WITH SCREWS 6 Hold latch
Download Pdf Manuals
Related Search