Apple 073-1059 User's Manual
Contents
1. Mac Pro Hard Drive Carrier Replacement Instructions Follow the instructions in this document carefully Failure to follow these instructions could damage your equipment and void its warranty Tools Required The only tool required for this procedure is a Phillips 1 screwdriver Opening the Computer k Shut down the computer Warning Always shut down the computer before opening it to avoid damaging its internal components or the components you are installing Do not open the computer or attempt to install items inside it while it is on Wait 5 to 10 minutes to allow the computer s internal components to cool Warning After you shut down the system the internal components can be very hot You must let the computer cool down before continuing Unplug all external cables from the computer except the power cord Touch the metal PCI access covers on the back of the computer to discharge any static electricity from your body Important Always discharge static before you touch any parts or install any components inside the computer To avoid generating static electricity do not walk around the room until you have finished working and closed the computer 073 1059 Rev A Unplug the power cord Hold the side access panel and lift the latch on the back of the computer Warning The edges of the access panel and the enclosure can be sharp Be very careful when handling them Remove the access panel and place it on a2. flat surface covered by a soft clean cloth SPLITS SSS SSSSS BOr SF Mac Pro Hard Drive Carrier 2 Removing the Installed Hard Drive Carrier 1 Carefully lay the computer on its side so that the open side faces up Important Make sure the latch on the back panel is in the up position When the latch is down the hard drives and carriers are locked in place and you will not be able to remove them 2 Locate the hard drives fen is Oe te St v4 3 Pull the hard drive out of the drive bay Mac Pro Hard Drive Carrier 3 4 Remove the four screws that mount the drive to the carrier and remove the drive from the carrier Important When removing or installing a hard drive hold the drive by its sides Be careful not to touch the printed circuit board on the bottom of the drive Installing the Replacement Hard Drive Carrier 1 Position the replacement hard drive carrier on the hard drive and secure it with the four mounting screws 2 Slide the carrier and drive over the guides and into the drive bay until you feel the drive snap into place Closing the Computer 1 Replace the access panel Note Make sure the latch is in the up position before replacing the access panel If the latch is down the access panel will not seat correctly in the enclosure 2 Push the latch down to close and secure the access panel Warning Never turn on the computer unless all of its internal and external
3. parts are in place and it is closed Operating the computer when it is open or missing parts can damage it or cause injury Mac Pro Hard Drive Carrier 4 Apple Computer Inc 2006 Apple Computer Inc All rights reserved Under the copyright laws this document may not be copied in whole or in part without the written consent of Apple Every effort has been made to ensure that the information in this document is accurate Apple is not responsible for printing or clerical errors Apple 1 Infinite Loop Cupertino CA 95014 2084 USA 1 408 996 1010 http www apple com Apple the Apple logo Mac Macintosh and Mac Pro are trademarks of Apple Computer Inc registered in the U S and other countries Mac Pro Hard Drive Carrier 5
Download Pdf Manuals
Related Search