Scanbar Discovery +
Contents
1. USB Mode The USB mode is effectively a keyboard emulator works with hosts that are USB compatible operating systems and have USB ports USB compatible operating systems are Windows 98 Windows NT 5 0 and Mac OS 8 and later No additional software is needed since the USB driver support is built into this operating system All program setup must start with reading the Start of Configuration Start of Configuration label and read the End of Configuration label to save any changes Keyboard Wedge Mode Message Terminator None Keyboard Type om Internat Il Keyboard It Mt Message Terminator Mt Il None Execute Keyboard Type Selection US Keyboard Ke US Keyboard vn Scanning Mode Selection ALT Method IBM ATI I l Capital Lock Auto Scan Mod Repeat M International Keyboard i I Mi Altematiys Mode Good Read Beeper Selection For selective models only Tone High IMedium ium Duration UO Long Short Disable The default Stag il2. values are fram Meh DAAM Copyright 2009 All rights reserved P N 593 30000E 006 Programming Card For Handheld CCD Laser Scanner Introduction This programming card contains only frequently used programming bar code labels and by scanning these labels it can configure the scanners This allows decoding options and interface protocols to be tailored to a specific application The configuration is stored in non volatile memory and will not be lost by removing power from the scanner The scanner must be properly powered before programming During the programming mode the laser scanner will acknowledge a good and valid reading with a short beep It will give long beeps for an invalid or bad reading For detailed programming instructions and safety notices please refer to Programming Guide for Handheld CCD Laser Scanner Important Notice No warranty of any kind is made in regard to this material including but not limited to implied warranties of merchantability or fitness for any particular purpose We are not liable for any errors contained herein nor for incidental or consequential damages in connection with furnishing performance or use of this material We shall be under no liability in respect of any defect arising from fair wear and tear willful damage negligence abnormal working conditions failure to follow the instructions and warnings or misuse or alteration or repair of the
3. products without written approval Specification or version may be subject to change without notice The actual specification and version are based on the product delivered Laser Safety The laser scanner complies with safety standard IEC 60825 1 for a Class laser produce It also complies with CDRH as applicable to a Class Ila laser product Avoid long term staring into direct laser light All program setup must start with reading the I Start of Configuration label and read the End Start of Configuration of Configuration label to save any changes RS 232 Mode Interface Selection PC AT RS 232C USB Wand Emulation The reading of the RESET label turns ll ll all the parameters RESET back to default values The reading of the ABORT label AT discards all the parameters read prior ABORT to the End of configuration The reading of the N SHOW VERSION label will show the SHOW VERSION firmware version USB Interface Cable Notice Some handheld CCD Laser scanner contains build in USB controller USB on Board and this update would only work with new USB cable P N 171 10U301 200 Please find the U marking on the devices or refer to the latest Buyer s Guide for more information The factory default communications are 9600 baud 8 data bits mark parity 1 stop bit and CRILF terminator me
4. ssage Baud Rate wii wn TU TL TL TL won wl Even dd None Data Bit 7 8l Stop Bit 2 Message Terminator MAU None wut OA CR MI LF A H Tab tl STX ETX A EOT The default parameter values are framed End of Configuration
Download Pdf Manuals
Related Search