Aquatic Exotic Flames Natural Gas Fire Pit User's Manual
Contents
1. FIRE PIT INSTALLATION AND OPERATION GUIDE FOR Featuring Aquatic Glassel Tempered Formulated Glass 2005 2007 NATURAL GAS INSTRUCTIONS Adequate Fire Pit Ventilation is Required if indoors NOTE READ INSTRUCTIONS FULLY BEFORE INSTALLING OR OPERATING INSTALLERS LEAVE THESE INSTRUCTIONS WITH THE CONSUMER This product must be burned only in a fully vented if indoors non combustible fire pit with the damper completely open if indoors and the chimney free of any obstructions or restrictions The fire pit must be designed and approved to burn wood The minimum permanent free opening in the fireplace chimney must be 8 inches in diameter 50 sq inches or greater for indoor installations IT IS THE HOMEOWNER S RESPONSIBILITY TO ASSURE THAT THEIR FIRE PIT HAS ADEQUATE DRAFT for indoor installation only WARNING IF THE INFORMATION IN THIS MANUAL IS NOT FOLLOWED EXACTLY A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE PERSONAL INJURY OR LOSS OF LIFE FOR YOUR SAFETY IF YOU SMELL GAS 1 OPEN WINDOWS 2 DON T TOUCH ELECTRICAL SWITCHES 3 EXTINQUISH ANY OPEN FLAMES 4 IMMEDIATELY CALL YOUR GAS SUPPLIER FLAMMABLE VAPORS MAY BE DRAWN BY AIR CURRENTS FROM OTHER AREAS OF YOUR HOUSE TO THIS APPLIANCE GENERAL INFORMATION DO NOT USE A NATURAL GAS BURNER FOR PROPANE OR A PROPANE BURNER FOR NATURAL GAS WHEN USING PROPANE GAS LPG AN AUTOMATIC PILOT SYSTEM MUST BE INSTALLED 1 There are2. many different local codes for gas fireplaces The installation of Aquatic Glassel glass must conform to your local codes or in the absence of local codes conform to the National Fuel Gas Code ANSI Z223 1 1999 2 Periodically the glass may be dusted with a soft feather duster The top layer may also be scooped up and taken to a water source and washed 3 Do not burn wood with this product NOTE THIS PRODUCT MUST BE INSTALLED BY PERSONNEL QUALIFIED TO INSTALL GAS APPLIANCES IF REQUIRED BY YOUR LOCAL CODES EXOTIC FLAMES BEARS NO RESPONSIBILITY FOR YOUR ACTIONS Page 1 of 3 Step 1 Clean out your fire pit Figure 1 Remove old burner unless it can be re used Attach your new burner with the flex line provided Hint unscrew the fitting on each end of the flex line Screw the fittings to the burner and gas line first Then screw the flex line to each fitting Position the burner to the center and 2 to 3 inches below the rim of the pit by gently bending the flex line Figure 1 Step 2 Now pour in the crushed lava rock Figure 2 while holding the burner in position Pour in just enough lava rock to create a flat surface about an inch below the burner Then switch to finely crushed lava rock pea size filling until the lava rock is flush with the top of the burner Also See Figure 4 Figure 2 Page 2 of 3 Step 3 Now pour and shape 2 inches of glass fill Figure 3 and 4 Your installation is now complete T
3. urn on the glass and light the fire pit with a long lighter making sure to keep your hand away from the surface of the glass Enjoy your product and thank you for purchasing from Exotic Flames Figure 3 Figure 4 Page 3 of 3
Download Pdf Manuals
Related Search