AMX RDM-HFDB User's Manual
Contents
1. BP LA IT S FOUR WORLD TAKE CONTROL The RDM HFDB Heavy Duty FDB Module is a heavy duty 2400 W positive air gap relay and dimmer built for strength and for reliable switching dim ming of Lutron FDB ballasts It is designed for use with the RDA series of enclosures in a AMX Lighting modular digital dimming system The RDM HFDB module s 120 240 and 277 VAC ratings are CE UL and C UL approved Mounting points Sy AHA High High Neutral i j Ig voltage Line in hot ee ae Switched out voltage connections x Dimmed out connections Positive air gap relay Solid state relay Low voltage control wiring 4 pin connector to AMX Lighting master controller FIG 1 RDM HFDB RDM HFDB UL and C UL Ratings e 120 VAC 2400 W e 240 277 VAC 2400 W Suggested Dimmed Loads e Lutron FDB Ballasts e Lutron ECO 10 Ballasts refer to the AMX Lighting instruction manual for more information Specifications e Dimensions HW 10 0 x 2 75 25 4 cm x 6 99 cm e Phase dependant e Use wires rated at 75 C 167 F e Torque terminals to 20 in lbs 2 3 N M e Max wire size 10 AWG 4 mm e Wire stripping length 0 28 7 mm e Weight 1 50 Ibs 0 680 kg e BTU hr 150 e Control current 135 mA 12 VDC e Use Dimming Curve 6 refer to the Programming AMX Lighting instruction manual for more information e For use with FDB ballasts Caution Pre Installation Notes e All2. Class 1 wiring must be connected to proper terminals e All control wiring must be connected to proper terminals e Disconnect power while installing or connecting the unit e Keep top and bottom air vents clear at all times e Test loads for shorts before connecting Use low voltage wires with a 300 volt rating or greater Installation Sheet RDM HFDB Heavy Duty FDB Module 2400 W e Use field installed copper conductors e All electrical ratings are for continuous duty e For indoor use only e This module may require extra power from the AXlink connection or an external power supply connected to the control card Connecting the RDM HFDB to the AMX Lighting Master Pin 3 RLY Pin 2 DIM Pin1 12 V RDM HFDB 4 pin module connector 3 2 AC 1 4 pin plug from RDM series module Note The 4 pin plugs from the module connector to the 4 pin connector on the master black plug cover facing up FIG 2 Connecting the RDM HFDB and AMX Lighting Master Lighting Application Drawings All neutrals are common to the Neutral block in the enclosure Provide a separate neutral for each load Line in HOT Neutral pr LHD NEUTRA Florescent Ballast Circuit breaker panel FIG 3 RDM HDC application wiring AMX Corporation reserves the right to alter speci
3. fications without notice at any time For full warranty information refer to the AMX Instruction Manual s associated with your Product s 043 019 2239 10 01 2001 AMX Corporation All rights reserved The AMX logo is a trademark of AMX Corporation AMX Corporation reserves the right to alter specifications without notice at any time 3000 research drive richardson TX 75082 USA 469 624 8000 800 222 0193 fax 469 624 7153 technical support 800 932 6993 Ar R
Download Pdf Manuals
Related Search