Audiovox WHS100 User's Manual
Contents
1. AUDIOVOX CORPORATION WHS100 Audiovox Wireless Infrared Headset System Installation Instructions Parts supplied 1 IR transmitter 1 2 IR Transmitter harness 1 3 IR headphones 2 Notes e For best results IR transmitter must be installed as shown with the LED s pointing toward the rear of the vehicle Fig 1 e Audio input can be connected to either a low level fixed audio output or a variable level audio output such as a speaker or headphone output If it is connected to a low level output only the volume control on the headphones needs to be adjusted to control volume level If connected to a variable level output volume adjustment needs to be done at both the source and at the headphones Wire harness with RCA connectors Fig 2 1 Using dual RCA M M cable not supplied length determined by installation connect one end to red and white RCA jacks Connect the other end to low level signal source 2 Connect pin 4 black wire negative to ground of vehicle 3 Connect pin 5 red wire 12 volt to ignition source source that supplies 12 volts when the ignition is switched on IR Transmitter 1 Plug wire harness into transmitter 2 Remove lens on transmitter to expose screw holes Fig 3 3 Fasten transmitter to headliner using two short screws make sure that screws do not puncture metal of roof Wireless headphones 1 Follow directions in owner s manual for proper oper2. ation 1998 Audiovox Corp Hauppauge N Y 11799 Fig 1 TRANSMITTER POSITIONING DIAGRAM TRANSMITTER REAR POSITION JUST ABOVE THIGH AREA OF SECOND PASSENGER ROW SEATING Fig 2 WIRING DIAGRAM 1 GROUND 1 LEFT RCA CHANNEL IN 2 WHITE 3 RED 2 RIGHT RCA CHANNEL IN 4 BLACK _ lt _ __ 3 DC 12V GND NEGATIVE 5 RED i EN 4 DC 12V IN POSITIVE Fig 3 IN CAR TRANSMITTER SIDE VIEW TOPVIEW 128 5372A
Download Pdf Manuals
Related Search