Phihong POE20D-1AF
Contents
1. ti e f OUT 7 i h a ee a GHEE f en lt 1 4 n i E _ lt L a N Gigabit Power Injector Block Diagram RJ45 PHIHONG Data Data amp IN Power Power amp e PoEPLUS Control Connect Description of LED Functions for Gigabit Power Injector Power up Sequence Upon power up all 3 LEDs will light for 2 seconds as part of the self test for the internal microprocessor software After the end of the 2 seconds the ON LED will illuminate green signifying that the DC output voltage is available for powering a compliant load to the 802 3af PoE standards Detection Sequence Once a compliant load is attached to the output RJ45 connector the green CONNECT LED will illuminate Should the load be non compliant then the LEDs will blink a code signifying the cause for non detection Detection Failure Codes 1 Incorrect resistive signature The green CONNECT and red FAULT LEDs will blink 3 times 2 Incorrect capacitive signature The green ON LED will blink 3 times 3 Incorrect Voffset The green CONNECT and green ON LEDs will blink 3 times 4 Unstable current measurement The green ON LED will blink 3 times 5 Low voltage sensed during detection overload The red FAULT LED will blink 3 times After the LEDs blink 3 times the Power Injector will continue to try to detect a valid load Therefore until the correct load is appl2. WWW PHIHONG COM 19 6W Power over Ethernet Adapter DC Input Single Port Injector PHIHONG iol InterOperability Laboratory Part of the University of New Hampshire Research Computing Center C Features e Detection and Classification per IEEE802 3af e UNH IOL Tested e Diagnostic LEDs e Full Protection OCP OVP e Non Vented Case e Gigabit Compatible e DC Input Voltage 18 72VDC e Lowest cost DC Input Power Injector e Year Warranty Applications e IP Telephones e Security Cameras e Wireless Network Access Points e IP Print Servers e Blue Tooth Access Point Safety Approvals e CE Mechanical Characteristics e Length 140mm 5 511in e Height 36mm 1 42in e Width 65mm 2 551in e Weight 0 2Kg 0 44lb Output Specifications Model DC Output Load Regulation Voltage POE20D 1AF 56V Phihong is not responsible for any error and reserves the right to make changes without notice Please visit our website at www phihong com for the most up to date specifications and contact information POE20D 1AF Characteristics WWW PHIHONG COM INPUT Isolation Test DC Input Voltage Range Primary to Secondary 2121VDC for 1 minute 10mA 18 to 72VDC Primary to Field Ground 2121 VDC for 1 minute 10mA Output to Field Ground 2121VDC for 1 minute 10mA DC Input Current 1 5A for 18V DC and maximum load Immunity ESD EN61000 4 2 Level 3 F RS EN61000 4 3 Level 3 A EFT EN61000 4 4 Level 2 Total O
3. ied the LEDs will continue to blink If there is an open circuit connected to the output RJ45 then the LEDs will not blink but the Power Injector will continue to try to detect a valid load Fault Sequence Should there be a fault such as an overload or short circuit then the red FAULT LED will illuminate The red FAULT LED will illuminate for 2 seconds and then go off as the power supply tries to redetect a valid load If there is a problem in detecting the LED will indicate what is wrong with the load as per the codes in the section above
4. utput Power Surge 19 6W at 56VDC urge EN61000 4 5 Level 3 CS EN61000 4 6 Level 3 Voltage Dips EN61000 4 11 DC Offset Harmonic EN61000 3 2 No data degradation with DC imbalance 18mA Efficiency 80 at maximum load gt 36 to 72VDC 75 at maximum load 18 to lt 36VDC Ripple and Regulation 100mV maximum at ambient 25 C Transient O P Voltage Protection 60V maximum at switch on and off Insulation Resistance Primary to Secondary gt 10M OHM S500VDC Primary to Field Ground gt 10M OHM 500VDC FEATURE Over Voltage Current Short Circuit Protection Outputs equipped with short circuit protection and overload protection as per 802 3af specification The output can be shorted permanently without damage Indicators ENVIRONMENTAL Green LED 1 Input power ON Temperature Red LED Fault detected Operation 20 to 50 C Green LED 2 Valid IEEE802 3af load detected and Non operation 25 to 85 C connected Humidity Input Connector Operation 5 to 90 Anytek O0Q0355510000G Mate Anytek TJ0350520000G or TJ035152000G EMC Anytek is part of Giga Way Technology Corp FCC Part 15 Class B EN55022 Class B Output Connection pins 3 6 pins 2 Dimension Diagram Unit mm inch Warranty Year 163 25 0 15 MODEL LABEL E 152 00 i 140 0 15 O i ie i P O j 3 O Od x O Ho FE 5 B7 o x q l _ 9 00x2 o 104 00 oe TEXT LASER ENGRAVING ve O 4 i Se int x l i E
Download Pdf Manuals
Related Search