CDA FWC152
Contents
1. Keep the spare hinge plate s to be able to reverse the door back again 1 Rear ventilation trim screw access and screw 2 Rear ventilation trim 3 Front ventilation trim screw 4 Front ventilation trim 5 Lower hinge 6 Lower hinge fixing screw 7 Short hinge pin 8 Main hinge pin 9 Hinge bracket 10 Upper hinge 11 Upper hinge fixing screw 12 Replacement top hinge Electrical Information Warning This appliance must be earthed Green amp Yellow to Earth Live O 13 Amp bid Fuse Gm Cord Clamp The mains lead of this appliance has been fitted with a BS 1363A 13 amp fused plug plug follow the steps below 1 Remove the fuse cover and fuse 2 Fit replacement 13A fuse ASTA approved to BS 1362 type into the fuse cover 3 Replace fuse cover Important Do not use the appliance without the fuse cover in position How to connect an alternative plug If the fitted plug is not suitable for your socket outlet then it should be cut off and disp shock hazard A suitable alternative plug of at least 13 Amp rating to BS 1363 should b As the colours ofthe wires in the mains lead of this appliance may not correspond with coloured markings identifying the terminals in your plug proceed as follows The wire which is coloured GREEN and YELLOW must be connected to the terminal by the Earth symbo or coloured GREEN and YELLOW The wire which is coloured BLUE must be connected2. automatically once the appliance has r Use Only store wine in sealed containers Do not overload the cabinet Only open the door when necessary Do not cover the shelves with aluminium foil or anything else that will prevent air fr To prevent damage to the door seal ensure the door is fully open before removin This is a self defrosting appliance The compressor will not run during the thirty mi Do not pull the shelves beyond the anti stop position approximately one third out This appliance is intended to be used exclusively for the storage of wine Inthe event of a power failure leave the door closed as much as possible to maint Should the power failure continue for a prolonged period you should take steps to pri against a rise in temperature The wine cooler will remember the selected temperatur once the power is restored This appliance is suitable for use in an extended temperature climate N and has a temperature of 16 32 C Use of the appliance below 10 C may cause performance is Normal operation will resume once the appliance is within the specified range Fwc152 fwc303 amp fwc623 will not be able to reach the required temperature if the a that required Use and Controls fwc152 Key 1 Power button C 2 Light button 7 3 button CDA fig 1 Key 1 Power button 2 Light button 3 button 4 button To switch the power on
3. cleaned using mild soapy water and dried thoroughly The interior cabinet should be cleaned using a solution of bicarbonate of soda and lukewarm water Clean the shelves separately by hand using soap and water Do not put them in the dishwasher Ensure that the cloth is only moist when cleaning the control panel and electrical parts and that all water is thoroughly dried ofbefore reconnecting the power Once cleaning is complete reconnect the mains electrical supply Ifthe appliance is not to be used for prolonged periods of time unplug and clean the appliance thoroughly The door should be left slightly ajar to prevent the formation of odours or condensation Removing the shelves fwc303 603 623 To remove the shelves from the wine cooler first remove all bottles from the shelf then pull the shelf forwards until the groove on either side of the shelf is level with the plastic peg on either side of the cabinet as shown in fig 7 Then lift the shelf up and pull forwards To replace the shelves follow the steps above in reverse order Temperature alarm If the temperature rises or falls outside the set temperature range an alarm will sound and the display will flash The wine cooler has not yet reached the set temperature when first switched on There has been a power failure The wine cooler has been overloaded The door is not closed properly Troubleshooting If you have any problems with your app
4. to the terminal which is marke coloured BLACK The wire which is coloured BROWN must be connected to the terminal which is coloured RED If in doubt regarding the electrical connection of this appliance consult a qualified elect cable the appliance may require removing for servicing N B Ensure that the plug socket is situated in an easily accessible place A A Brand CDA fwc152ss fwc303ss Model Rento fwc152bl fwc303bl Category of the Household Refrigerating Appliance Voltage Frequency H 230 240V 50 14 8x57x82 29 5x61 5x82 The energy consumption is based on standard energy consumption will depend on how the app Storage Volume I 20 i e Dimensions WxDxH cm Weight kg Energy Efficiency Class Annual Energy Consumption AEc kWh year o O o s D a C Defosting Type Climate class N climate class Climate Class This appliance is intended to be used at an amb lowest temperature C and 32 highest temp Airborne Acoustical Noise 44 43 o Emissions in dB A re1 pW Installation Type Built under This appliance is intended to be used exclusively for the storage of wine 14 CDA To contact our Customer Care Department or for Service please contact us on the details below
