Brodit ProClip 513608
Contents
1. 27 January 2015 www brodit com 2015 Brodit AB Product 513608 513608 Active holder for fixed installation With tilt swivel with Molex adapter system Use an active holder for your Tab PRO 10 1 while driving and you will always have a freshly charged battery The active holder is to be connected inside the dashboard It provides a discreet and neat installation without any cables hanging over the interior Safe and convenient 12 24 Volt The product is E approved Connect the power cable with a 2 A fuse 2 A charger Professional installation recommended The holder is mounted onto a tilt swivel This mean that you can adjust the angle in order to avoid light reflection on the screen You can easily switch between portrait and landscape mode by turning the holder into desired position It is easy to put the Tab PRO 10 1 into place in the holder and to take it with you when leaving the car Tablets Surfpads should not be installed onto a car s dashboard if they block the view or block key controls ProClip Brodit s vehicle mounting bracket is designed for installation of smaller devices like mobile phones and GPS devices ProClip is not designed for large devices like tablets In some vehicles the ProClip has an extra firm fit and can then be used also for installation of a tablet If you want to place a tablet onto the car s dashboard each combination of tablet car must be examined in detail by you in order to determine if s2. s before attaching the holder 1 Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back 2 Place the attaching plate onto the desired position 3 Screw the attaching plate into place with the enclosed screws Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel Tighten the screw until the holder is firmly in place but still can be adjusted 4 The holder is in place in upright and horizontal position 2 2
3. uch an installation is possible in the specific case Consideration should be given to the position and how firmly the ProClip is in place as well as the size of the tablet you wish to use Brodit will not give any recommendations for such installations An installation of a tablet onto a vehicle s dashboard is always done on the customer s own responsibility Brodit recommends to use tablets on the car s headrest installed onto a Brodit headrest mount EAN 7320285136083 Item no 513608 fits Samsung Galaxy Tab PRO 10 1 LTE SM 1T525 For all countries Samsung Galaxy Tab PRO 10 1 SM T520 For all countries 1 2 INSTALLATION INSTRUCTIONS l 2 Important Note The charger unit is fused internally with 2 A automotive re settable thermal fuse but if an external fuse is to be installed then connect a 2 A fuse holder and fuse inline with the Red wire close to the power source Route the cable from the holder into the vehicle dashboard and secure the charger unit in place with the adhesive tape provided Ensure the charger unit is securely mounted behind the dashboard in a well ventilated area that does not get hot Connect as follows 1 Connect the White wire to a Negative Ground connection of the vehicle or the vehicle chassis 2 Connect the Red wire to a 12 24 Volt power supply in the vehicle that is controlled by the ignition switch of the vehicle Installation of the holder Please read all of the instructions and look at the picture
Download Pdf Manuals
Related Search