AmpliVox S132A User's Manual
Contents
1. allow you to use one or both speakers for additional sound power or true stereo output Base unit speaker is wired internally Plug external speaker into left speaker jack for stereo Note when using a stereo AUX source with a single speaker only one of the stereo channels will be heard However all MIC inputs are heard equally on both channels PROBLEM SOLVING FEEDBACK is the howl or screech often heard in sound reinforcement systems It is caused by sound from the loudspeaker returning to the microphone AmpliVox systems utilize proven acoustical principles to minimize this however there is no way to completely eliminate howlback under conditions of high amplification If feedback occurs check the following 1 User s hand covering the head of the microphone Hold microphone under head slots 2 Sounds can easily re enter microphone Keep loudspeaker turned toward audience Note sound can be reflected from a hard surface back through the microphone Turn speaker 3 User holding microphone in a reflecting position Turn microphone 4 Volume setting too high Reduce microphone channel volume compensate by speaking louder or closer to the microphone NO SOUND Make sure amplifier POWER switch is turned on and red LED is lit If switch is on and LED is not lit check to see that batteries are properly connected and at full charge If using optional power adapter check to see that front panel connector is properly seated a2. INA AMPLIVOX PORTABLE SOUND SYSTEMS ROVING ROSTRUM P A PORTABLE PUBLIC ADDRESS SYSTEM MODELS S132A INCLUDES Carrying case with fold down legs and built in speakers Multimedia Stereo Amplifier Professional Cardioid microphone Gooseneck microphone holder Extension speaker with 40ft cable CD Player Cassette Tape Player SET UP INSTALL POWER SUPPLY The Battery pack is standard Optional Power Supplies may be substituted Model 1460 International AC Adapter Recharger 110 220V 50 60Hz Model S1462 12 Volt DC adapter automotive cigarette lighter plug in Model S1465 NiCad Battery Pack TO INSTALL OR REPLACE BATTERIES Remove Reading board Loosen two wing nuts on battery holder bracket Remove battery holder from amplifier Insert 10 new Alkaline D cell batteries be sure to observe polarity or replace with Model S1465 NiCad battery pack Carefully replace battery pack Replace battery holder bracket Tighten two wing nuts and replace reading board Do _ not mix battery types or attempt to recharge alkaline batteries equipment damage safety hazard or fire could result CD CASSETTE PLAYER Each requires AA batteries loaded on the backside of each unit TO OPERATE Plug microphone into DYNAMIC microphone jack Plug the extension speaker lead into right SPEAKER jack Turn amplifier on large rocker switch located on the front of the amplifier The red light will go on showing that power is available R
3. nd verify that the power source is live IF YOU HAVE ANY QUESTIONS OR PROBLEMS PLEASE CALL OUR CUSTOMER SERVICE DEPT AT 1 800 267 5486
4. otate VOLUME control knob to obtain desired loudness level throughout the coverage area ON OFF When power switch is in the ON position the red light will be on DC IN Connection for optional power adapter e 1460 International AC Adapter Recharger 110 220V 50 60Hz e S1462 12 Volt DC automotive cigarette lighter Adapter LAMP Connection for 12 to 15V DC accessory VOLUME Rotate clockwise to increase amplification MICROPHONE INPUTS There are three microphone inputs which can be used simultaneously DYNAMIC for standard dynamic cartridge microphones CONDENSER for electret or condenser microphones which require phantom power Supplied from the amplifier WIRELESS accepts line level output from wireless microphone receiver when used with 132A AUXILIARY To add pre recorded music or sound effects during your presentation just connect your CD player tape player or computer sound card into the AUXILIARY LINE IN jack using a 6 stereo cable supplied then plug into the phone jack on CD or cassette Separate VOLUME and TONE control knobs let you balance the program source with the live microphones If using an external wireless receiver for best sound quality it should be connected to the LINE IN jack OUTPUT To tape record your speech or program connect the LINE OUT on the amplifier using a 6 stereo cable supplied to the input on a tape recorder SPEAKERS Two separately amplified speaker jacks 4 8 ohms
Download Pdf Manuals
Related Search