CDA KVF21L
Contents
1. kvf21 amp kv 22 CDA Stainless Steel Flush Mount Sinks Installation Before Installation Thoroughly check the sink and any fittings for signs of transport or other damage Please note After fitting sinks cannot be returned for credit or replacement Offer up the sink to the worktop and or the cabinets to confirm that the external dimensions of the bowls are compatible with the cabinets themselves Confirm that with the sink in position e There is adequate space to install any taps or other required accessories There is adequate space to install the waste pipework and that any necessary modification to internal shelves to accommodate the waste and trap is acceptable e Access to any water stop cock or other services will still be adequate after the installation Installation e Refer to the cut out sizes on the back of this manual and use them to mark out where the worktop needs to be cut Double check the dimensions before cutting the worktop aperture After cutting out the worktop aperture we recommend you seal the cut edges with silicone or similar sealant to help prevent ingress of water tis often easier to mount the taps waste fitting and overflow onto the sink prior to fitting the sink to the worktop The edges of the sink should be bedded onto a bead of silicone or similar sealant to create a barrier to the ingress of water and other items between sink and workt2. ce on the details below Customer Care Department The ICDIA Group Ltd e Harby Road Langar Nottinghamshire e NG13 9HY T 01949 862 012 F 01949 862 003 E customer care cda eu Copyright CDA 2015 www cda eu
3. op e After positioning the sink on the worktop position the fixing brackets as shown in Fig 1 then tighten their Screws Do not use a power tool to tighten the screws by using a hand tool it is easier to ensure that they are tightened just enough to clamp down on the worktop and no more After fixing ensure the sealant forms a continuous bead to prevent water ingress e Remove any excess sealant using an appropriate method as recommended by the sealant manufacturer The taps waste fitting and overflow can now be mounted onto the sink if not already done and fully connected to their respective services To check the waste for leaks close the plug basket of the waste fitting open the tap and fill the sink to the level of the overflow turn off the tap and wait several minutes to verify that the water doesn t drain away e Empty the sink After fitting ensure that the enclosed Stainless Steel Sinks Use and Maintenance guide is retained for the customer and or user of the sink E amp OE All instructions dimensions and illustrations are provided for guidance only CDA reserve the right to change specifications without prior notice Cut Out Dimensions 4 R10 1 507 1 LLL LLL Kp 5 20 1 987 1 30 ULUL LL RLL LLULL UL LULL LLOUR LLL LLULL ALLAL 1000 1 Please contact our Customer Care Department for Servi
Download Pdf Manuals
Related Search