ATD Tools ATD-80103 User's Manual
Contents
1. SABER LIGHT ATD 80103 Instructions 1 Charging I nstructions Fully charge your ATD Saber Lighte for 8 10 hours before use The battery is only 50 charged before shipping Be sure your ATD Saber Lighte is turned off and then plug the AC charging unit into the wall and into the bottom of your ATD Saber Lighte The green LED indicator at the top of the LED board will light up when the ATD Saber Lighte is fully charged After using your ATD Saber Lighte for 5 hours recharge it until the green LED indicator light comes on 2 Operating Environment e The performance of your ATD Saber Lighte will decline in temperatures exceeding 104 F 40 C or in temperatures lower than 4 F 20 C due to the battery s natural inability to perform under these conditions Keep your ATD Saber Light away from heat sources e Keep your ATD Saber Lighte away from acids and alkalines e Avoid bumping or dropping your ATD Saber Lighte 3 LED board replacement instructions e When repairing your ATD Saber Lighte do not allow any metal to come in contact with the internal battery pack or the PC board and its components e Turn the ATD Saber Lighte off e Remove end cap 2 from end of tube 3 using care not to crack the tube e Pull the LED PC board 8 from top of the tube 3 e Disconnect the wiring connector from the LED PC board and reconnect it to a new PC board 8 e Carefully slide the PC board assembly 8 back into clear tube 3 a2. nd replace the end cap 2 x 4 This unit is NOT waterproof and is NOT intended to be used in showers saunas or any other potentially wet locations Keep the ATD Saber Lighte away from sinks tubs showers etc Retrieving ANY electrical appliance when they fall into the water can be fatal gt The ATD Saber Light is to be used for general indoor lighting It is NOT intended to be used in potentially hazardous locations such as near flammables or in explosive atmospheres 6 Your ATD Saber Light has a built in automatic discharge shut off feature that prevents the battery from becoming fully discharged thus extending the battery life After around 8 hours of use after fully charging the LED s will flash and then the light will shut off automatically to protect the battery 7 You ATD Saber Lighte can be fully discharged and used when plugged into the AC adapter for recharging It will recharge while it is in use ATD Saber Light is a registered trademark of ATD Tools Inc Patent Pending ADWANCED TOOL DESIGN ATD 80103 10 SE re oar e mma Tinea I HN S j OPTIONAL not included PRTB0100 06 Bb CONNECTION WIRE BLACK PRIBUIU UB LED PCB BRIBuUla0gS 9 PC
Download Pdf Manuals
Related Search