Brodit 513156 holder
Contents
1. 2 INSTALLATION INSTRUCTIONS l Please read all of the instructions and look at the pictures before attaching the holder Important Note The charger unit is fused internally with 2 A automotive re settable thermal fuse but if an external fuse is to be installed then connect a 2 A fuse holder and fuse inline with the Red wire close to the power source Route the cable from the holder into the vehicle dashboard and secure the charger unit in place with the adhesive tape provided Ensure the charger unit is securely mounted behind the dashboard in a well ventilated area that does not get hot Note If you are connecting a GPS Data device to the holder please ensure the charger unit is located in a position within easy reach of any GPS or charging adapters Route the power cable from the charger unit to the power supply source in the vehicle and connect as follows 1 Connect the White wire to a Negative Ground connection of the vehicle or the vehicle chassis 2 Connect the Red wire to a 12 24 Volt power supply in the vehicle that is controlled by the ignition switch of the vehicle Installation of the holder 1 Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back 2 Place the attaching plate onto the desired position Screw the attaching plate into place Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel Tighten the screw so the holder is firmly in place bu2. F s 4 kr e r G i ATS O AEA Caora T TLE h h Do eT a ae E r j a J f y oO wo A oy k an de i a 4 fc 2 E r ie c x z P bh F 4h i A 7 cas Am7 1 0 z os I 1 49 r a d i oa i a ao lt j E ii ime Pi a as L i Min F 15 March 2012 www brodit com 2012 Brodit AB Product 513156 513156 Active holder for fixed installation For fixed installation with Molex adapter system 2A charger Keep your device in an active holder while on the road and you will always have a freshly charged battery The active holder is to be connected inside the dashboard this gives a discreet neat installation without cables hanging over the interior When you put the device in the holder it is automatically connected to the charging unit You can choose to use the holder as an active holder for charging of your device only or to connect an adapter to the Molex connector for additional features Then you can use the holder also for power supply of a GPS receiver or other own solutions can not be used for data communication or audio connection 12 24 Volt The product is E approved Connect the power cable with a 2 A fuse 2 A charger Professional installation recommended The holder is attached onto a tilt swivel so you can easily adjust your device in order to avoid light reflection Attach onto a ProClip Mounting Platform EAN 7320285131569 ltem no 513156 fits Motorola MC9500 Symbol MC9500 1
3. t still can be adjusted 3 To place the device in the holder Place the upper part of the device in the holder then flip press the lower part forwards so it snaps into place in the holder To remove the device from the holder Press upwards on the upper part of the holder in the same time pull the upper part of the device out from the holder and then lift the device up and out from the holder 4 The holder is in place 2 2
Download Pdf Manuals
Related Search