Alvin Drafting Table Onyx User's Manual
Contents
1. Phone 860 243 8991 e Toll Free 800 444 2584 e Fax 860 242 8037 e Toll Free Fax 800 777 2896 www alvinco com LIT A7143 6 072. drill to start screw holes Be careful not to drill all the way through tabletop Attach rear extension brackets and front guide tracks to tabletop using 1 2 Phillips screws G Eg Front guide tracks Since some screws are hard to reach try spinning l INN F U 7 adjustment collar so that adjustment knob is out of your way z Once all screws are secure return table to its upright position and adjust tube extensions until tabletop is at desired height and angle Figure 4 Approx Approx 3 e gt 3 Fa Approx 6 Approx 6 k To Attach Pencil Ledge Flush Position The pencil ledge Hi prevents materials from sliding off a tilted surface Slotted connection allows for easy adjustment from flush to elevated position Use an awl or a e drill to start holes and attach using two screws J into front edge of tabletop To Fold Table Flat Tighten the two hinge bolts Loosen lower screws in that connect the front legs to front height adjustment the back of the base frame to collars IE and spin maximize the strength and collars until adjustment stability of the table knobs face inward Lift front edge of tabletop slightly to remove front extension tubes from front guide tracks and swing legs inward Left leg should be folded first When both front legs are folded into position allow tabletop to drop downward 2007 ALVIN amp COMPANY INC P O Box 188 Windsor CT 06095 0722 3
3. gt Onyx Drafting Table Assembly Instructions Tools required Phillips screwdriver and awl or Ye drill Parts Included B 2 pcs C 2pcs E 4pcs F 2pcs A 1pc C a aac Ca Rear extension tubes Front extension tubes Height adjustment collars Front guide tracks G 12 pcs H 1 pc J 2 pcs Base frame Ys Phillip screws Pencil ledge Pencil ledge screws To Assemble Unpack and inspect contents to confirm you have all the parts listed above Open base frame A in the upright position and place one height adjustment collar IE on top of each leg tube as shown in figure 1 Position adjustment knobs facing out and tighten lower screws using a Phillips screwdriver Figure 1 Figure 2 Insert front and rear extension tubes B and into base frame as shown in figure 1 For the time being set each tube at a height of approximately 4 and lock into place by tightening adjustment knob see figure 2 Front extension tube ine Adjustment knob Rear extension tube Lower Phillips screw Place your drawing board tabletop on a soft pad or carpet to avoid Figure 3 scratches with the best side facing down Turn the assembled base Asan extonsion brackeis frame A upside down and place on tabletop as shown in figure 3 Position the frame according to the dimensions in figure 4 depending on the size or your tabletop Center from left to right Place front guide tracks F under front leg extensions as shown Use an awl or a e
Download Pdf Manuals
Related Search