Cables Unlimited Audio Unlimited SPK-POOL User's Manual
Contents
1. 1 If there is no audio input signal to the transmitter for a 4 minute period the transmitter will go into standby mode and the LED will change from Blue to Green 2 Ifthe audio source is off the LED on the transmitter will change to Green 3 The Speaker will turn to standby mode if there is no input signal to transmitter and the LED becomes Green The Speaker will automatically shut off when standby mode continues for 5 minutes 4 While in standby mode the speaker will turn to On automatically after getting a signal from transmitter OTHER CONTROL Select volume up and down on Speaker 2 Select Light button to turn on the mood light effect in the water This feature works only when the Speaker is turned on 3 If you hear interference that may be coming from other devices you can adjust the tuning control by moving the channel knob to 1 2 or 3 on the transmitter Then press the Scan button on the speaker for best reception SCAN F TROUBLE SHOOTING NO SOUND Too much water retention inside the speaker grill Turn the speaker over and gently shake it to let the water drain out Ensure you have fresh alkaline batteries for both transmitter and receiver if the speaker s and or transmitter s battery charge is too low sound distortion will be heard Replace with new batteries Ensure the audio component is ON and its volume is set to at least 50 The connected audio equipment is not playing Start playing t2. AUDIO UNLIMITED SPK POOL Floating Wireless Speaker System Instructions Manual www audio unlimited com www cablesunlimited com INTRODUCTION This Audio Unlimited Floating Wireless Speaker System uses the latest 900Mhz wireless technology to enable you to enjoy music outdoors in your swimming pool It is simple to connect the portable transmitter to typical audio sources such as an i Pod Hi Fi CD MP3 player or other audio source A INSIDE THE PACKAGE 1 Transmitter base Floating speaker AC adapter for transmitter Input adapter 3 5mm audio plug to RCA type audio cable o gt 2 IN User Manual w FEATURES 900 MHz wireless technology Auto Scan System to lock speakers onto strongest signal Phase Lock Loop PLL transmitter Water resistant Speaker Open air operating distance of up to 150 feet ON OFF control on Transmitter Auto Shut Off on Speaker Switchable mood light directed downward into the water Si P a 200 CR wee ae N Battery operation for complete portability of transmitter and speaker C COMPONENTS _IDENTIFICATION 1 TRANSMITTER Power Signal indicator Green Blue ON OFF 2 SPEAKER D INSTALLATION 1 TRANSMITTER A Connect the supplied AC power adapter to an electrical wall outlet B Plug the AC power adapter in the DC jack located on the rear of the transmitter C Or you can insert 4 X AA size ALKALINE batteries into the battery
3. Turn on the audio source TV or audio component like an iPod to which the transmitter is connected The LED will change from Green to Blue 3 Select channel 1 2 or 3 of the transmitter for best performance in your location 4 Turn on the Power button on the speaker Press the Autoscan button Adjust the volume by pressing and for desired listening level Caution Screw the battery door clockwise to tightly close it and to make sure there is no gap before placing the speaker into the water 5 You can now place the floating speaker in the pool bathtub hot tub etc CAUTION Your speaker will operate best and loudest with no water resting on top of the speaker Periodically draining the speaker by inverting it will ensure that not too much water remains standing on top of the speaker driver Turn the speaker over and lightly shake it to let the water drain out quickly for best audio performance and when storing the speaker between uses When you find the floater with low volume or no volume in the water it might because the floater fills in with too much water on top of the speaker driver which prevent the driver from producing sound Simply open the speaker cover to release the water out You can use your finger thumb to press the edge of speaker cover as below figure and open the cover pour out the water After that close the speaker cover with correct position the floater will work properly again SWITCHING OFF
4. compartment at the bottom of the transmitter with correct polarity D The rear of the transmitter has one audio cord that can be connected to audio output jack of TV i pod DVD and CD MP3 players or to headphone earphone jack with the connector provided 1 2 3 R i Battery Compartment CHANNEL baubo nd Turn the switch to On and the LED of transmitter will light up in Green When the audio cable has been connected turn on the audio source to at least the mid range level and play the music The LED will turn from Green to Blue note if the audio source is not in the play mode the LED will not turn from green to blue If a speaker is not turned on within 4 minutes the transmitter light will turn from Blue back to green to save power 2 SPEAKER A Insert 6 x AA size ALKALINE batteries into the battery compartment with correct polarity at the bottom of the speaker Tighten the battery door clockwise and make sure it is closed firmly without any gap Press the Power button to turn the speaker ON The Power LED will light up in Green When the signal link is established between the transmitter and speaker the LED on the speaker will change to Blue O W Mate li ee i F PRAAT fate reggae pr x ERE Peso PAHIT Era ae SETA frees ies an oe pisasena hat ne POWER I Vice VOLA VOL TNo oFF m OPERATION Turn on the transmitter The LED will light up in Green 2
5. he equipment The volume of speaker is too low adjust the volume to an appropriate level Adjust your audio source component volume to maximum DISTORTED Too much water retention inside the speaker grill Turn the speaker over and gently shake it to let the water drain out Press the Scan button on the speaker to best match the frequency of the transmitter Change the position of the channel selector on the transmitter You must then press the Scan button on the speakers Battery capacity is too low Replace with the new batteries Ensure the volume level of speakers is adjusted properly The speaker is too far from transmitter move closer The input level of the audio signal is too low Turn up the volume of the audio source equipment G TECHNICAL SPECIFICATIONS Transmission Mode UHF stereo Carrier Frequency 900 MHz Operation Voltage Transmitter 4 X AA size Alkaline batteries not included or DC 6V 300mA adaptor Speaker 6X AA size Alkaline batteries not included Frequency Response 40Hz 12KHz Distortion 1 5 S N Ratio 65dB typical Operation Distance Up to 150feet Output Power 5W Max WARNING Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user s authority to operate the equipment Operation is subject to the following two conditions 1 this device may not cause interference and 2 this device must acce
6. pt any interference including interference that may cause undesired operation of the device This device complies with RSS 210 of Industry and Science Canada Operation is subject to the following two conditions 1 this device may not cause interference and 2 this device must accept any interference that may cause undesired operation of the device This product may contain chemicals listed in Proposition 65 http www oehha ca gov prop65 prop65_list Newlist html that may be known to cause cancer birth defects or other reproductive harm ATTENTION The transmitter for this speaker set is designed to work with a wide variety of devices Our tests have shown the default volume levels of iPods MP3 players and other devices connected to the transmitter through the headphone jack does not have the signal strength required by the transmitter Raising the volume of your device will increase the signal strength to the transmitter The blue signal LED will light when the required signal strength from your device is reached We recommend that you keep the volume set on your iPod or MP3 player at a minimum of of full volume
Download Pdf Manuals
Related Search