Airflow Technology Breeze Ultra 7.1 User's Manual
Contents
1. GE Flow pA Technolo OPERATION INSTRUCTIONS FOR THE AIRFLOW BREEZE ULTRA WITH REMOTE CONTROL MODEL SERIES 7 1 READ AND SAVE THESE INSTRUCTIONS AND IMPORTANT NOTICE INSTALLATION Floor registers 6x10 or 6 x12 1 Remove the round cap on the grill top 2 Route the plug end of the AC adapter through the round opening and plug into the underside of the Ultra Place round cap with slot on the grill top Plug the AC adapter into the 120V AC wall outlet Follow the Operation Settings Remove the floor register and replace with the Ultra Oo a Wall or Ceiling registers 6 x10 or 6 x12 1 Drill 2 holes with a 3 16 drill bit from the bottom side of the Breeze The holes should be drilled in the pre molded locations as pictured below Remove the round cap on the grill top Route the plug end of the AC adapter through the round opening and plug into the underside of the Ultra Place round cap with slot on the grill top Plug the AC adapter into the 120V AC wall outlet Follow the Operation Settings Remove the wall or ceiling register and replace with the Ultra Note If you choose to hard wire the Ultra install the necessary 120V AC outlet near the backside of the Ultra then plug into the rear of the unit Use the non slotted grill cap to trim out the Ultra top w tad oOo Power Cord Access Hole Power Receptacle AirFlow Technology Inc 1427 W 86 St Suite 328 Indianapoli2. e room temperature for the purpose of programming the electronic sensor 7 To shorten the length of time your Breeze Ultra runs after your forced air furnace or air conditioner has shut off a for HEAT raise the SET POINT temperature b for COOL lower the SET POINT temperature 8 If power fails or the Breeze Ultra is turned off the Ultra will automatically retain all settings
3. s IN 46260 www aftproducts com 800 458 5540 K Operation Settings Mode Selections e FAN green for continuous running e HEAT red for automatic ON OFF to boost warm air e COOL blue for automatic ON OFF to boost cool air MODE S5 60 0O Display shows SET POINT FAN HEAT COOL p temperature setting for QO SPEED es HEAT and COOL 2 HIGH MED LOW FAN Speed Settings REMOTE CONTROL INSTRUCTIONS e Press ON OFF button to turn Breeze Ultra on e Press MODE button for FAN green and select fan speed Suggest HIGH to start e For heating press the MODE button and select HEAT red Adjust SET POINT down until fans are on then adjust SET POINT up until fans turn off Unit is now set e _ For_cooling press MODE button and select COOL blue Adjust SET POINT up until fans are on and then adjust SET POINT down until fans turn off Unit is now set e Return to INSTALLATION directions 6 or 7 MODE ON OFF OO gt SET SPEED POINT DOWN GE Flow a Technology IMPORTANT NOTES 1 Fan speed light will flash when fans are running 2 Fan speed can be set at any time Fans do not have to be running 3 Numeric display will go out 30 seconds after SET POINT is completed 4 The numeric display will only be active in the Heat or Cool mode 5 The numeric display will come on in Heat or Cool if any button is pressed 6 The numeric display exhibits an approximat
Download Pdf Manuals
Related Search