Alvin X-4-XB User's Manual
Contents
1. D with holes in table top as shown in Figure 1 Fasten all screws IM and tighten securely Use care not to overtighten and strip Carefully return table assembly to the upright position Adjust table top to desired height using height adjustment knobs F You re finished and your table is ready to use as shown in Figure 2 Folding Table Drop all extension tubes down to their lowest positions Lift top up until the front extension tubes D disengage with the support braces G then move the left leg assembly in until it is flush against the rear frame assembly X 3 xB XI 3 XB XI 3 XB Next move the right leg assembly in flush against the left leg assembly XIl 4 XB Gently lower the table top down flush against the right leg assembly The table is now ready for storage 2008 ALVIN amp COMPANY INC e P O Box 188 Windsor CT 06095 0722 www alvinco com Phone 860 243 8991 Toll Free 800 444 2584 e Fax 860 242 8037 Toll Free Fax 800 777 2896 LIT A8002 4 08 Figure 22. gt Professional Spacesaver Tools Required Phillips screwdriver drill with 1 6 bit Parts Included B 1pc Tabletop C 2pcs Rear Extension Tubes Shipped in separarate box D 2pcs Front Extension Tubes E 2pcs Floor Glides F 2pcs Height H 12pcs 1 2 Wood Screws 22 O OO Oa Oo CO COD Coa Ca ca G 2pcs Leg Support Braces To Assemble f 1 Unpack all parts and inspect to confirm that all are present 2 Unfold base A Insert rear extension tubes C completely into frame A and loosely hand tighten knobs F 4 Insert front extension tubes D into frame A Place table top B with preferred side facing down on carpeted or protected floor Place supplied cardboard template on board surface with edge of template at front edge of board Left and right edges of template should be an equal distance from each side of the table top Using a 146 drill bit gently drill 14 deep holes where indicated on the template red squares for 24 x 36 top or black holes for 31 x 42 template marked XB II is for 36 x 48 top Remove template Wrap masking tape 1 4 from drill bit end to determine drilling depth Take care to drill only 4 deep to avoid drilling through and damaging table top surface Using the Phillips screwdriver screw the leg support braces G onto the tabletop B as shown in Figure 1 Carefully turn table frame upside down and place on top of tabletop Align holes in front leg extensions
Download Pdf Manuals
Related Search