5. Directive 2004 108 EEC IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACC 2002 96 EC Please render the appliance unusable before disposal This includes removing the prevent children being trapped inside the appliance during play or any other risk of At the end of its working life the product must not be disposed of as urban waste It authority differentiated waste collection centre or to a dealer providing this service Disposing of a household appliance separately avoids possible negative conseque deriving from inappropriate disposal and enables the constituent materials to be rec in energy and resources As a reminder of the need to dispose of household applia marked with a crossed out wheeled dustbin X Before first use You must allow the appliance to settle for at least twenty four hours prior to switc It is recommended that you remove all internal and external packaging and clean the i use using a solution of bicarbonate of soda and warm water and then thoroughly dry The appliance may have an odour to it at first use This will disappear as the appliance Please note The appliance will work continuously until it gets to the correct temperature Ifthe appliance is switched off you should allow five minutes before switching it on unnecessary damage to the compressor The LED display may not show the selected temperature whilst the appliance first is normal and the display will be corrected
6. e shelves are not positioned correctly The display show E1 or E2 The temperature sensor has failed Installing the Wine Cooler This appliance is intended to be installed in a space between two units The minimum space required is fwc152 150 mm wide x 555 mm deep x 825 mm high fwc303 300 mm wide x 580 mm deep x 825 mm high fwc603 600 mm wide x 580 mm deep x 825 mm high fwc623 600 mm wide x 580 mm deep x 825 mm high Please note When the product is installed there should be a small ventilation gap between the top of the unit and the underside of the worktop 6 mm or 1 4 These products should not be installed 1 Indirect sunlight 5 Adjacent to a heat source oven or radiator 2 3 Below a hob unit 4 Where a continuous plinth is to be used it is necessary cut a section out so that the ventilation slots at the front of the appliance are not obstructed in any way fig 6 IMPORTANT Failure to follow the instructions regarding installation and ventilation may invalidate the warranty supplied with your appliance To Install the Handle IMPORTANT Do not overtighten the screws and do not use power tools to install 1 Carefully locate the handle over the fixing pins 2 Using the supplied allen key tighten the securing grub screw to fix the handle IMPORTANT Take care when installing the handle not to damage the door Any d by the warranty supplied with
7. fwc152 fwc303 fwc603 C D A fwc623 Wine Coolers Manual for Installation Use and Maintenance Important The CDA Group Ltd cannot be held responsible for injuries or losses caused by inco product Please note that CDA reserve the right to invalidate the guarantee supplied installation or misuse of the appliance or use in a commercial environment This appliance is not designed to be used by people including children with reduc capacity or who lack experience or knowledge about it unless they have had super the appliance by someone who is responsible for their safety Under no circumstances should any external covers be removed for servicing or ma qualified personnel Do not use the appliance if the plug the mains cord or the appliance itself is damag you must have it replaced by the manufacturer or an authorised service centre or si avoid a hazard Children should be supervised to ensure that they do not play with the appliance Ki of children Do not let the mains cord hang over the edge of the table or worktop on Appliance information Please enter the details on the appliance rating plate below for reference to assist fault with your appliance and to register your appliance for guarantee purposes Appliance Model Serial Number CE Declarations of Conformity This appliance has been designed constructed and marketed in compliance with sa 2006 95 EEC Low voltage and requirements of EMC
8. liance you should check the troublesho Customer Care to prevent unnecessary service calls and potential cost If the appliance is not working check There is power to the appliance The house fuses or circuit breakers are intact and the fuse in the plug has not bl The plug socket is functioning correctly To check this plug another electrical ap working The ambient temperature is between 16 to 38 C The appliance is working but not very well check The appliance is not overloaded The thermostat is set to an appropriate temperature The door is closing properly The door gasket is sealing properly There is enough ventilation at the side and rear walls The ambient temperature is between 16 to 38 C The appliance is noisy check The appliance is level and stable The cooling gas will make some noise even when the compressor is not runnin During operation it is normal for the fan to run even when the compressor is no The light does not work check There is power to the appliance The house fuses or circuit breakers are intact and the fuse in the plug has not bl The light button is not set to off Please note The LED lighting cannot be replaced without a service call If the light fails contact The door will not close properly check The appliance is level and stable Ifthe door has been removed it may not have been correctly refitted The door seal is dirty Th
