Aiphone HID-SS User's Manual
Contents
1. NE SSR IE TC M TD H KB Audio door stn IE SS A IE SSR For additional options please contact Aiphone Technical Support FCC WARNING This device complies with Part 15 of the FCC rules Operation is subject to the following two conditions i 1 This device may not cause harmful interference 2 This device must accept any interference that may cause undesired operation e For proper regulatory compliance the drain wire should be disconnected at the power supply end of the cable e Changes or modifications not expressly approved by the party responsible for compliance could void the user s authority to operate the equipment e The Reader is intended to be powered from a limited power source output of a previously certified power supply Aiphone Communication Systems 1700 130th Ave N E Bellevue WA 98005 425 455 0510 FAX 425 455 0071 TOLL FREE TECHNICAL SUPPORT 800 692 0200 E MAIL tech aiphone com HID SS Instr 0913JD2. lt gt AIPHONE HID Proximity Reader Module for 2 Gang Entrance Panel INSTRUCTIONS The HID SS is a 2 gang stainless steel unit that contains an HID ProxPoint Plus Card Reader This module installs next to any one of Aiphone s 2 gang stainless steel sub stations SS and SSR series creating a unified look with the intercom and card reader installed together Horizontal and vertical surface mount boxes are available for mounting both units The HID SS does not need to be used with an intercom station The card reader provides electronic access to a building through the standard Access Control system which is not supplied by Aiphone See matching models numbers on page 2 or see Aiphone Catalog for more information INSTALLATION 1 Install HID SS alongside of or below the 2 gang intercom sub station 2 The HID SS will mount into the SBX 2BH SBX 2BV SBX 2G or any standard 2 gang box or ring 3 Secure wire connections as shown on wiring chart 4 Cut any unused wire so that bare wires are not exposed 5 Refer to standard product installation manuals for complete system information No additional information pertaining to the Access Control system is provided by Aiphone HID SS HID SS front view back view LED indicator Connecting the Reader to the Host gt Connect the reader to the host according to the wiring table below and the host installation g
3. uide DC Red Ground Black Violet Data0 Green ninta Da White 18 pigtail cable Shield Ground Drain O Green LED Orange Red LED Brown zl Beeper Yellow Hold Blue Page 1 TYPICAL LAYOUTS 2 gang sub and HID SS Mounted vertically in SBX 2BV vertical TESTING AND OPERATION e When power is applied to the card reader the LED will flash green three 3 times while the beeper beeps simultaneously The LED will then turn red This indicates that the microcontroller is operating properly surface mount box o o o o o o 2 gang sub and HID SS HID SS without mounted in SBX 2BH intercom sub station horizontal surface mount box with optional SBX 2G surface mount box e Present an ID card to the reader Hold card directly in front of reader The LED will momentarily turn green while the beeper beeps once indicating that the card was read successfully SPECIFICATIONS Reader Power Source Absolute Max Voltage Peak Current Avg Current 5V or 12V Terminations Wiring Distance Dimensions H x W x D Operating Temperature 6005B Series 5 0 16 0 VDC 18 VDC 80 mA 20 mA Color coded pre wired pigtails 500 4 x 4 3 4 x 7 8 10 60 C 14 140 F INTERCOM SYSTEM MATCHING SUB STATIONS LEM LEF LAF C CA AP M MP S series LE SS A LE SSR NEM NDR NDRM series NE SS A
Download Pdf Manuals
Related Search