Accusplit 998-310 User's Manual
Contents
1. outside front of the watch is touching your palm is held in place with spring tension With the Put the lanyard back into its slot in the bottom of battery hold down tab out of the way you can the case front shake or pry the old battery loose 12 Flip the electronics case back assembly over and 6 Install a new CR2032 battery with terminal gently press it back into the front case of the watch facing up until it seats The buttons should now work normally 7 Ifthe gray gasket came loose from the case back 13 Replace and tighten the six screws in the case back reinstall it now a First line up the black gasket holder on top of the Screws must be tight for the watch to be water resistant again ACCUSPLIT Inc 3090 Independence Drive Suite 148 Livermore CA 94551 USA 800 935 1996 925 290 1900 FAX 925 290 1930 www ACCUSPLIT com support ACCUSPLIT com 998 3102. ACCUSPLIT A601X3V Stopwatch Battery Changing Instructions When the display on your watch begins to go dim or if it goes blank the watch needs a new battery The watch uses a high capacity CR2032 Lithium battery which has an expected life of more than five years in this watch Plastic Lens Name Plate Case Front 3 Button Set Button Holder Metal Clamp LCD LCD Connector 2 To change the battery you will need a set of large jeweler s screwdrivers including Phillips head Note If this looks too complicated you can always send your watch back to ACCUSPLIT for battery changing instead See www ACCUSPLIT com support for details 1 Turn the watch over and select the correct size Phillips screwdriver the fastening is very tight so the screws will strip easily if you use the wrong size or type of screwdriver LCD Display Holder PCB Battery Holder Gray Rubber Gasket Gasket Holder Case Back Negative Battery Contact Positive Battery Contact Warranty Label 1 2 3 4 5 6 7 8 9 10 11 3 os r NOOO FP WD 601X3V 2 Remove all six screws from the back of the case and case back with the beveled side facing up set aside so they will not get lost b Orient the gasket correctly The three dark gray 3 Gently pry the watch back Electronics module pads must be facing up away from the case away from the case front back using the gap near th
3. e c Finally put the gasket on top of the gasket ae eee holder and gently push both into the case back the case back You will have Haney Penson Ere e to slide the back downwards 8 Turn the electronics module over so that the battery to free the electronics module is facing the inside of the case back Gently push the from the button actuator bars electronics module down into the gray rubber The lanyard will also come loose set it aside gasket until it seats It will be firmly in position if 4 Hold the case back with Baten Gray rubber a E A electronics module face up gasket 9 Slide the button set out of the front case you Il see in one hand Use your other that the three buttons are joined together into one hand to gently pull the assembly electronics module loose 10 Turn the button actuator set so that the flat part of from the case back The the buttons are facing the outside of the case back green circuit board will Now slide the button set into the top of the case come away with the module back amp electronics module assembly so that the Try to leave the gray rubber button actuator bars slide down into the slots gasket in place see step 7 Battery hold down tab between the top of the gray rubber gasket and the 5 Turn the electronics module over to see the battery case back Use a small flat head screwdriver to gently push 11 Now pick up the case front holding it so that the the silver battery hold down tab out of the way it
Download Pdf Manuals
Related Search