9. modes The appliance has two different running modes Silent mode Once the required temperature is reached the appliance will run without the fan The mode To change to dynamic cooling mode touch and hold the button for approximately fiv fwc603 amp fwc623 The wine cooler will beep five times to confirm dynamic cooling is a Dynamic cooling mode The fan cycles on and off to circulate the air even after the required temperature is read humidity and temperature distribution in the wine cooler creating perfect conditions for Using the dynamic mode increases the level of noise in operation To change to silent mode touch and hold the button for approximately five seconds fwc623 The wine cooler will beep three times to confirm silent mode is on Sabbath mode Sabbath mode is available for the observance of certain religious holidays This will and audible alarms The cooling process will continue To switch the Sabbath mode on touch and hold the power and light keys simultanea light will flash four times and confirm the Sabbath mode is on Sabbath mode will s hours but to switch the Sabbath mode off at any time touch and hold the power and seconds Care and Cleaning Always disconnect the appliance from the mains electrical supply before any cleaning or maintenance Do not use abrasive products or detergents After washing rinse and dry thoroughly The exterior of the appliance and the door seal should be
10. off Press and hold the power button for five seconds To change the temperature Press the or buttons until the required temperature is shown on the display The preset temperature is 12 C 54 F To change the temperature display from Fahrenheit to Celsius or Celsius to Fahre for five seconds To view the set temperature touch the or button at any time and the set temp for five seconds The display shows the current internal temperature when the wine cooler is on Optimal temperature selection Whilst wine is best stored at temperatures between 13 and 15 C your wine can also b red wine this is between 15 and 17 C and for white wine between 12 and 13 C To use the internal light Press the light button to switch the light on or off Use and Controls fwc603 amp fwc623 Key 1 Power button 2 Left Upper zone button 3 Left Upper zone button al 8 2o button a 5 Right Lower zone button 6 Light button To switch the power on off Press and hold the power button for five seconds To change the temperature Press the or buttons for the appropriate zone until the required temperature i The preset temperature is 10 C 50 F for left upper zone and 16 C 60 F for right low To change the temperature display from Fahrenheit to Celsius or Celsius to Fahre for five seconds To view the set temperat
11. ure touch the appropriate or button at any time and LED display for five seconds The display shows the current internal temperatures when the wine cooler is on Optimal temperature selection Whilst wine is best stored at temperatures between 13 and 15 C your wine can also be red wine this is between 15 and 17 C and for white wine between 12 and 13 C To use the internal light Press the light button to switch the light on or off Please note The temperature in the lower zone must be set either the same or higher than the tem optimal performance the temperatures in the two zones should differ by at least 4 C Use All Models Humidity Control all models except fwc152 The wine coolers are equipped with a humidity control system to maintain optimal humidity within the wine cooler Fill the humidity reservoir approximately 3 4 full with water Place the reservoir over the special lugs toward the back of the top shelf only as shown in fig 5 Ensure it is located correctly to prevent water spillage Check the water level regularly and refill if required Temperature display The temperature display will show the current internal temperature The display flashes When a different temperature is being set If the internal temperature is 5 away from the set temperature This serves as a contents of the appliance should the temperature be too high Dynamic Cooling and Silent
12. your appliance 10 Installation This appliance is designed to fit under worktops between 820 890mm in height usi ensure that the feet are concealed from view Loosen but do not remove the rear ventilation trim screws Slide the rear plinth to the screws to lock the plinth in position Reversing the Door Itis possible to reverse the door on this appliance if required To do so follow the steps below 1 Remove the rear ventilation trim 2 by removing screws 1 and then remove the front ventilation trim 4 by removing screws 3 as shown in figure 7 2 Remove the lower hinge 5 by removing the four screws 6 as shown in figure 8 Support the door as you do this to prevent damage 3 Gently lower the door away from the top hinge and place on a padded surface to avoid the risk of damage as shown in figure 9 4 Remove the upper hinge 10 as shown in figure 10 5 Unscrew and transfer pins 7 8 from the lower hinge plate o the opposite side as shown in figure 8 6 Pop out the cover caps on the opposite side and use hem to cover the screw holes on the original side Fit the alternative upper hinge on the opposite side 8 Rotate the door 180 and relocate it on the top hinge Refit the modified lower hinge into the door and secure it o the appliance body using the screws removed in step 1 10 Refit both ventilation trims Please note
Download Pdf Manuals
Related Search