Elica Juliette
Contents
1. Children should be monitored to ensure that they do not play with the appliance Never use the hood without effectively mounted grating The hood must NEVER be used as a support surface unless specifically indicated The premises must be sufficiently ventilated when the kitchen hood is used together with other gas combustion devices or other fuels The suctioned air must not be conveyed into a conduit used for the disposal of the fumes generated by appliances that combust gases or other fuels The flaming of foods beneath the hood itself is severely prohibited The use of exposed flames is detrimental to the filters and may cause a fire risk and must therefore be avoided in all circumstances Any frying must be done with care in order to make sure that the oil does not overheat and burst into flames As regards the technical and safety measures to be adopted for fume discharging it is important to closely follow the relations provided by the competent authorities The hood must be regularly cleaned on both the inside and outside AT LEAST ONCE A MONTH it is in any event necessary to proceed in accordance with the maintenance instructions provided in this Failure to follow the instructions as concerns hood and filter cleaning will lead to the risk of fires Do not use or leave the hood without the lamp correctly mounted because of the possible risk of electric shocks We decline any responsibility for any proble2. Instruction on mounting and use LLLLLLLLLLLLLLLLLLLLLLLLL LL H 50cm 7 L 2 X Y H 3cm IV gt Q x Vill EN Instruction on mounting and use The hood can look different to that illustrated in the drawings in this booklet The instructions for use maintenance and installation however remain the same Consult the designs in the front pages referenced in the text by alphabet letters Closely follow the instructions set out in this manual All responsibility for any eventual inconveniences damages or fires caused by not complying with the instructions in this manual is declined Note the elements marked with the symbol 47 are optional accessories supplied only with some models or elements to purchase not supplied A Caution WARNING Do not connect the appliance to the mains until the installation is fully complete Before any cleaning or maintenance operation disconnect the hood from the mains by removing the plug or disconnecting the home mains switch Always wear work gloves for all installation and maintenance operations The appliance is not intended for use by children or persons with impaired physical sensorial or mental faculties or if lacking in experience or know how unless they are under supervision or have been trained in the use of the appliance by a person responsible for their safety
3. erify suitability of the materials in accordance with the type of wall ceiling The wall ceiling must be strong enough to take the weight of the hood Do not tile grout or silicone this appliance to the wall Surface mounting only Support to the ceiling bracket Regulators of the tie rods of the hood Decorative cover Box for connecting to the domestic power network Interconnection cable Halogen bulb Active carbon filter Metal anti fat filter gt Operation Use the high suction speed in cases of concentrated kitchen vapours It is recommended that the cooker hood suction is switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating cooking A on off light switch B on off aspiration switch and minimum power selection B C medium power selection aspiration switch B D maximum power selection aspiration switch Maintenance Before performing any maintenance operation isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse Cleaning The cooker hood should be cleaned regularly at least with the same frequency with which you carry out maintenance of the fat filters internally and externally Clean using the cloth dampened with neutral liquid detergent Do not use abrasive products DO NOT USE ALCOHOL WARNING Failure to carry out the basic cleaning recommendations
4. ms damage or fires caused to the appliance as the result of the non observance of the instructions included in this manual This appliance is marked according to the European directive 2002 96 EC on Waste Electrical and Electronic Equipment WEEE By ensuring this product is disposed of correctly you will help prevent potential negative consequences for the environment and human health which could otherwise be caused by inappropriate waste handling of this product The symbol mw on the product or on the documents accompanying the product indicates that this appliance may not be treated as household waste Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment Disposal must be carried out in accordance with local environmental regulations for waste disposal For more detailed information about treatment recovery and recycling of this product please contact your local authority Use The hood is supplied in the FILTERING version and is used without an extracted fumes discharger conduit Fumes and steam are recycled through the X deflector If you intend using the product in the SUCTION version it is necessary to have an evacuation conduit going from the upper Y exit to the extraction hole towards the exterior In this case a connection ring has to be installed on the Y extraction hole and the carbon filter removed Fig 10 11 12 13 14 15 16 17 18 19 20 Installati
5. of the cooker hood and replacement of the filters may cause fire risks Therefore we recommend oserving these instructions The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations Grease filter Traps cooking grease particles This must be cleaned once a month using non aggressive detergents either by hand or in the dishwasher which must be set to a low temperature and a short cycle When washed in a dishwasher the grease filter may discolour slightly but this does not affect its filtering capacity Charcoal filter filter version only It absorbs unpleasant odours caused by cooking The charcoal filter can be washed once every two months using hot water and a suitable detergent or in a dishwasher at 65 C if the dishwasher is used select the full cycle function and leave dishes out Eliminate excess water without damaging the filter then put it in the oven for 10 minutes at 100 C to dry completely Replace the mattress every 3 years and when the cloth is damaged Montage Install the carbon filter on the back of the grease filter and fix with two rods Attention The rods are included in the carbon filter packing and not on the hood dismantle the filter act in the reverse manner Replacing lamps Disconnect the hood from the electricity Warning Prior to touching the ligh
6. on Specialised personnel must carry out both the electrical and the mechanical installation The minimum distance between the supporting surface for the cooking vessels on the hob and the lowest part of the range hood must be not less than 50cm from electric cookers and 65cm from gas or mixed cookers If the instructions for installation for the gas hob specify a greater distance this must be adhered to Electrical connection The mains tension must correspond to the tension shown on the characteristic label situated inside the hood The product is meant for connecting directly to the mains supply therefore apply a regulation bipolar switch that ensures complete disconnection from the mains in the conditions of category Ill over tension conforming to the installation rules Warning Detail B fixing bracket to the ceiling Fig 1 is equipped with a conductor yellow green that must be connected to the earth of the domestic electrical plant Fig 4 ATTENTION Be particularly careful about positioning the excess cable Failure to observe this indication could cause grave damage to the apparatus and or an electric shock to the user or the installer For further details see Fig 8 Warining Changing the interconnection cable must be carried out by the authorised technical assistance service Mounting Expansion wall plugs are provided to secure the hood to most types of walls ceilings However a qualified technician must v
7. t bulbs ensure they are cooled down 1 Using a flat head screwdriver or equivalent tool carefully pry loose the light cover 2 Remove the damaged light and replace with a new 12 Volt 20 Watt Maximum halogen light made for a G 4 base SUITABLE FOR USE IN OPEN LUMINAIRES Follow package directions and do not touch new light with bare hands 3 Reinstall the light cover it will snap shut Some models envisage lateral lamps Replace them with identical forms of 40W E14 max Remove cover A to access the lamp housing A If the lights do not work make sure that the lamps are fitted properly into their housings before you call for technical assistance
Download Pdf Manuals
Related Search